Diamond growth by carbon ion implantation of diamond

Medium energy (5–25 keV) ¹³C⁺ ion implantation into diamond (100) to a fluence ranging from 10¹⁶ cm⁻² to 10¹⁸ cm⁻² was performed for the study of diamond growth via the approach of ion beam implantation. The samples were characterized with Rutherford backscattering/channelling spectroscopy, Raman spectroscopy, X-ray photoemission spectroscopy and Auger electron spectroscopy. Extended defects are formed in the cascade collision volume during bombardment at high temperatures. Carbon incorporation indeed induces a volume growth but the diamond (100) samples receiving a fluence of 4 × 10¹⁷ to 2 × 10¹⁸ at. cm⁻² (with a dose rate of 5 × 10¹⁵ at. cm⁻² s⁻¹ at 5 to 25 keV and 800 °C) showed no He-ion channelling. Common to these samples is that the top surface layer of a few nanometers has a substantial amount of graphite which can be removed by chemical etching. The rest of the grown layer is polycrystalline diamond with a very high density of extended defects.     

水热合成法制备纳米TiO2晶须的表征及工艺研究

本文以TiCl4为原料，采用水热合成法制备金红石型纳米TiO2晶须，通过TEM和XRD对所制备的纳米TiO2晶须进行表征，确定了主要工艺参数。     

Characterization and performance of Pd-La/spinel catalyst for preparation of 2,6-diisopropylaniline

The Pd-La/spinel catalyst for the preparation of 2,6-diisopropylaniline (2,6-DIPA) by gas-phase amination of 2,6-diisopropylphenol (2,6-DIPP) has been studied. The catalysts before and after reaction were characterized by BET, XRD, differential thermal analysis (DTA)-thermo gravimetric analysis (TGA), FTIR, and NH₃-TPD techniques. The DTA study results show two kinds of coke deposited on the metal and support of Pd-La/spinel catalyst, and they are combusted at about 242 and 324 °C, respectively. The XRD and FTIR spectra of the Pd-La/spinel catalyst show that the coke contains the aromatic and aliphatic rings, alkyl groups, polynuclear aromatic system, hydroxyl groups, and amine groups. The reason for catalyst deactivation can be expressed as follows: coke formed on palladium metals may move from metal to the interface or boundaries of metal-support and acid sites of the support where further dehydrogenation and polymerization are occurring. The H₂ plays a key role in retarding coke formation, but must be in suitable amount to get relatively high selectivity. The rare earth promoter La not only promotes the activity and selectivity by retaining Pd species in the metallic state, but also decreases the formation of carbon by neutralizing the strong acid sites on the catalyst.     

硫醇自组装膜的电化学研究进展

综述了在金电极上硫醇自组装膜的电化学表征方法，性质和应用，介绍了自组装膜上的电子传递机理，并进行了简要的展望。     

Ohmic contacts to semiconducting diamond using a Ti/Pt/Au trilayer metallization scheme

Ohmic contacts have been fabricated on a naturally occurring type IIb diamond crystal using an annealed Ti/Pt/Au trilayer metallization where the Pt served successfully as a barrier to Ti diffusion into the Au capping layer. However, a specific contact resistance could not be reliably determined using transmission line model measurements. Auger microanalysis revealed the presence of Ti on the diamond surface near the ohmic contact pads. The most likely origin of the Ti on the diamond surface was determined to be lateral diffusion from beneath the contact pads. This would have produced a nonuniform concentration of Ti across the diamond surface which, in turn, would have affected the diamond sheet resistance in a complicated way.     

Effects of preparation conditions on the surface modification and performance of polyethersulfone ultrafiltration membranes

The impact that some membrane preparation steps had on ultrafiltration (UF) membrane characteristics and performance was studied. Polyethersulfone (PES) was employed as base polymer, while N‐methyl pyrrolidone (NMP) was used as a solvent, and polyvinylpyrrolidone (PVP) was used as a nonsolvent pore‐forming additive. The manufacturing variables studied were solvent evaporation time and membrane surface modification, using a fluorine‐based copolymer referred to as surface‐modifying macromolecule (SMM). The flat sheet membranes, prepared via phase inversion, were characterized using solute transport data, X‐ray photoelectron spectroscopy (XPS), and contact angle measurements. Membrane performance was evaluated via filtration test protocol that included a 6‐day filtration of concentrated river water. The flux reduction with time was modeled using single and dual mechanisms of fouling. The pore blockage/cake filtration model described better the behavior of the permeation rate along the experiments. Increasing the solvent evaporation time decreased the size of the pores and the permeation rate. However, it did not significantly affect the removal of the organic compounds naturally present in the river water used as feed. XPS and contact angle measurements proved that the short evaporation periods did not allow enough SMM migration to the surface to provoke a significant effect on the membrane performance. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci, 2006     

中低品位膨润土的有机化及在泥浆中的应用

以新疆乌兰陵格产中低品位钠基膨润土为原料,用十六烷基三甲基铵盐(氯化物D1631和溴化物CTAB)作插层剂,制备有机膨润土。通过实验确定了制备有机膨润土的季铵盐加入量是85～90mmol/100g土。用红外(FTIR)、X-衍射(XRD)和扫描电镜(SEM)表征了有机土结构。FTIR谱显示有机插层剂已进入膨润土的层间,XRD特征峰位移表明膨润土的层间距由1.23nm增加到3.26nm。SEM观察到有机土形貌显著改变,颗粒松散。结果表明膨润土的层间距增大,粒层厚度约为72nm左右。测试了有机膨润土的钻井油基泥浆性能,结果表明,其塑性粘度为7.0mPa·s,表观粘度为8.5mPa·s,动切力为1.5Pa,滤失量40.0mL,均已达到钻井液用有机土的质量指标要求。     

药物中间体3,5-二甲氧基-邻苯二甲酸酐的合成及表征

以3,5-二甲氧基苯甲酸甲酯为原料经过羟烷基化反应、酯交换反应、水解反应、脱羧反应、氧化反应、脱水反应来合成3,5-二甲氧基-邻苯二甲酸酐这一中间体,每步反应的收率均在90%以上。通过差热分析、红外、质谱、核磁等分析手段对合成的化合物的结构表征,结果表明,所合成的化合物的结构、性能指标与目标要求一致。     

纳米碳酸钙的制备及表征

研究了以氧化钙和二氧化碳为原料,化学法制备纳米碳酸钙的工艺条件、添加剂的影响及形态。结果表明:中间体氢氧化钙的初始浓度、二氧化碳的流量、反应温度、搅拌速度及添加剂等在控制制备纳米碳酸钙颗粒的形状和尺寸中均十分重要。透射电镜观察结果表明:通过控制反应及添加剂,可以得到尺寸规整的链锁形、纺锤形和球形纳米碳酸钙。表面能谱证实产品为高纯的碳酸钙。X射线衍射和电子衍射的结果进一步表明:所制纳米碳酸钙均属方解石型六方晶系,a0=0.498 9 nm,c0=1.706 2 nm;为多晶结构。     

竹纤维素的结构表征

对纺织用竹纤维、黏胶用竹浆粕、造纸用竹浆粕、高级竹浆粕进行物化性能分析,并对其结构进行表征。显微镜观察显示,竹纤维纵向表面有竹节,相比纺织用竹纤维光滑的表面,竹浆粕呈现明显的微纤结构;由X-衍射(WAXD)分析结果可知,纺织用竹纤维结晶属于典型的纤维素Ⅰ,内部具有完善的微纤结构,结晶度和晶粒尺寸均明显高于三种竹浆粕,主要原因是分子间具有更强的氢键作用。