注聚采出水分离用动态水力旋流器特性研究

原有的地面工艺和设备已不能满足聚合物驱采出水分离的要求。采用自行研制的动态水力旋流器，在增压与不增压两种工艺流程下，分别进行了流量和转数对分离效率的影响、转数与压力降的关系，以及入口压力与处理量的关系等项试验研究。试验结果表明，与静态水力旋流器相比，动态水力旋流器的分离效率明显提高，一般可提高10％左右；压力损失显著降低，约可减少0．1MPa，足见可在低压下工作，易于实现无泵运行；无泵运行明显比有泵增压运行的分离效率高，但处理量会有所降低。将动态水力旋流器应用于聚合物驱产出水的油－水分离处理是完全可行的。     

Sensitizing Mechanism and Adsorption Properties of Dye—Sensitized TiO2 Thin Films

The dye-sensitized TiO2 complex films were prepared by the dye coat onto TiO2 surfaces,and the sensitizing mechanism and adsorption properties of the dye-sensitized TiO2 complex films were inverstigated.The influence of the application conditions of dye adsorbed on TiO2 films on the amount of dye adsorption was discussed.Experimental results show that the concentration,the temperature of dye solutions and the dipping time of TiO2 films in the dye solutions have a significant influence on the amount of dye adsorption.Cell test indicates that the conversion efficiency of light to electricity increases with the amount of dye adsorption.     

含羧基的聚乙烯醇胺肟螯合纤维吸附钯的研究

研究了含羧基的聚乙烯醇胺肟（ＰＶＡＡＯ－ＡＡｃ）螯合纤维对钯的吸附，讨论了ｐＨ、温度、浓度、吸附时间对吸附率及回收率的影响。确定了最佳吸附条件，吸附钯的纤维用５％硫脲＋０．１０ｍｏｌ／Ｌ硝酸溶液可以解吸。     

PAA-PSF交联复合膜的制备及对低浓度有机醇水溶液反渗透分离性能研究

进行了ＰＡＡ（ＰｏｌｙａｃｒｙｌｉｃＡｃｉｄ）－ＰＳＦ（Ｐｏｌｙｓｕｌｆｏｎｅ）交联复合膜的制备，研究了交联剂、添加剂对膜性能的影响，并通过扫描电镜观察了膜的断面结构．研究了ＰＡＡ－ＰＳＦ交联复合膜对低浓度有机醇类水溶液反渗透分离性能．发现对于１０００×１０－６乙醇水溶液截留率达到６６．２％，透过流束可达０．９×１０－６（ｍ３·ｍ－２·ｓ－１）．随醇的分子量的增加，截留率不断上升，对戊醇的截留率达９４．３％，而透过流束则保持相对稳定．对不同结构醇类的分离性能研究表明，截留率存在有：ｔｅｒｔ－＞ｓｅｃ－＞ｉｓｏ－＞ｎ－的规律．     

TNT-RDX混合废水处理的实验研究——生物-吸附法

介绍了在２５￣３５℃的温度下，用厌氧－兼氧－水生生物－吸附组合工艺处理ＴＮＴ和ＲＤＸ混合废水的方法，进行了日处理量为６０￣９００Ｌ的实验室放大实验。当ＴＮＴ和ＲＤＸ混合废水总浓度为４￣１２ｍｇ／Ｌ时，经过该工艺处理后可达到国家排放标准。其中厌氧－兼氧能去除废水中８０％以上的ＴＮＴ和ＲＤＸ，水生生物（水葫芦）对ＴＮＴ及ＲＤＸ也有一定的降解效果，最后用活性炭吸附可以实现深度处理。     

Alkali-metal Na Adsorption and Promoted Oxidation on Si(100)2×1 Surface

The alkali-metal Na adsorption on Si(100)2×1 surface and its promoted oxidation and Si oxidegrowth have been investigated by means of thermal desorption,work function,Auger electronspectroscopy and photoemission electron spectroscopy.The experimental data showed that therewas a new state,interface electron state,near the Fermi level after the deposition of Na atoms.It wasfound that the presence of Na always caused an increase of the oxygen initial uptake whereas thepromotion of Si oxide growth was observed only at the coverage of Na greater than 0.5 ML.A newmechanism of Na-promoted Si oxide growth is suggested in this paper.     

Use of TNSAC in phosphate adsorption studies and relationships. Isotherm relationships and utility in the field

There is a need for developing low cost, easily and abundantly available, yet efficient, adsorbents for the removal of phosphates during the tertiary treatment of wastewaters. The tamarind nut shell activated carbon (TNSAC) prepared on a laboratory scale has been used to evaluate its performance for phosphate adsorption. This paper describes the laboratory production of this adsorbent material in its various forms, and discusses the effects of the TNSAC process variables (the unrinsed and rinsed forms of the TNSAC and the impregnation ratio) on its performance in adsorbing phosphate. The material has been shown to be a good alternative adsorbent. As much as 95% phosphate removal by the unrinsed TNSAC is possible in about 30 min under the test conditions. The phosphate adsorbing capacity is about two times higher for the unrinsed TNSAC in comparison to the rinsed TNSAC. The adsorption rates, however, transit to extremely low rates towards the end when equilibrium conditions could be attained in about 2 h contact time. The phosphate removal mechanics are adsorption and precipitation/ion exchange when unrinsed TNSAC is used, and adsorption alone for the rinsed TNSAC. The maximum phosphate removal is found to take place at an impregnation ratio of 1.0 for both forms of the TNSAC.     

A semi-analytic boundary element method for parabolic problems

A new semi-analytic solution method is proposed for solving linear parabolic problems using the boundary element method. This method constructs a solution as an eigenfunction expansion using separation of variables. The eigenfunctions are determined using the dual reciprocity boundary element method. This separation of variables-dual reciprocity method (SOV-DRM) allows a solution to be determined without requiring either time-stepping or domain discretisation. The accuracy and computational efficiency of the SOV-DRM is found to improve as time increases. These properties make the SOV-DRM an attractive technique for solving parabolic problems.     

非标准工况下空分设备增产氩的研究与实践

文章对非标准工况下的空分设备增产氩措施进行了研究。以宝钢6#60000m3/h空分设备为例,通过设计型算法和校核型算法,建立了空分设备精馏的数学模型,通过改变数学模型的参数,分析了在非标准工况下精馏塔内的组分浓度分布,并提出了优化后的操作方案和操作参数,实施后提高了空分设备的氩提取率,取得了显著的经济效益。     

40000m~3/h空分设备主换热器的设计及制造

通过对进口 4 0 0 0 0m3 /h空分设备主换热器进行结构分析及对比模拟计算 ,用国产传热翅片进行设计、采用真空钎焊工艺制造的主换热器 ,经并网运行 ,设计指标优于原空分设备 ,为今后成套大型空分设备板翅式换热器国产化设计、制造创造了条件。