铵离子交换处理负硬水供锅炉应用技术

本文论述了负硬水只用氯化铵再生时离子交换器的运行过程及离子交换软化除碱的方法,并阐述了控制出水中残留碱的简便方法。经研究证明,此方法可达到除碱度、除硬度、除盐、延长锅炉使用寿命、减少腐蚀、减少排污量、节约燃煤等效果。经济效益十分显著。     

Cathodic processes in the leaching and electrochemistry of covellite in mixed sulfate–chloride media

The cathodic processes that occur on a covellite (CuS) surface in mixed sulfate–chloride solutions in the absence and presence of copper(II) ions have been studied using potentiostatic transients and cyclic voltammetry at rotating disk electrodes in the potential range 0.3–0.7 V (versus SHE). This range is relevant to the oxidative leaching of this copper mineral in sulfate and chloride lixiviants. Variations in the concentrations of sulfate and chloride ions had a small effect on the cathodic reduction of covellite in the potential range of 0.5–0.3 V, although the presence of chloride ion resulted in a significant increase in the anodic current on the reverse sweep. On the other hand, addition of copper(II) ions resulted in enhanced cathodic currents and subsequent anodic currents in both sulfate and chloride solutions due to reduction of covellite to an undefined reduced copper sulfide species. Reduction of copper(II) to copper(I) ions becomes the preferred cathodic reaction as the concentration of chloride ions increases, becoming mass transport controlled at a rotating disc electrode at potentials below about 0.4 V. Potentiostatic measurements at potentials negative to the mixed potential in acidic chloride solutions have shown that reduction of copper(II) ions is reversible and have been used to estimate the rate of oxidative dissolution of the mineral which value agrees reasonably well with previously reported leaching rates under similar conditions. Reduction of dissolved oxygen has been found to be very much slower that that of copper(II) ions under ambient conditions.     

Studies on cross-linked polyurethane acrylate-based electrolyte consisting of reactive vinyl/divinyl diluents

A series of cross-linked polyurethane acrylate (PUA) electrolytes have been prepared by using 4,4′-methylene bis(phenyl isocyanate), polyethylene glycol, hydroxyethyl methacrylate and different reactive vinyl/divinyl diluents, such as methyl methacrylate (MMA), ethyl acrylate and acrylonitrile, tripropylene glycol diacrylate (TPGDA). The electrolytes were prepared by UV radiation induced cross-linking of the PUA-diluent mixture followed by swelling in a liquid electrolyte (LP-30). Depending upon the composition of the components, these electrolytes exhibited a wide range of mechanical and electrical properties. The system containing MMA as reactive diluent showed highest conductivity, but poor mechanical properties and stability in the liquid electrolyte. The TPGDA cross-linked system possesses a good combination of ionic conductivity and stability in liquid electrolytes. These systems showed good compatibility with Li-electrodes and sufficient electrochemical stability to allow safe operation in rechargeable Li-batteries.     

VAc／MMA半连续乳液共聚合的研究：Ⅱ分子量及其分布

以过硫酸铵为引发剂，十二烷基硫酸钠为乳化剂，于７０℃下进行了ＶＡｃ／ＭＭＡ乳液共聚合试验。试验确定了不同组成ＶＡｃ／ＭＭＡ共聚物的Ｍａｒｋ－Ｈｏｕｗｉｎｋ方程参数Ｋ和α值。对ＧＰＣ测试数据处理给出了加料速率，乳化剂量，单体比例及种子与非种子法对分子是及其分布的影响。     

醋酸乙烯酯对丙烯酰胺聚合反应的影响

探讨了醋酸乙烯酯在丙烯酰胺聚合反应中的影响。实验证明在丙烯酰胺水溶液混入少量醋酸乙烯酯 ,该水溶液经阳离子交换树脂处理后 ,可聚合生成交联型丙烯酰胺胶体。     

γ 射线引发 VAc 乳液聚合以制备白乳胶的动力学及工艺条件研究

研究了ＶＡｃ的辐射乳液聚合动力学，并对其聚合工艺条件作了初步探索。得出ＶＡｃ乳液在进行辐射聚合时，成核期结束较早（转化率在１０％以下），有相当长的恒速期存在。乳胶粒子直径在０．５～３μｍ之间，比一般的乳液聚合乳胶粒子要大。同时从动力学数据还可以看出几种成核机理（胶束成核，水相成核和液滴成核）同时存在，由此对试验条件提出了相应的要求。     

