control with limited communication and message losses

We propose an H^∞ approach to a remote control problem where the communication is constrained due to the use of a shared channel. The controller employs a periodic time sequencing scheme for message transmissions from multiple sensors and to multiple actuators of the system. It further takes into account the information on the random message losses that occur in the channel. An exact characterization for controller synthesis is obtained and is stated in terms of linear matrix inequalities. Furthermore, an analysis on the loss probabilities of the messages to accomplish stabilization is carried out. The results are illustrated through a numerical example.     

冷拉减面率对C形环用Inconel X-750丝材组织性能的影响

文章通过冷拉拔加工制备减面率为0%、30%、60%的Inconel X-750丝材,分别在650℃、730℃、810℃下时效处理16h,研究冷拉减面率对X-750合金组织性能的影响,特别是减面率对γ′相形状、分布、数量及尺寸的影响。经定量分析,增大冷拉减面率除了有细化晶粒的作用外,还能一定程度地增加γ′相析出的颗粒数量及体积分数,减小γ′相尺寸,进一步加强沉淀强化的作用。时效温度对X-750丝材的晶粒尺寸没有明显影响,对γ′相的数量、尺寸及形状影响较大。采用730℃时效处理16h的标准工艺制备的X-750丝材,经加工为弹簧后制造成金属C形密封环,其回弹量及泄漏率均满足要求,实验条件下密封性能良好。     

WebGIS在114电话导航中的应用

针对114传统业务在空间信息查询方面的局限性及用户对位置信息的多样化需求,实现一种基于瓦片和Ajax技术的电子地图发布,设计POI查询、公交搜索和自驾导航路径分析等3个空间搜索引擎,并开发一套114电话导航WebGIS平台。该平台可供114客服人员为客户提供各种空间信息查询服务。     

Finding an Euclidean anti--centrum location of a set of points

An obnoxious facility is to be located inside a polygonal region of the plane, maximizing the sum of the k smallest weighted Euclidean distances to n given points, each protected by some polygonal forbidden region. For the unweighted case and k fixed an O(n²logn) time algorithm is presented. For the weighted case a thorough study of the relevant structure of the multiplicatively weighted order-k-Voronoi diagram leads to the design of an O(kn³+n³logn) time algorithm for finding an optimal solution to the anti-t-centrum problem for every t=1,…,k, simultaneously.     

Sensitivity of SAR data to post-fire forest regrowth in Mediterranean and boreal forests

Disturbed forests may need decades to reach a mature stage and optically-based vegetation indices are usually poorly suited for monitoring purposes due to the rapid saturation of the signal with increasing canopy cover. Spaceborne synthetic aperture radar (SAR) data provide an alternate monitoring approach since the backscattered microwave energy is sensitive to the vegetation structure. Images from two regions in Spain and Alaska were used to analyze SAR metrics (cross-polarized backscatter and co-polarized interferometric coherence) from regrowing forests previously affected by fire. TerraSAR-X X-band backscatter showed the lowest sensitivity to forest regrowth, with the average backscatter increasing by 1-2 dB between the most recent fire scar and the unburned forest. Increased sensitivity (around 3-4 dB) was observed for C-band Envisat Advanced Synthetic Aperture (ASAR) backscatter. The Advanced Land Observing Satellite (ALOS) Phased Array-type L-band Synthetic Aperture Radar (PALSAR) L-band backscatter presented the highest dynamic range from unburned to recently burned forests (approximately 8 dB). The interferometric coherence showed low sensitivity to forest regrowth at all SAR frequencies. For Mediterranean forests, five phases of forest regrowth were discerned whereas for boreal forest, up to four different regrowth phases could be discerned with L-band SAR data. In comparison, the Normalized Difference Vegetation Index (NDVI) provided reliable differentiation only for the most recent development stages. The results obtained were consistent in both environments.     

Triton X-100 pretreatment of LR-white thin sections improves immunofluorescence specificity and intensity

The staining of intracellular antigenic sites in postembedded samples is a challenging problem. Deterioration of antigenicity and limited antibody accessibility to the antigen are commonly encountered on account of processing steps. In this study preservation of the antigen was achieved by fixing the tissues with mild fixatives, performing partial dehydration, and embedding in a low crosslinked hydrophilic acrylic resin, LR-White. Permeabilization of cell membranes with Triton X-100 is well documented but can affect some antigen conformations. We tested the effect of Triton X-100 on the ED1 antigen present in the lysosomal membrane of the macrophage in cell culture. The ED1 antigen in the lysosome was resistant to extraction by Triton X-100. Interestingly pretreating the LR-White sections of macrophage pellets with Triton X-100 improved the staining intensity of ED1. The most intense and clear specific fluorescent staining was observed when sections were pretreated with 0.2% Triton X-100 for 2 min. Longer exposure of sections to 0.2% Triton or 2 min exposure to 2% Triton lead to reduced ED1 labeling. SEM observations indicated that the detergent extracted a component from the cells and not the resin and was determined to be lipid. This novel technique could be applied in many research areas where postembedding fluorescent immunolabeling with higher labeling intensity is desired.     

