机抖激光陀螺检测电路前置放大器的设计与分析

首先简单介绍了激光陀螺信号特点,在此基础上设计一种实用的低噪声、大动态范围的激光陀螺前置放大整形电路。分析了该放大电路的基本工作原理,计算了放大电路的传递函数、相对误差和噪声。理论分析和实验结果表明：该放大整形电路完全能够满足激光陀螺的实用要求,并成功应用于机抖激光陀螺检测系统上,取得了良好的效果。     

基于网络处理器的RPR综合业务接入平台的设计

弹性分组环(RPR)是一种新的城域网技术,文章提出了用网络处理器IXP1 200构建RPR综合业务接入平台的设计方案,并重点讲述了其中微引擎部分的软件设计.     

基于有机场效应管的电荷模型的基础数字电路设计

An OFET charge model,as well as its parameter extraction method are presented.The fitting results are also discussed and different OFET model characters are compared.Some basic OFET based digital circuit blocks, including the inverter,NAND,and ring oscillator are also developed,which would be considered to be helpful to the design of relevant applications.     

泵浦功率对有源环形微腔滤波器特性的影响

研究泵浦功率对Er-Yb共掺磷酸盐玻璃有源环形腔滤波器滤波特性的影响。利用重叠积分方法求解Er-Yb共掺系统的速率方程与功率传输方程,讨论了泵浦功率对滤波器的传输特性、带宽和精细度的影响。数值计算结果表明:泵浦功率的改变不会改变环形腔滤波器的谐振特性,泵浦功率的提高对滤波器输出光谱特性具有重大的影响。一方面压缩了滤波器的带宽,另一方面又提高了滤波器的精细度。     

基于BMP及CMR的抗主瓣干扰算法研究

瓣干扰算法。通过分析阻塞矩阵预处理后数据特征值的变化情况,修正预处理导致的过处理现象,从而重构协方差矩阵,该算法适用于阻塞矩阵预处理导致的自由度损失的情况,能够解决由于预处理导致的主瓣波峰偏移等失真问题,同时算法复杂度较低。该算法最大的优点是当采样快拍包含目标信号时,其抗干扰性能较好,快拍敏感度相比常规的波束保形方法更低,经实测数据验证,结果显示出该算法的优越性。     

脊加载环板行波管的理论与实验研究

脊加载环板行波管是一种频带相对较宽的大功率行波管 ,本文对脊加载环板慢波系统及其改进型进行了研究 ,理论与实验良好符合 ,实验表明脊加载环板慢波系统的改进型比脊加载环板慢波系统具有更宽的频带 ;同时对慢波系统采用等效线路模型 ,电子注采用二维圆环模型 ,研究了脊加载环板行波管的大信号特性 ,讨论了注波互作用的非线性效应。本文的结果将为脊加载环板行波管的设计提供理论基础。     

Distributed feedback quantum cascade lasers operating in continuous-wave mode at λ≈7.6μm

正Distributed feedback(DFB) quantum cascade lasers(QCLs) in continuous-wave(CW) mode emitting atλ≈7.6μm are presented.Holographic lithography was used to fabricate the first-order distributed feedback grating. For a high-reflectivity-coated QCL with 14.5-μm-wide and 3-mm-long cavity,CW output powers of 300 mW at 85 K and still 10 mW at 270 K are obtained.Single-mode emission with a side-mode suppression ratio(SMSR) of about 30 dB and a wide tuning range of ~300 nm in the temperature range from 85 to 280 K is observed.     

超短环形腔布里渊掺铒光纤激光器

提出了一种超短环形腔布里渊掺铒光纤激光器(BEFL),腔长仅为10m。该BEFL以4m长的普通掺铒光纤(EDF)为激光增益介质,腔外布里渊抽运光和980nm抽运光的注入在掺铒光纤中,分别引入非线性布里渊增益和线性掺铒光纤放大器(EDFA)增益。实验结果表明,BEFL工作在单纵模状态,输出信噪比高(>40dB),抽运阈值低(～20mW),输出功率大(>10mW),且布里渊抽运光不仅决定BEFL的输出波长,更对其抽运阈值和出光功率有重要影响。     

Three-Stage Thin-Film Superlattice Thermoelectric Multistage Microcoolers with a Δ<Emphasis Type="Italic">T</Emphasis><Subscript>max</Subscript> of 102 K

Thin-film Bi₂Te₃- and Sb₂Te₃-based superlattice (SL) thermoelectric (TE) devices are an enabling technology for high-power and low-temperature applications, which include low-noise amplifier cooling, electronics hot-spot cooling, radio frequency (RF) amplifier thermal management, and direct sensor cooling. Bulk TE devices, which can pump heat loads on the order of 10 W/cm², are not suitable in these applications due to their large size and low heat pumping capacity. Recently, we have demonstrated an external maximum temperature difference, ΔT _max, as high as 58 K in an SL thin-film p–n couple. This state-of-the-art couple exhibited a cold-side minimum temperature, T _cmin, of −30.9°C. We regularly attain ΔT _max values in excess of 53 K, in spite of the many significant electrical and thermal parasitics that are unique to thin-film devices. These measurements do not use any complex thermal management at the heat sink to remove the heat flux from the TE device’s hot side. We describe here multistage SL cooling technologies currently being developed at RTI that can provide useful microcooling cold-side temperatures of 200 K. This effort includes a three-stage module employing independently powered stages which produced a ΔT _max of 101.6 K with a T _cmin of −75°C, as well as a novel two-wire three-stage SL cascade which demonstrated a T _cmin of −46°C and a ΔT _max of nearly 74 K. These RTI modules are only 2.5 mm thick, significantly thinner than a similar commercial three-stage module (5.3 mm thick) that produces a ΔT _max of 96 K. In addition, TE coolers fabricated from these thin-film SL materials perform significantly better than the extrapolated performance of similar thickness bulk alloy materials.     

太赫兹量子级联激光器

太赫兹技术近年来发展迅速,应用越来越广泛,是当前的热门研究领域。太赫兹量子级联激光器是产生太赫兹辐射的重要器件,对太赫兹量子级联激光器的发展,以及有源区和波导层的设计等进行了详细讨论。