Drying Characteristics of Barley Grain Dried in a Spouted-Bed and Combined IR-Convection Dryers

A study was performed to determine the drying characteristics and quality of barley grain dried in a laboratory scale spouted-bed dryer at 30, 35, 40, and 45°C and an inlet air velocity of 23 m/s^-1, and in an IR-convection dryer under an infrared radiation intensity of 0.048, 0.061, 0.073, and 0.107 W cm^-2 at an air velocity of 0.5 m/s^-1. The results show that the first, relatively short, phase of a sharp decrease in the drying rate was followed by the phase of a slow decrease. The time of barley drying depended on temperature of inlet air in a spouted-bed dryer and on radiation intensities in an IR-convection dryer. Barley drying at 45°C in a spouted-bed dryer was accompanied by the lowest total energy consumption. The average specific energy consumption was lower and the average efficiency of drying was higher for drying in a spouted-bed dryer. The effective diffusivities were in the range 2.20-4.52 × 10^-11 m² s^-1 and 3.04-4.79 × 10^-11 m²/s^-1 for barley dried in a spouted-bed and in an IR-convection dryer, respectively. There were no significant differences in kernel germination energy and capacity between the two drying methods tested.     

微絮凝接触过滤处理低浊度含藻水的研究

通过现场试验，对微絮凝过滤处理生活用水所带来的一系列问题进行了详细、科学的分析，在大量试验数据基础上对产生问题的原因进行了研究并取得了初步结论。在此基础上，提出了改进措施，取得了实效。     

DRYING OF GRANULAR PARTICLES IN A MULTISTAGE INCLINED FLUIDIZED BED WITH MECHANICAL VIBRATION

A mathematical model for the drying rate of granular particles in a multistage inclined fluidized bed(IFB) is presented from the standpoint of simultaneous heat and mass transfer, with taking the effect of mechanical vibration added vertically into consideration.

Steady-state distributions for the temperatures and concentrations of the particles and the heating gas, and for the moisture content of the particles are numerically calculated based on the present model. The calculated results show fairly good agreement with the experimental data, which were obtained from the drying experiments of brick particles in a three-stage IFB using comparatively low temperature air(40-60°C) as the heating gas.

It has been found within the range of the experimental conditions employed that, the mechanical vibration added vertically enhances the over-all drying rate of the particles and its effect can be considered equivalent to an increase in the air velocity.     

Energy Saving in Industrial Wood Drying Addressed by a Multiscale Computational Model: Board, Stack, and Kiln

This article proposes a multiscale computational model able to calculate energy consumption in a batch lumber kiln. A dual-scale computational model of wood drying deals with the boards/stack interaction and serves as a basis for the present work. A new module was added here that calculates heat losses through kiln walls (convection, condensation) and the energy used by each kiln component (fans, heating elements, humidifier, vacuum pump, etc.). The corresponding mathematical formulation is presented and then theoretical results are compared to those collected in an industrial vacuum kiln. As application example, the effect of air reversal, air velocity, and kiln insulation are exhibited, which depicts the great potential and prospects of this new tool for energy savings in relation to the product quality.     

Modeling Condensation and Evaporation on Fruit Surface

Rewarming of fruits and vegetables after cooling is characterized by heat and mass transfer processes, which leads commonly to condensation of water on the produce surface at temperatures below the dew point. This effect may affect the produce quality due to microbial growth at unfavorable environmental conditions. The amount of condensed water is a function of the produce surface temperature and of the surrounding conditions as air temperature, air humidity, and air flow. Under practical conditions, both the warming and the condensation are strongly affected by the packaging system used. Depending on the flow conditions close to the produce surface, parameters of heat and mass transfer under laboratory conditions were measured. A mathematical model was developed for the determination of the amount of condensed water on fruit surfaces, its reevaporation, and its total dwell time dependent on the environment air conditions. The model describes the heat and mass transfer processes on single fruits. The process of diffusion of humidity in air and proceed of surface temperature is the basis for the model.     