Stability of protective oxide films in waste incineration environment—solubility measurement of oxides in molten chlorides

Solubility measurements of several oxides in molten NaCl-KCl and NaCl-KCl-Na₂SO₄-K₂SO₄ were conducted in three different levels of basicity. The dissolution behavior of the oxides showed almost the same tendency as that shown by the dissolution behavior of the oxides in molten Na₂SO₄ in literature. In a waste incineration environment, a protective Cr₂O₃ film easily dissolves in molten chlorides as CrO₄²⁻ because pO²⁻ of the molten chlorides tends to have a small value due to the effect of water vapor contained in the combustion gas. From the result of the solubility measurement, the addition of molybdenum and/or silicon was expected to improve the corrosion resistance of alloys. Laboratory corrosion tests confirmed this expectation. However, the scale analysis suggested that the effect of molybdenum could not be explained completely by only the mechanism derived from the result of the solubility measurement.     

Synergistic inhibition between o-phenanthroline and chloride ion for steel corrosion in sulphuric acid

The corrosion inhibition of cold rolled steel in 0.5 M sulphuric acid in the presence of o-phenanthroline and sodium chloride (NaCl) has been investigated by using weight loss and electrochemical techniques. The experimental data suggest that the inhibition efficiency increases with increasing NaCl concentration in the presence of 0.0002 M o-phenanthroline, but decreases with increasing temperature. A synergistic effect is observed when o-phenanthroline and chloride ions are used together to prevent cold rolled steel corrosion in 0.5 M sulphuric acid. The polarization curves showed that the complex of o-phenanthroline and NaCl acts as a mixed type inhibitor. The experimental results suggested that the presence of chloride ions in the solution stabilized the adsorption of o-phenanthroline molecules on the metal surface and improved the inhibition efficiency of o-phenanthroline. The adsorption of the complex accords with the Langmuir adsorption isotherm. Some thermodynamic parameters such as adsorption heat, adsorption entropy and adsorption free energy have been calculated by employing thermodynamic equations. Kinetic parameters such as apparent activation energy and pre-exponential factor have been calculated and discussed.     

Ability of the direct wave of radar ground-coupled antenna for NDT of concrete structures

The research work presented in this paper aims at evaluating the potential of the direct wave of radar ground-coupled antennas for the on site physical characterization of concrete. According to studies highlighting the ability of radar reflected waves to characterize concrete, the potential of the direct wave is studied by systematic comparison of direct and reflected wave attenuations. Among the various features of electromagnetic waves propagating through concrete, attenuation is the most sensitive to moisture and chloride contents. In order to study the sensitivity of the direct wave to the physical condition of the concrete, laboratory experiments were conducted on concrete slabs with various porosities, water contents and chloride contamination levels.The results of this study show very satisfactory correlations between attenuations of direct and reflected waves, indicating that both waves provide similar information regarding the physical state of concrete. This correlation was confirmed on two bridges by comparison of direct wave attenuation maps with reflection attenuation maps. Therefore, radar interpretation method based on the direct wave attenuation should be able to detect, in a very fast way, physical contrasts in concrete structures and, consequently, identify probable pathological areas.     

Corrosion rate of magnesium and its alloys in buffered chloride solutions

The effect of the buffer capacity of test solution on the corrosion rate of cast pure (>99.95 mass%) and high-purity (>99.9999 mass%) magnesium, and AZ31 and AZ91E has been studied. Their corrosion rates were measured gravimetrically in a pH 6.5 and a pH 9 borate buffer including chloride ions, and in a conventional chloride solution. Except for the AZ91E in the pH 6.5, the corrosion rates of all the examined materials depended solely on the pH of the test solution, although the materials had a variety of purity and alloying elements. Higher buffer capacity probably masked the detrimental effect of the “cathodic impurities”. The corrosion rates measured in the buffers were considered as giving the resistivity of the passive film to anodic reactions. The high-purity magnesium had a fair corrosion resistance even in conventional chloride solution.