黄河内蒙古段干流沉积物中砷含量及形态研究

为探明黄河内蒙古段沉积物中砷含量及形态分布特征,采集黄河内蒙古段干流柱状沉积物,采用HNO4-H2SO4-HCl O4法消解沉积物样品,提取沉积物中吸附型砷(A-As)、铝型砷(Al-As)、铁型砷(Fe-As)、钙型砷(CaAs)、包蔽型砷(O-As)5种形态砷,并采用氢化物发生原子荧光分光光度法测定砷含量。结果表明:黄河内蒙古段干流柱状沉积物中砷含量为7.123~16.661 mg/kg,平均为9.292 mg/kg;从整体上看,左岸沉积物砷含量高于右岸,随深度增加砷含量呈下降趋势,从上游至下游砷含量在黑柳子段出现高值;黄河内蒙古段沉积物中砷以Ca-As为主,O-As次之;随着深度的增加,总体上,Ca-As含量略有升高,A-As和O-As含量有所下降,Al-As和Fe-As含量基本不变。     

Authentication of the 31 species of toxic and potent Chinese materia medica by microscopic technique assisted by ICP-MS analysis, part 4: four kinds of toxic and potent mineral arsenical CMMs

Toxic and Potent Chinese Materia Medica (T/PCMM) is a special and very important category of Chinese medicines. They have long been used in traditional medical practice and are being used more and more widely throughout the world in recent years. As there may be many fatal toxic effects caused by misusing or confusion of T/PCMM, their quality and safety control arouse increasing attention internationally. Researches on the accurate identification to ensure the safe use of T/PCMM are acquired; however, there are few reports on authentication. We are carrying out a series of studies on 31 T/PCMM originating from plants, animals, minerals, and secreta. In our previous studies, we proved that modern microscopic authentication is a simple, fast, effective, low cost, and less toxic method for identifying animal, seed, and flower T/PCMM. In the present study, we focused on the authentication of four kinds of mineral arsenicals, including orpiment (mainly containing As₂S₃), realgar (mainly containing As₄S₄), arsenolite, and arsenic trioxide (mainly containing As₂O₃). We examined the macroscopic and microscopic characteristics of the above minerals and found that they all can be easily identified and authenticated by using light microscopy coupled with polarized microscopy. Moreover, the authentication results for arsenolite and arsenic trioxide are confirmed by ICP‐MS analysis. We are sure that the morphological and microscopic characteristics indicated here are indispensable to establishing standards for these four mineral T/PCMMs. Microsc. Res. Tech. 74:1‐8, 2011. © 2010 Wiley‐Liss, Inc.     

H_2O_2、Fenton试剂与活性炭联用对COD_(Cr)去除效果的对比试验研究

为了开发高效低成本、达到回用水质标准的污水处理工艺,本试验采用H2O2、Fenton试剂与活性炭联用对CODCr进行去除的对比试验研究。结果表明:在室温下200 mL水样,当pH为3,震荡强度为150 rpm时,Fenton试剂-活性炭联用与H2O2-活性炭相比,活性炭用量少200 mg,时间缩短10 h,CODCr去除率高17.6%。试验揭示了Fenton试剂-活性炭联用的反应机理:Fe2+与活性炭共同催化分解H2O2生成大量.OH,能快速氧化降解有机物,使CODCr浓度迅速降低。从工程应用角度和技术经济方面考虑,Fenton试剂-活性炭联用的pH值在5～7适宜;且处理成本更低。Fenton试剂-活性炭联用是处理二级出水CODCr高效、低耗的方法,值得进一步研究和推广应用。     

库仑滴定法测定工业废水中微量砷

以库仑滴定法测定工业废水中微量砷，以死停终点法确定滴定终点，最后以EXCEL处理实验数据，本方法具有灵敏度高，准确，简便快速，仪器便宜，易于推广的特点，特别适用于工厂及县级以下环境监测站进行水中微量砷的检测，方法的回收率为99．3％。     

常规火焰原子吸收光谱法测定水中的痕量砷

利用砷、镉在 2 2 8.8nm波长处重叠谱线的光谱干扰效应 ,研究了砷、镉共存体系的干扰特点 ,采用均匀设计 ,数学方法和计算机技术进行数据处理 ,实现了用常规火焰原子吸收光谱法同时测定痕量砷和镉 ,其中测定砷的灵敏度可达 10ng/ml,利用该方法分析了水中的痕量砷 ,其结果令人满意。     

深孔加工负压抽屑装置的优化设计与仿真

为解决深孔加工排屑的难题,在分析现有DF深孔钻削系统结构的基础上,运用液压相关理论分析了影响负压抽屑的影响因素.采用Fluent软件对DF系统中负压抽屑装置的喷射角k和负压间隙S进行了力学、速度、能量场仿真,最终通过理论分析与仿真试验的对比研究,得出当k=30°,S=0.4mm时负压效果最好,当k=29°,S=0.5mm时次之.为研究准干式深孔加工新型负压射流结构、负压机理及排屑特性提供了理论基础.     

The removal of arsenic from （ground）-water by adsorbent loaded in polymeric microspheres

Arsenic is a natural tasteless and odourless element,existing in the earth’s crust at average levels of between two and five thousands micrograms per liter (parts per million) . Arsenic is highly toxic to humans, who are exposed to it primarily from air,food and water. The occurrence of arsenic in groundwater is due to geological composition of soil. High concentrations of arsenic in water are the result of dissolution or desorption of ferric oxides and the oxidation of mineral arsenopyrites. Arsenic in drinking water has an important impact on the human health,especially in the less developed countries. Different methods exist to remove arsenic from aquatic media,and one of them is by adsorption. In this work,the adsorption of both As(III) and As(V) by means of novel microspheres has been investigated. In particular,TiO2 has been embedded into polymeric microspheres PES (PolyEtherSulphone) and PEEK-WC (PolyEtherEther-Ketone) . The main advantages of this encapsulation adsorption material are: no loss of adsorbents into the water stream,easy to be used and scaled-up.     

基于向量线段的特殊字符识别

传统的OCR技术在某些特定方面,如印刷体数学公式中特殊字符的识别存在困难和限制,其识别结果的准确率不尽如人意.为此,重点介绍基于向量线段的特殊字符识别算法规则和识别系统的设计.提出通过提取字符中的向量线段进行特征比较的分析方法,并将噪点去除算法融入其中.实验表明,该方法对于特殊字符的分析识别具有较好的准确性和应用前景.