新型槽栅nMOSFET热载流子效应的模拟研究

应用二维器件仿真程序 PISCES- ,对槽栅结构和平面结构器件的特性进行了模拟比较 ,讨论了槽栅结构 MOSFET的沟道电场特征及其对热载流子效应的影响。槽栅结构对抑制短沟道效应和抗热载流子效应是十分有利的 ,而此种结构对热载流子的敏感 ,使器件的亚阈值特性、输出特性变化较大     

深亚微米PD和FD SOI MOS器件热载流子损伤的研究

研究了深亚微米PD和FD SOI MOS器件遭受热截流子效应(HCE)后引起的器件参数退化的主要差异及其特点，提出了相应的物理机制，以解释这种特性。测量了在不同应力条件下最大线性区跨导退化和闽值电压漂移，研究了应力Vg对HCE退化的影响，并分别预测了这两种器件的寿命，提出了10年寿命的0．3μm沟长的PD和FD SOI MOS器件所能承受的最大漏偏压。     

基于加速性能退化试验的板级可靠性评估

传统的可靠性评估方法一般基于失效寿命数据,而目前对于高可靠长寿命的电子产品,很难通过加速试验获得其失效寿命时间。为解决这一矛盾,将性能退化理论引入到传统可靠性评估中,提出了基于失效数据及加速性能退化的可靠性评估的新方法。应用某型雷达24V/2A稳压电源板加速性能退化试验进行验证,结果表明该方法用于高可靠长寿命电子装备的可靠性评估是正确有效的。     

GaN基发光二极管的可靠性研究进展

高效高亮度GaN基发光二极管(LED)在图像显示、信号指示、照明以及基础研究等方面有着极为广阔的应用前景,器件的可靠性是实现其广泛应用的保证.本文从封装材料退化、金属的电迁移、p型欧姆接触退化、深能级与非辐射复合中心增加等方面介绍了GaN基LED的退化机理以及提高器件可靠性的措施,并对GaN基LED的应用前景进行了展望.     

Some observations from interrupted lifetest of GaInAsP/InP inverted-rib laser diodes

Conventionally, lifetests of semiconductor laser diodes usually involved operating the devices continuously at either constant power output or drive current, with periodic recording of their characteristics. In this paper, some effects arising from interrupted lifetest of 1.3 m GaInAsP-InP inverted-rib laser diodes are reported. This unconventional lifetest method involves constant power biasing at 4 mW/facet and 8 mW/facet respectively at 50°C, followed by a period during which the lifetest is interrupted and the devices left unbiased at room temperature. Subsequently, the devices were put back on constant power biasing at 50°C. Among a number of parameters, pronounced reduction in the threshold current, current for 4 mW/facet and 8 mW/facet were observed, indicating strong recovery effects commencing from the time when the life-test was interrupted. Redistribution of mobile defects in the cladding layer is postulated to be the cause of the degradation recovery, and the data supports the occurrence of an aging-current dependent defect annihilation mechanism. Such recovery effects have so far been observed to occur only in the GaInAsP-InP inverted-rib devices.     

The drag reduction and degradation characteristics of poly α olefin in diesel via rotating disk apparatus

Poly α olefin/diesel system was studied by experiments with a rotating disk apparatus, to investigated drag reduction and degradation behavior. Four different concentrations were tested with time, rotating speed, temperature, mechanical and ultrasound treatment. The results show that there is a optimum time and maximum DR% for drag reduction, and DR% increases slowly with temperature in diesel. The higher concentration possesses shorter optimum time but higher rotating speed to take effect. Also higher DRA concentration shows better degradation resistance at intensive shear and ultrasound circumstance. This phenomenon could be attributed to poly α olefin prefer to form more clusters than single molecule forms at high concentration, comparing with lower one.     

改性纳米TiO2光催化降解苯酚活性的研究

在装有紫外光的光催化反应器中，用锐钛型纳米TiO2为光催化剂，进行了苯酚水溶液的光催化降解性能的研究。考察了溶液的pH值、纳米TiO2用量、镍（Ni^2＋）掺杂量、苯酚的初始质量浓度等因素对苯酚水溶液光催化降解过程的影响。结果表明，在pH值为7时，苯酚水溶液的降解率达95％以上，强酸和强碱条件均不利于苯酚的降解。当TiO2用量为50mg，UV辐照40min时，200mL质量浓度为50mg／L的苯酚水溶液的降解率为96．3％；当TiO2用量为150mg，UV辐照60min时，200mL质量浓度100mg／L的苯酚水溶液的降解率为95．8％。镍掺杂增加了TiO2的光催化活性，用质量分数为10％的二氯化镍水溶液掺杂制备的复合光催化剂，苯酚水溶液的降解率比未掺杂时增加13．6％。     

阳离子化多元醇防塌剂的研制

室内研究和现场应用表明,聚乙烯醇类防塌剂表现出较明显的增粘负效应,可引起钻井液粘度的急剧增加,严重影响其推广应用.通过金属盐催化降解和阳离子化反应,研制出了抑制性好且增粘负效应低的阳离子化改性多元醇防塌剂.考察了阳离子化试剂、反应温度、反应时间对取代度、反应效率和产品主要性能的影响,得出了阳离子化多元醇防塌剂最佳制备条件,即：PVA与阳离子化试剂物质的量比为1：1,反应温度为50℃,反应时间为4 h,阳离子度可达0.435.     

炼油厂碱性污水生物催化氧化预处理工艺研究

在对炼油厂碱性污水水质分析的基础上,提出采用生物催化氧化工艺对碱性污水进行预处理。试验结果表明,在水力停留时间为4 h,曝气量(标准状态)为8 m3／h的条件下,碱性污水的硫化物去除率可达90％以上,出水中的硫化物平均值为15．2 mg/L,CODCR、酚和油的去除率分别为47．5％,44．1％,50．8％,其中CODCR体积负荷为3．85 kg／(m3·d),是传统生化处理的10倍, 达到了污水预处理的目的。