提高前馈神经网络推广能力的若干实际方法

提高前馈神经网络的推广能力是深受关注的问题，本文根据我们最近提出了一个网络有效推广的准则，从提高网络特征提取能力，分类能力和修改神经元激活函数等几方面给出了若干实际方案，我们在任意手写数字识别问题上的实验结果证实了这些方法的有效性。     

芝麻营养原液的开发与研究

本文对芝麻营养保健成分的提取进行了系统的研究。确定了芝麻营养原液的制取工艺。为充分发挥芝麻的营养保健作用开辟了新的途径。     

Unperturbed dimension of poly(4-acetoxystyrene) measured in good and theta solvents

In order to obtain the additional data concerning the unperturbed dimension of poly-4-substituted styrene, light scattering measurements are performed on the twenty-two fractions with molecular weight of (0.91–352)·10⁴ of poly(4-acetoxystyrene) in dioxan at 25°C, from which the molecular weight obtained was found easily to be evaluated with the gel permeation chromatography using THF. Phase separation experiments for this polymer indicate that the theta state is attained in isopropyl acetate at 19.7°C and butyl acetate at 26.8°C. By making viscosity measurements at that state, the value of K_Θ is directly evaluated as 5.4·10^?4 dl g^?1. The limiting viscosity number is also obtained in good solvents, THF and dioxan, at 25°C and constants of the Mark-Houwink-Sakurada equation in each solvent are determined. Further, approximately the same K_Θ as above is obtained from these data with the Stockmayer-Fixman plot. The calculated value of steric factor, 2.37, on this polymer may be plausible, compared with those of polyvinylaromatic derivatives.     

莲心中可溶性成分的有效提取

采用不同的原料处理,改变提取的流程和提取时间，测定不同条件下所得提取液的可见吸收光谱，以此反映各提取液的组分和浓度是否发生变化，并比较在最大吸收波长下各提取液的吸光度大小，从而确定将莲心捣碎后，加热回流时间为60min的提取方法效果最佳。     

HPMBP与伯胺N_(1923)对希土元素(Ⅲ)的协同萃取

本文研究了HPMBP与伯胺N_(1923)的二甲苯溶液,从盐酸介质中协同萃取希土(Ⅲ)的机理。用斜率法、恒摩尔法确定了协萃配合物的组成为:RNH_3Ln(PMBP)_4。求得关于Pr(Ⅲ)协萃反应的平衡常数及协萃配合物的生成常数分别为:logK_(12)=-1.95;logβ_(12)=3.94。实验发现,协萃系数(R)随希土元素的原子序数(Z)递变而呈现“双峰效应”。还研究了协萃配合物的IR,NMR谱。     

用菱锌矿制取轻质氧化锌的研究

介绍了以菱锌矿为原料生产轻质氧化锌的方法，论述了反应酸浓度，煅烧温度，溶液PH值对实验的影响，并对生产工艺条件进行了研究。其工艺流程是将粉碎后的菱锌矿进行循环酸浸，净化后再直接和碳化母液反应，经沉降后再煅烧分解为轻质氧化锌，产品质量符合国家标准，视比容大，活性强，成本低，经济效益显著。     

奎宁印迹聚合物的吸附与识别特性的研究

以奎宁为模板分子 ,利用分子印迹技术合成了一种新型的类似于人工受体的印迹聚合物 ,研究了它对奎宁和其它底物的吸附特性和选择性识别能力 ,并对其固相萃取性能做了初步的研究。     

螺旋焊管内涂层涂敷挥发份的清除

针对大口径螺旋焊管内涂层涂敷作业时，钢管内残留的涂料挥发份如何清除的问题，介绍了一种自行设计制造的内涂层涂敷挥发份吹除装置。     

A new efficient method for one‐pot conversions of aryl carboxylic acids into nitriles without solvent

A new efficient method for synthesising nitriles, important organic reagents, is reported in this paper. In an environmentally benign solvent‐free system, aryl carboxylic acids were converted into the corresponding nitriles via one‐pot reactions, by amidation with ethyl carbamate followed by dehydration with thionyl chloride, in excellent yields. The results showed that the method has the advantages of lower cost, higher yield, less pollution and greater ease of work‐up. Copyright © 2008 Society of Chemical Industry     

Original Finger Image Extraction by Morphological Technique and Finger Image Comparisons for Persons' Identification

This research uses the object extracting technique to extract the index, middle and ring fingers from the hand images. The algorithm developed in this research can find the precise locations of the different fingers' fingertips and the finger-to-finger-valleys. After finding the positions of the fingertips and finger-valleys, the index, middle and ring fingers can be extracted from the hand images by using morphological technique. The extracted index, middle and ring fingers contain many useful geometry features. One can use these features to do the person's identification. The orientations of the index, middle and ring fingers are found in this research. Image rotating, image shifting, and image interpolating techniques are used to align different persons' index, middle and ring fingers. Image subtraction is used to exam the difference of two index, middle and ring finger images. In this research so far only use the index, middle and the ring fingers as the features to identify different persons. ^★This work was supported by National Science Council under grant NSC 93-2213-E-212-011.