RESEARCH ON DESIGN METHOD OF A MULTIPLE DISC WET BRAKE IN LUBRICATED ENVIRONMENT

The rmomechnical phenomena occurring between friction pairs greatly change the distributions oflining pressure and friction surface temperature of a multiple disc wet brake. It has become one of the maincauses of brake failure. In order to understand these thermomechanical phenomena, several design and mate-rial factors tha have great influence on thermomechanical phenomena, such as heat transfer coefficient, fric-tion factor, sliding velocity initial lining pressure and so on, are analyzed. An isothermal design method isproposed for designing a multiple disc wet brake.     

克拉2气田储层岩石的应力敏感性及其对生产动态的影响

克拉2气田是一个异常高压气藏，压力系数在2．0以上。在衰竭式开采条件下，其地层压力降幅可为普通气藏地层压力降幅的3倍以上，因此研究储层岩石应力敏感性及其对生产动态的影响意义重大。研究得出，岩石的应力敏感性特征主要有：岩石物性对应力的敏感性总体上不大，其中以孔隙度最小，渗透率次之，压缩系数最大；岩石物性随地层压力的下降而下降；在同一地层压降下．岩石物性下降幅度不是渗透率的连续函数，而是与渗透率分布范围有关，高渗透率范围，岩石物性下降幅度小，低渗透率范围，岩石物性下降幅度大。研究得出，克拉2气田岩石的应力敏感性对其生产动态的影响较小。     

Thermal Radiative Properties of Xonotlite Insulation Material

Introduction Xonotlite-type calcium silicate (6CaO?6SiO2?H2O) is synthesized porous insulation material by hydrothermal processing with quartz powder and limestone as the raw material (with CaO/ SiO2≈1:1). Compared with fire- retardant fibre, xonotlite has more excellent insulating performance, such as low thermal conductivity, environment friendly, high intension, and wide applying temperature range, which has been emphasized in recent years by many scholars and widely used in many indu…     

Inference for pth‐order random coefficient integer‐valued autoregressive processes

Abstract. A pth‐order random coefficient integer‐valued autoregressive [RCINAR(p)] model is proposed for count data. Stationarity and ergodicity properties are established. Maximum likelihood, conditional least squares, modified quasi‐likelihood and generalized method of moments are used to estimate the model parameters. Asymptotic properties of the estimators are derived. Simulation results on the comparison of the estimators are reported. The models are applied to two real data sets.     

2，6-萘二甲酸二甲酯在有机溶剂中溶解度的测定与关联

Solubility of dimethyl-2,6-naphthalene dicarboxylate in acetic acid, N,N-dimethylfonnamide, N,N-dimethyl acetamide, dimethyl sulphoxide, and N-methyl-2-ketopyrrolidine were determined using a dynamic method. The measured systems were correlated by UNIFAC group contribution method. A new main group （aromatic ester, ACCOO） was defined to express the activity coefficients of the aromatic ester. New interaction parameters of the ACCOO group were expressed as the first-order function of temperature and were determined from the experimental data. The calculated results for the new interaction parameters were satisfactory. The measured systems were also correlated with the Wilson and 2-h models, and the results were compared with those of the UNIFAC model.     

Temperature dependence of kinetics and diffusion coefficients for ferrocene/ferricenium in ammonium-imide ionic liquids

The electrochemical behavior of ferrocene (Fc) and ferricenium (Fc⁺) was investigated by cyclic voltammetry with convolutional and semi-differential electroanalyses in the temperature range 298-373 K in the hydrophobic room temperature ionic liquid systems consisting of bis(trifluoromethanesulfone)imide anion with quaternary ammonium cation. The experimental results indicated that the redox reaction of Fc/Fc⁺ was reversible in this ionic liquid and the charge-transfer rate constant (k⁰) has been obtained. Mass transport towards the electrode is a simple diffusion process and the diffusion coefficient (D) for Fc/Fc⁺ has been also calculated. These results indicated that the k⁰ and D increased with increasing temperature in ionic liquids. The validity of the Arrhenius law was verified by investigating the temperature dependences of k⁰ and D.     

Simultaneous HPLC quantification of total cholesterol,tocopherols and β-carotene in Barrosã-PDO veal

A simple, rapid and sensitive procedure for the simultaneous determination of total cholesterol, tocopherols and β-carotene in meat is described. The method involves a direct saponification of the meat, a single n-hexane extraction and the analysis of the extracted compounds by normal-phase HPLC, using fluorescence (tocopherols) and UV–Vis photodiode array (cholesterol and β-carotene) detections in tandem. Rates of recovery of spiked meat samples were 93% for cholesterol, 83–86% for (α-, β- and -γ) tocopherols and 89% for β-carotene. Repeatabilities were high (CV < 6%) for all determined compounds, except for δ-tocopherol. This tocopherol, which is not usually present in meat, showed a much lower recovery percentage (73%) and repeatability (12.8%). This methodology was applied for the quantification of total cholesterol, tocopherols and β-carotene in three muscles (longissimus thoracis, longissimus lumborum and semitendinosus) of the Portuguese traditional Barrosã-PDO veal, obtained from autochthonous calves fed extensively during summer (with the least abundant green pastures) and slaughtered in early autumn (October). Barrosã-PDO veal showed median contents of total cholesterol (0.50–0.56 mg/g) and, depending on the analysed muscle, moderate to high contents of α-tocopherol (3.3–3.9 μg/g) and β-carotene (0.07–0.09 μg/g), suggesting an high sensorial and hygienic quality.     

Q195冷轧板材轧制困难原因分析

针对部分Q195冷轧板材存在轧制困难的现象，进行了现场检验与分析。带状组织、混晶现象严重导致变形强化系数偏高是造成轧制困难的主要原因。     

Water and salt permeability of reinforcement polymer‐gel composite membrane

The charged mosaic polymer membrane (CMM) without reinforcement and the composite charged mosaic polymer membrane (CCMM) with reinforcement were investigated in terms of salt and water transport (permeability). The composite charged mosaic polymer membrane (CCMM) with reinforcement showed a unique transport behavior such as preferential material transport L_p and ω. Water permeability coefficient, L_p and salt permeability coefficient, ω were estimated by taking account of active layer thickness of composite polymer gel. The L_p and ω values of CCMM with reinforcement were larger than those of CMM without reinforcement. On the other hand, the reflection coefficient of CCMM, σ, showed negative value, which suggested preferential material transport to solvent transport. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Water absorption properties of phosphate glass fiber‐reinforced poly‐ϵ‐caprolactone composites for craniofacial bone repair

The moisture uptake of polymers and composites has increasing significance where these materials are specified for invasive, long‐term medical applications. Here we analyze mass gain and the ensuing degradation mechanisms in phosphate glass fiber reinforced poly‐?‐caprolactone laminates. Specimens were manufactured using in situ polymerization of ?‐caprolactone around a bed of phosphate glass fibers. The latter were sized with 3‐aminopropyltriethoxysilane to control the rate of modulus degradation. Fiber content was the main variable in the study, and it was found that the moisture diffusion coefficient increased significantly with increasing fiber volume fraction. Diffusion, plasticization, and leaching of constituents appear to be the dominant aspects of the process over these short‐term tests. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008