挡土墙填土曲线破裂面的地震主动土压力分析

在地震作用影响下，墙后填土处于极限平衡状态时，假定破裂面为一条通过墙趾的旋轮线。从墙后土楔中取出一微薄水平层，研究其在水平惯性力下的平衡，得到的地震土压力分布和土压力合力作用点位置均与实验结果相吻合。     

硫氰酸钠湿纺腈纶设备的孔蚀与防护

本文重点讨论了硫氰酸钠湿纺腈纶设备因钝化膜缺陷和Cl-侵入而产生孔蚀的机理及环境因素对孔蚀的影响,并针对产生孔蚀的主要原因提出了防护措施。     

X波段双极化有源相控阵天线的设计

机载或星载X波段有源相控阵雷达系统具有很高的分辨率，由于雷达系统使用了大量双极化子阵组成的有源相控阵天线（俯仰面和方位面均需扫描），频率的升高使得子阵馈线网络的可用面积受到了很大的限制。本文着重论述了有源相控阵天线中的双极化阵设计，提出了一系列解决方法，进而叙述了整个天线阵的设计。     

InGaAsP/InP有源双稳放大器的实验研究

本文报导了室温下F—P型InGaAsP/InP双异质结半导体激光放大器的双稳态效应,放大器的增益为20dB。     

STN—LCD的新进展

STN-LCD采用新的取向层,消除了残象;采用新的驱动波形,消除了串扰;采用二(口恶)烷、卤化物、链烯基、醚和二苯乙炔,改进了液晶料材的性能,使STN-LCD获得高的对比度、快的响应速度、低的驱动电压;采用有源矩阵驱动方法,消除了帧响应,使STN-LCD获得高的对比度、高的亮度及视频响应速度;使用温度跟踪电路,自动跟踪STN-LCD的阀值电压,使STN-LCD获得宽的工作温度。     

二(二甲苯基)丙烷合成工艺的研究

二氯丙烷(DCP)与二甲苯在混合金属氯化物催化剂(HD90)作用下合成二(二甲苯基)丙烷,生产过程简单,产品收率高。在60—80℃的温度下,二甲苯与二氯丙烷摩尔比为6∶1,HD用量50克/摩尔DCP的条件下反应5—6小时,二(二甲苯基)丙烷的收率可达88％以上。     

CAD OF MILLIMETER WAVE OSCILLATORS WITH THE FDHB TECHNIQUE

In this paper the modelling, analysis and optimization of millimeter wave oscillatorsare investigated by using the a frequency-domain harmonic balance technique (FDHB), where theexternal-circuit impedances looking outside from the active device are calculated with a combinedtechnique of modes expansion, Galerkin, and collocation methods. The optimization results arein agreement with the experimental ones, which show the reliability of the presented model andoptimization.     

Synthesis and characterization of chitosan/poly(acrylic acid) polyelectrolyte complex

Polyelectrolyte complex based on chitosan and acrylic acid monomer by photoinitiated free‐radical polymerization in the absence of crosslinker showed a large transition in swelling in response to changes in pH of surrounding medium. Their ability to swell arises from polyelectrolyte interactions and molecular structure of the complex. The main properties of interest that related to the molecular structure, swelling volumes, glass transition temperature, and elastic modulus of the complex were investigated. The effect of water content, the only variable in the sample component, played an important role in molecular structure of the complex and as a consequence, the extent of intermolecular linkage, especially amide bonds which in turn governed the degree of swelling of the polyelectrolyte complex in this study. The decreased degree of swelling and higher temperature shift of glass transition temperature was found with increased water content, whereas increased modulus of elasticity of dry complex was found in lower water content of synthesis component. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 1025–1035, 2002     

Recovery of monomers and fillers from high-temperature-vulcanized silicone rubbers—combined effects of solvent, base and fillers

The depolymerization of high-temperature-vulcanized (HTV) silicone rubbers containing filler silica and alumina into cyclosiloxane monomers and spontaneous recovery of fillers were studied. First, HTV silicone rubber was treated with different types of solvents in the presence of KOH to find that a triad mixture of diethylamine, methanol and hexane was appropriate not only to dissolve the silicone rubber to a suspension but also to separate fillers completely by filtration. The filtrate was distilled to remove solvent first and then give pure cyclosiloxane monomers in 76–84% yields. Second, the rubbers were treated with other types of triad mixture of solvents and bases, e.g. tetramethylammonium hydroxide, hexane and diethylamine. After filtration, residue was again treated with the amine and hexane to recover clean fillers in 83–93% yields. Cyclosiloxane monomers were also obtained from the combined filtrates in 67–78% yields.