高可靠镀Ni／Au工艺及其在微波PTFE电路上的应用

介绍了高可靠电镀Ｎｉ／Ａｕ工艺在ＰＴＦＥ微波印制电路上的应用，并分析了氨基磺酸盐镀软镍和亚硫酸盐镀软金工艺的影响因素及提高Ｎｉ／Ａｕ镀层之间附着力的措施。通过实验及应用证明了与直接镀金工艺相比，在软基材ＰＴＦＥ敷铜箔板上镀Ｎｉ／Ａｕ工艺能大大提高微波电路的可焊性，高温稳定性和长期可靠性，并且用其所制作的微波器件的高频性能也优于直接镀金工业。     

预测井眼稳定性的力学化学耦合方法

在井眼力学稳定性评价的基础上，将硬脆性页岩水化后岩石强度等参数的变化规律用于页岩水化前后坍塌压力变化的对比分析，结果表明，地层坍塌压力当量密度随页岩水化程度的增加逐渐升高。给出了预测井眼稳定性的力学化学耦合方法，并将该方法应用于现场生产中，取得了较好的预测效果     

Separation of di- and tripeptides with solvent extraction and an emulsion liquid membrane

The extraction equilibria of various di- and tripeptides with di-2-ethylhexylphosphoric acid (D2EHPA) were studied at low pH values. The complex extracted to organic phase consisted of one molecule of peptide and two molecules of D2EHPA dimer. The extraction constants of the peptides correlated well with the distribution coefficients of peptides between 1-octanol and water, which is a measure of hydrophobicity. The permeation rates of peptides through an emulsion liquid membrane were examined by using D2EHPA as a carrier, Span 80 as an emulsifier and kerosene as a diluent. The rates varied considerably with peptide type, depending upon the hydrophobicity.     

Experimental densities for compressed R134a

This paper reports densities of compressed R134a (1,1,1,2-tetrafluoroethane) determined by using a contiuously weighed pycnometer at 20 K intervals between 180 and 380 K at pressures from slightly greater than the vapour pressure to 70 MPa. The results are accurate to within ±0.1%. Saturated liquid densities derived by extrapolation from the experimental values agree with other reported values to within ±0.3%.     

利用锁模光纤激光器做时钟提取器的OTDM通信系统

简短评述了大容量和超大容量光通信系统的ＷＤＭ和ＯＴＤＭ技术，提出了一个在ＯＴＤＭ通信系统中用锁模光纤激光器做时钟提取器的新方法，给出了一个利用设置波分预标时钟脉冲方案构成的新的全光型ＯＴＤＭ通信实验系统结构。     

填料萃取塔液泛速度的计算

介绍了三种有代表性的填料萃取塔的液泛速度计算公式，并通过它们用于三种典型的液-液实验体系和两种不同填料的计算结果的比较，对这些公式的适用范围进行了讨论。     

聚合铝生产工艺研究

以铝矿为原料，在常压下，采用两段溶出法，对聚合铝的合成工艺进行了系统研究。     

Extraction of Anthocyanin Pigments from Purple Sunflower Hulls

The anthocyanin pigments in hulls of purple sunflower seeds were extracted using three solvent systems, 50:1:49 ethanol-acetic acid-water (EAW), 0.01M acetic acid (AAc), or water containing SO₂. Solvent, extraction time, size of ground hulls, pH of extracting solvent, hulls/solvent ratio, and concentration of SO₂ in water, were investigated. All were significant factors affecting yield of extracted anthocyanins. EAW and SO₂ were more effective extractants than AAc. Optimum conditions from response surface optimization for the extraction with sulphurous water were: SO₂ at 200 mg/L, hull size 20 mesh, extraction time 5 min at 22°C, and solvent/hulls ratio = 20.     

基于Patel-Teja状态方程的统一粘度模型(Ⅱ)应用于油气藏流体粘度的预测

基于(I)报根据pVT和Tμp图形的相似性和Patel-Teja状态方程建立的预测纯流体气、液相粘度的统一模型,通过引入常规的状态方程参数的混合规则,将其应用于二元轻烃混合物共计1894个数据点及模拟天然气高压粘度的预测,平均相对误差分别为13.78%和16.75%;应用于油藏原油和天然气高压粘度的预测,结果优于现有的有关油气藏流体粘度模型.