家电卷材涂料用HDI改性聚酯树脂的研制

以己二异氰酸酯（HDI）改性聚酯树脂与氨基树脂配制成家电用卷材涂料。阐述了氨酯键对涂膜性能的贡献。探讨了HDI用量对涂膜性能的影响。     

不饱和聚酯树脂光固化工艺的研究-光引发剂浓度

本文选用TPO、651两种光引发剂，分别配制引发剂浓度为0．25、0．5、1、2wt％的不饱和聚酯体系。通过测定光固化试样的显微硬度分析光引发剂浓度对固化程度的影响。结果表明，提高引发剂浓度能抑制氧阻聚的作用，但对于较厚的试样，引发剂浓度过高会导致固化不完全。     

热固性树脂基防火涂料的研究

讨论了不同单组分树脂基体和树脂复配体系以及树脂用量对防火涂料性能的影响。确定以不饱和聚酯树脂和环氧树脂为树脂基体,以聚磷酸铵、三聚氰胺和季戊四醇为防火助剂,辅以填料和其他助剂,配制膨胀型防火涂料。实验结果表明,当树脂基体的质量分数为28%,涂层厚度为1.90 mm的条件下,涂料的防火性能最好,耐燃时间超过210 min。     

阳离子改性苯乙烯-马来酸酐共聚物的制备与表征及应用

以2,3-环氧丙基三甲基氯化铵(ETA)为阳离子化试剂,对苯乙烯-马来酸酐共聚物(SMA)进行阳离子化改性,制备出一种阳离子性高分子分散剂(SMG)。通过红外光谱、含氮量、表面张力以及溶解性等的测定,研究了SMG的结构与性质;通过对颜料黄14的分散性考察,研究了SMG的分散性能。结果表明,SMA在阳离子化过程中,酸酐基团全部开环,部分形成酯键,阳离子化度达到7.5%左右;SMG的表面活性较低,但对颜料黄14的分散稳定性较好,在pH=7.0条件下,可以使颜料的Zeta电位提高至 35.4 mV。     

高性能环氧乙烯基酯树脂在车辆制造上的应用

介绍了几种特种环氧乙烯基酯树脂在不同类型车辆部件制造上的应用，阐述了高性能树脂基复合材料在车辆上的应用情况和发展趋势。     

Evaporative light scattering mass detection for high-performance liquid chromatographic analysis of sucrose polyester blends in cooking oils

A high-performance liquid chromatographic method is described to determine the sucrose polyester (SPE) content in seven blends of cooking oils. Four gel-permeation chromatography (GPC) columns were used in series with an evaporative light scattering mass detector to separate the SPE from the acylglycerols in the final chromatogram. The SPE fraction was collected off the GPC column and injected onto a reverse-phase C-18 column for quantitation with sucrose octaacetate as an internal standard and a gradient of nonaqueous solvents as mobile phase. The chromatograms were interference-free, with only two sharp peaks appearing. The standards were linear from 500 to 5000 μg/mL with a correlation coefficient of r=0.999. The mean percent recovery (n=9) and standard deviation were 102±6.7. The detector could detect amounts as low as 5 μg SPE.     

阻燃聚酯纤维生产技术

主要介绍了聚酯用阻燃剂的种类、特点 ,阻燃聚酯纤维的生产方法 ,并归纳了国内外主要生产厂家 (公司 )的阻燃聚酯纤维生产工艺特点。概述了目前我国及西欧地区的阻燃法规和标准 ,并对我国阻燃聚酯纤维的发展提出了建议。     

脂肪族聚酯熔点的预估——对D．W．Vankrevelen经验公式的修正

对D．W．Vankrevelen经验公式进行了修正,并对脂肪族聚酯的熔点进行了计算。结果表明,修正后的公式比原公式准确性星著提高,可对脂肪族聚酯熔点进行预估。     

Optimization of the hot alkali treatment of polyester/cotton fabric with sodium hydrosulfite

The treatment of cotton or polyester fabric in alkali media is a common modification process for producing a fabric with desirable qualities. Alkali treatment of polyester/cotton fabric could produce a fabric with better performance. In this research, polyester/cotton fabric was treated with NaOH at different temperatures and times. The results show that alkali treatment at the optimum temperature and time with NaOH could hydrolyze the polyester fiber surface and remove some of the impurities from the cotton fiber at the same time and may also improve some of the fabric properties, such as fabric regain, water drop absorbency, and fabric pilling. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100:5049–5055, 2006     

钛系聚酯催化剂的研究进展

介绍了聚酯催化剂中锑、锗、钛三个系列的各自特点，综述了复合型钛系和超细TiO2型聚酯催化剂的最新进展，认为新型钛系催化剂催化活性更高，更环保，而且用它合成的聚酯产品色相好，热稳定性得到了改善。