浊点萃取分光光度法测头发中锌的含量

针对传统萃取分光光度法测定头发中的锌含量,需要使用苯、四氯化碳等有机毒性试剂萃取锌-双硫腙疏水配合物,存在污染环境和操作费时之弊端,采用浊点萃取法代替有机毒性试剂萃取锌-双硫腙红色疏水配合物,用分光光度法测定人发中的锌含量.选择湿法消化处理头发试样,选取非离子表面活性剂曲拉通X-114和硫酸铵作为浊点萃取体系,对锌-双硫腙红色疏水配合物进行浊点萃取;实验测定了浊点萃取物的最大吸收波长、萃取剂的浓度、萃取剂的测定、硫酸铵的用量及显色体系的pH和显色剂的用量对吸光度的影响,并进行回收率实验.实验结果表明浊点萃取的配合物最大吸收波长为527 nm、质量分数2％的萃取剂为0.3～1.0 mL、硫酸铵1.2g、pH为4.5、显色剂的用量为0.2～0.8 mL,锌含量的线性范围为0.2～1.2 μg/mL,线性回归方程为A=0.435 9 c（μg/mL） ＋0.014 8,相关系数r=0.997 3,表观摩尔吸光系数为5.894×10 000 L/（mol·cm）,测定结果的相对偏差为2.4％,回收率为98.76％～102.2％.用该法测定头发中的微量锌,结果令人满意,对食品中微量锌的测定具有一定应用价值.     

Tribological behavior of sialon ceramics sliding against steel lubricated by fluorine-containing oils

The friction and wear behavior of sialon ceramics sliding against steel and lubricated by perfluoropolyethers (PFPE), tetrakis (3-trifluoromethylphenoxy)-bis(4-fluoro-phenoxy)-cyclotriphosphazene (X-1P) and ionic liquid (1-methyl-3-octylimidazolium tetrafluoroborate, coded as L108) were investigated. It was found that the three fluorine-containing lubricants reduced friction coefficient and wear volume effectively. The effectiveness of the three lubricants in reducing wear volume could be ranked as L108>X-1P>PFPE. The antiwear films mainly consisting of organic oxyfluoride or carbonfluoride species and silicon fluoride are all observed for the three lubricants, while the degradation of PFPE during friction might account for the higher wear volume therewith. The lowest friction coefficient 0.065 was recorded for L108 under load of 0.5–400 N. This is dependent on the physically adsorbed ionic liquid on the rubbing surface and the formation of BN under the harsh conditions.     

HZSM-5分子筛负载SrTiO_3光催化降解活性艳红X-3B

采用溶胶-凝胶法制备HZSM-5分子筛负载SrTiO_3,对其进行XRD、FTIR和N2吸附-脱附表征,研究负载对活性艳红X-3B光催化降解过程的影响。通过分析降解液的FTIR谱图、紫外-可见光谱和总有机碳(TOC)数据,对活性艳红X-3B的光催化降解过程进行了探讨。结果表明:催化剂的主要成分为钙钛矿结构SrTiO_3,负载对SrTiO_3晶粒尺寸几乎没有影响。纯SrTiO_3没有明显的孔结构,负载后样品的比表面积和孔隙主要由HZSM-5提供。负载之后催化剂的降解活性显著提高,30%SrTiO_3/HZSM-5对活性艳红X-3B染料溶液的脱色和TOC去除速率最快。     

真空增压铸造工艺对ZL114A合金充型能力和力学性能的影响

目的 研究不同真空增压铸造工艺参数下ZL114A合金的充型距离、组织性能的变化规律。方法 设计了不同厚度的充型距离测试片,采用游标卡尺测试了不同真空度和石膏铸型温度条件下合金的流动性。采用万能拉伸机测试了不同凝固压力条件下单铸试棒的力学性能,采用金相显微镜观察合金的显微组织,采用扫描电子显微镜观察拉伸断口的形貌。结果 当真空度从重力状态(0 MPa)提高至-0.08 MPa时,3.0 mm薄片的充型距离从42 mm提升至210 mm。当铸型温度从260℃提高至340℃,3.0 mm薄片的充型距离从95 mm提升至175 mm。凝固压力从重力条件下提升至0.8 MPa,抗拉强度从293 MPa提升至338 MPa,屈服强度从240 MPa提升至278 MPa,断后伸长率从2.0%提升至4.0%。结论 提高真空度、铸型温度,可显著提升ZL114A合金的充型能力。提高凝固压力、凝固组织致密,第二相分布均匀,疏松缺陷明显减少,力学性能提高。