西门子PLC与计算机间的通讯程序设计

介绍了西门子（Siemens）公司生产的S7－200型PLC与计算机之间的通讯网络构成及主要通讯指令，说明了利用PLC进行通信的实质和设计步骤，给出了PLC与计算机通讯时上位机和下位机的相应程序。     

Oxygen-enrichment of YBa2Cu3 YBa2Cu3O7-δ using the fluidization techniqueusing the fluidization technique

The oxygen-deficient phase of the highT _c superconductor, YBa₂Cu₃O₇, was oxygen-enriched using the fluidization technique to give good superconducting properties. The normal method of oxygen treatment at 900°C for 24 h and at 600°C for 24 h has been reduced to just one treatment at 600°C for 12 h by the fluidization technique to achieve almost the same strength of superconducting signal for the YBa₂Cu₃O₇ powder, which establishes the attractiveness of the latter route for the large-scale preparation of superconducting material. The particle sizes were in the range 0–90, 90–180 and 180–420 μm. The fluidized particles were crystalline with orthorhombic distortion.T _c ^onset , estimated using the a.c. magnetic susceptibility method, was 91·3 K. The volume fraction of superconducting material in the product was 83·7–85·3%, one of the highest values reported so far for YBa₂Cu₃O₇.     

Recent Progress of HT-7U Superconducting Tokamak

HT-7U is a superconducting tokamak. which is being constructed in Institute of Plasma Physics, Chinese Academy of Sciences. The mission of the HT-7U project is to develop a scientific and engineering basis of the steady state operation of advanced tokamak.The engineering design of the device has been optimized. The R&D program is going on. Short samples of the conductor and a CS model coil were tested. All the TF and PF coils will be manufactured and tested in Institute of Plasma Physics. Therefore, a 600-meter long jacketing line for cable-in-conduit conductors along with two winding machines, a set of VPI equipment and a test facility for the TF and PF coils are ready in ASIPP now. In this paper, the recent progress of the HT-7U is described.     

长脉冲激光沉积原位生成YBaCuO超导膜

用长脉冲激光(脉冲宽度150μs,波长1.06μm)辐照高温烧结的YBa_2Cu_3O_(7-x)靶,在6Pa的氧气压强下,巳在(100)YSZ单晶衬底上原位生成YBa_2Cu_(?)O_(7-x)超导膜。衬底置于750℃的加热器上,衬底与靶之间的距离5cm,用该法制得的薄膜光亮坚实,正常态呈金属性,零电阻温度为84.7K。用XRD和SEM对薄膜进行了分析研究。     

Dislocations and flux pinning in YBa2Cu3O7

The dislocation structures of bulk textured and epitaxial thin film YBa₂Cu₃O₇ superconductors are examined. Correlations between increases in flux pinning and dislocation densities are noted. A model for flux pinning by individual dislocations is presented. This gives a treatment of strain induced effects and effects of normal state region interactions. It is shown that the values of pinning predicted are in line with experimental observations.     

A Cross-Cultural Investigation of the Efficacy Beliefs of South Asian Immigrant and Anglo Canadian Nonimmigrant Early Adolescents.

The author explored the mathematics efficacy beliefs of 270 South Asian (Indo Canadian) immigrant and Anglo Canadian nonimmigrant Grade 7 students. Self-efficacy beliefs strongly predicted mathematics performance for both cultural groups, but there were differences between the 2 groups in the sources of self-efficacy, the predictiveness of the secondary motivation variables, and the vertical dimensions of individualism and collectivism. It is argued that the Indo Canadian students are more vertical or hierarchical than the Anglo Canadian students and that comparison with others strongly influences their motivation beliefs and the formation of their efficacy beliefs. Self-efficacy in some cultures may be more other-oriented than is typically seen in Western cultures. A caution against generalizing about Asian populations is given, and implications for school settings are explored. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

单相负载三相供电功率分配之PLC改造实践

介绍了单相负载一工频感应炉供电的S7-200CPU224改造实践方案.依托原有设备条件,三相功率分配同样设计采用电容、电抗进行调节,起、停及三相电流平衡控制由晶闸管 接触器形式替代原单纯采用接触器控制,有效值测量使用有别于FFT的检测算法.运行实践表明:节能降耗明显,设备故障率大幅降低,具有良好的推广应用价值.     

Effect of praseodymium substitution on the growth and properties of Y1−x Pr x Ba2Cu3O7−δ (o <x < 0·4) single crystals

In the present paper, a modified self-flux technique has been successfully employed for the growth of pure and praseodymium substituted (partially) large single crystals of high temperature superconducting Y_1−x Pr _x Ba₂Cu₃O_7−δ (x = 0·0,0·2,0·4). Typical sizes of the platy and bulky crystals of pure YBCO(123) material are ≈ 2 × 2 × 0·1 mm³ and 4 × 1 × 1 mm³, respectively. In case of Pr-substitution, the typical sizes of platy and bulky crystals of Y_0·8Pr_0·2Ba₂Cu₃O_7−δ and Y_0·6Pr_0·4Ba₂Cu₃O_7−δ materials are ≈ 2 × 3 × 0·1 mm³ and 5 × 1 × 1 mm³ and ≈ 1 × 1·5 × 0·1 mm³ and 7 × 0·2 × 0·1 mm³, respectively. The morphology and growth habit of the as-grown single crystals and the critical transition temperature (T _c) of the oxygenated crystals were found to depend on the Pr-content. Paper presented at the poster session of MRSI AGM VI, Kharagpur, 1995     

The performance of foliage mass and crown radius models in forming the input of a forest reflectance model: A test on forest growth sample plots and Landsat 7 ETM+ images

Several published foliage mass and crown radius regression models were tested on the preparation of the input for the reflectance model of Kuusk and Nilson [Kuusk, A. and Nilson, T. (2000), A directional multispectral forest reflectance model. Remote Sensing of Environment, 72(2):244–252.] for 246 forest growth sample plots in Estonia. In each test, foliage mass and crown radius for trees in the sample plots were predicted with a particular pair of allometric regression models. The forest reflectance model was then run using the estimated foliage mass and crown radius values. Reflectance factors were simulated and compared with the reflectance values obtained from three atmospherically corrected Landsat 7 Enhanced Thematic Mapper (ETM+) scenes. The statistics of linear regression between the simulated and measured reflectance factors were used to assess the performance of foliage and crown radius models. The hypothesis was that the best allometric regression models should provide the best fit in reflectance. The strongest correlation between the simulated and measured reflectance factors was found in the short-wave infrared band (ETM + 5) for all the images. The highest R² = 0.71 was observed in Picea abies dominated stands. No excellent combination of foliage mass and crown radius functions was found, but the ranking based on determination coefficients showed that some linear crown radius models are not applicable to our data. Processing of raster images, reflectance measurement for small sample plots, usage of tree-species-specific fixed parameters (specific leaf area, etc.), and the ignored influence of phenology introduced additional variation into the relationships between simulated and measured reflectance factors. Further studies are needed, but these preliminary results demonstrate that the proposed method could serve as an effective way of testing the performance of foliage mass and canopy cover regressions.