Atmospheric Freeze Drying—Modeling and Simulation of a Tunnel Dryer

Drying is an important unit operation in processing of foods and other biotechnological products. Vacuum freeze drying is said to be the best drying technology regarding product quality of the end product, but the disadvantages are, among others, expensive operational costs and batch drying. Atmospheric freeze drying was introduced to lower the production costs of high-quality dried foods, and the need of simulation tools became important in estimations of the industrial drying processes.

A simplified mathematical model (AFDsim) is developed based on uniformly retreating ice front (URIF) considerations. The model is used to calculate theoretical drying curves of atmospheric freeze dried foods in a tunnel dryer. Studies of thermal and mass transfer properties during drying are essential for understanding the changes in product quality and for designing and dimensioning the drying process. The model can be used to simulate industrial atmospheric freeze drying of different foodstuff in a tunnel. The results from AFDsim modeling are in good accordance with the experimental results.     

Drying of Probiotics: Optimization of Formulation and Process to Enhance Storage Survival

This work describes how probiotic bacteria can be dried at low temperature in two steps, combining spray drying and vacuum drying, in order to enhance their survival during storage. A sufficient number of dried probiotics survived storage for more than 3 months at 30°C, if an appropriate combination of protein and carbohydrate was selected as carrier and storage conditions were maintained optimal. The use of soy protein and maltodextrin or skim milk and arabic gum resulted in the best survival rates of probiotics during storage. No evident difference was found between different spray dryer configurations, although a cocurrent flow was preferred.     

Effect of processing on in vitro digestibility of protein and starch in quinoa seeds

The in vitro digestibility of protein in raw quinoa assessed by an enzymic method was 78%, significantly ( P > 0.01 ) lower than that of casein, 91%, and also somewhat lower ( P > 0.01) than that of the raw washed quinoa sample, 83%. the process used to remove the outer layers of the seeds containing saponins increased the protein digestibility significantly ( P > 0.01), by 7%. Heat treatments increased protein digestibility over that of raw quinoa samples. Only the cooked sample treated for 60 min presented a slightly lower protein digestibility, 77%, than those obtained for other heat-treated samples.
The temperature, time and moisture used in cooking and autoclaving of whole seeds of quinoa did not improve starch digestibility significantly. the digestibility of the starch in the raw and precooked samples was 72 and 77%, respectively, after drum drying and about 64% after extrusion in both cases. Precooking at 60°C for 20 min does not improve the digestibility of the quinoa starch.     

Effect of Reactor Ambient Pressure on the Morphology of Spray Dried Magnesium Sulphate Powders

The effect of reducing the reactor air pressure on the morphology of spray dried magnesium sulphate powders is investigated, experimentally. A reactor, capable of drying and pyrolyzing solution sprays at low pressures, is designed and manufactured. A vibrating mesh nebulizer is employed to generate the spray. Four different pressures, starting from 60 Torr to the atmospheric pressure, and two different reactor air temperatures of 130°C and 420°C, are considered. In addition, two different concentrations of magnesium sulphate solutions are tested. The results are explained based on the effect of reactor air pressure on the droplet evaporation rate.     

VARIATIONS IN ALFALFA JUICE SOLUTE CONCENTRATIONS AS WATER IS EVAPORATED

Alfalfa juice was extracted from plants during the graving phases of the first and second crops. The alfalfa juice was dried and solute concentrations were measured periodically during the process using freezing point depression (FPD) as an indicator. Solute/solvent weight ratios were calculated from the freezing point depression of fresh unconcentrated 'uice extracted from both firsc and second crops. At the time of harvest, tie FPD was a function of this ratio. The first and second crops behaved distinctively different during the drying process, with the second having a larger soluce concentration and a greater FPD at a given moisture content. The appearance of preci itate during the drying process and the general1 large FPD makes this materiay a questionable product for drying vitg low temperature processes.