（2m，2，m）非线性等重码不是最佳检错码

本文证明了当ｍ＞４时（２ｍ，２，ｍ）非线性等重码不是最佳检错码。     

Effect of enzymatic hydrolysis of proteins on growth of Bifidobacterium bifidus in milk

The effect of enzymatic hydrolysis of proteins in milk using neutrase on the growth of the probiotic strain Bifidobacterium bifidus was evaluated by estimation of microbial growth, acidity, viscosity and flavour production. A significant increase in the growth of B bifidus was observed in neutrase‐hydrolysed milk. The setting time of bifidus‐cultured milk was advanced by about 12 h at 5% degree of hydrolysis. Enzymatic hydrolysis of proteins prior to cultivation also significantly increased the viscosity of the product. An approximately 60% increase in viscosity of the product was observed in neutrase‐hydrolysed milk. Production of steam‐volatile monocarbonyls as an indication of development of flavour was also higher in neutrase‐hydrolysed milk. The concentration of steam‐volatile monocarbonyls was 2.47 µmol per 100 ml in neutrase‐hydrolysed milk but only 1.84 µmol per 100 ml in control milk at the setting point of the curd. © 2002 Society of Chemical Industry     

超高分子量聚乙烯的辐照效应

通过密度测定和ＤＳＣ热分析，观测了超高分子量聚乙烯的辐射效应。实验结果表明：在吸收剂量０—１．１３ＭＧｙ范围内，密度随吸收剂量的增加而增大，熔化热和熔点也有所增加，特别是在低剂量范围内增加十分明显。以上结果都说明，超高分子量聚乙烯在辐照过程中，结晶在完善或有新的结晶形成     

MPID─TOF质谱的快速时间分辨微弱信号测试系统

把瞬态记录仪Ｂｉｏｍａｔｉｏｎ８ｌ００与微型计算机ＩＢＭ─ｐＣ／ＸＴ联接建成了一个高速数据采集系统，本文介绍了系统的硬件接口设计及软件设计。在超声分子束条件下，把它应用于环氧乙烷（Ｃ＿２Ｈ＿４Ｏ）的多光子电离与离解飞行时间（ＭＰＩＤ─ＴＯＦ）质谱的实验研究中，并给出了实验结果；本系统在微观基元化学反应动力学实验研究中广泛适用于对时间分辨微弱信号的探测。     

Materials modelling: A bridge from atoms to bulk properties

The use of molecular-level materials modelling techniques in the development of advanced performance polymers is discussed, with particular emphasis upon bridging the large difference in the scales of dimensions between atomic structure and fabricated parts. The advantages and disadvantages of bulk quantitative structure-property relations and atomistic modelling are assessed, and the method of group interaction modelling is suggested as a means of bridging the dimensional scales.After a brief introduction to the concept of group interaction modelling, examples of modelling the engineering properties of polymers are presented which are difficult to model quantitatively by any other means. The important phase transitions from the crystal and glassy states of matter to those of rubber- and liquidlike states are shown quantitatively to be due to the same isoenergetic condition. The viscoelastic properties of a polymer are critical for many applications and expressions are derived for the loss and storage components of the complex modulus, with reference to failure initiation conditions. The effect of crosslinking in thermosets upon the glass transition temperature and viscoelastic properties is outlined. Finally, the scaling of time from atomic vibrations to the years involved in creep and ageing effects are discussed.     

Unperturbed dimension of poly(4-acetoxystyrene) measured in good and theta solvents

In order to obtain the additional data concerning the unperturbed dimension of poly-4-substituted styrene, light scattering measurements are performed on the twenty-two fractions with molecular weight of (0.91–352)·10⁴ of poly(4-acetoxystyrene) in dioxan at 25°C, from which the molecular weight obtained was found easily to be evaluated with the gel permeation chromatography using THF. Phase separation experiments for this polymer indicate that the theta state is attained in isopropyl acetate at 19.7°C and butyl acetate at 26.8°C. By making viscosity measurements at that state, the value of K_Θ is directly evaluated as 5.4·10^?4 dl g^?1. The limiting viscosity number is also obtained in good solvents, THF and dioxan, at 25°C and constants of the Mark-Houwink-Sakurada equation in each solvent are determined. Further, approximately the same K_Θ as above is obtained from these data with the Stockmayer-Fixman plot. The calculated value of steric factor, 2.37, on this polymer may be plausible, compared with those of polyvinylaromatic derivatives.     

Quantum chemical studies of Li cation binding to polyalkyloxides

A quantum chemical study of the binding of Li⁺ cation to polyalkyloxides has been carried out. The lithium cation interaction with three polyalkyloxides (polyethylene oxide (PEO), polytrimethylene oxide (PTMO), and polypropylene oxide (PPO)) has been investigated using ab initio molecular orbital theory at the HF/6-31G^* level with molecular models for the polymers. Coordination by one to six oxygens was considered. In addition, higher level calculations were carried out using G3(MP2) theory for coordination of Li⁺ by one oxygen. For coordination of lithium by one oxygen, the binding energy ordering is PTMO>PPO>PEO, with PTMO having the largest lithium cation affinity. The same ordering is found for larger coordination numbers with the exception of coordination by six oxygens, where the ordering changes due to the steric interactions.     

Molecular correlations in sheared thermotropic copolyesters showing banded textures

Banded textures produced in a thermotropic liquid crystal polymer by shearing between glass slides are examined by using both transmission electron and polarized light microscopy. The periodic variation in director orientation about the shear axis, as measured by light microscopy, is shown to be distinctly different from that indicated by electron diffraction. Measurements of birefringence and observation of Zernicke phase contrast indicate periodic variations in optical properties of the polymer, in step with the bands. Such effects are accounted for in terms of a synchronous rotation of the planar aromatic groups about the molecular chain axes. Evidence for an out-of-plane component of molecular orientation is also presented.     

Intramolecular crosslinking of poly(vinyl alcohol)

Poly(vinyl alcohol) is crosslinked in dilute solution (c=0.1 wt%) with glutaraldehyde. The reaction product is characterized by viscometry and gel permeation chromatography (g.p.c.). The intrinsic viscosity decreases with increasing degree of crosslinking and does not depend on temperature. G.p.c. reveals that the reaction product is not homogeneous, but consists of a mixture of particles with different sizes, possibly both intra- and intermolecularly crosslinked molecules. The intramolecularly crosslinked molecules are smaller in size than the initial polymer molecules and their size depends on the degree of crosslinking. They possess a narrow particle size distribution even if the initial polymer sample had a broad molecular weight distribution.