Silver electrodeposition from air and water-stable ionic liquid: An environmentally friendly alternative to cyanide baths

The influence of temperature on the kinetics and the morphology of silver deposits obtained from an air and water-stable ionic liquid (the 1-butyl-3-methyl imidazolium tetrafluoroborate) was studied by means of cyclic voltammetry and chronoamperometry. The nucleation and growth mechanisms have been investigated and the effect of temperature evaluated up to 200 °C. Dense, pure and very thin (about 0.3 μm) silver coatings, with decorative properties, have been obtained on commercial copper electrodes at different temperatures. The characterization of the deposits morphology has been performed by visual investigation and SEM microscopy. Data about thickness were acquired by Calotest® measurements. The deposits result constituted by pure silver as determined by combination of EDX microanalysis and Auger Electron Spectroscopy (AES). The deposition method promises to be a new, environmentally friendly, method for silver electrodeposition which is the reason for the absence of cyanide and volatile toxic solvents in the electroplating bath.     

微重力落塔电磁悬吊、释放技术研究

论述了微重力落塔电磁悬吊、释放、提升机构的关键技术,电磁释放过程的特性分析以及微重力落塔实际试验的情况。分析说明:悬吊、释放性能的好坏决定了试验落舱的微重力水平,也是微重力落塔试验能否成功的关键技术。     

Studies on Catalytic Side-Chain Oxidation of Nitroaromatics to Aldehydes with Oxygen

The side-chain oxidation of 2-nitrotoluene in liquid phase in the presence of catalytic amount of manganese sulfate and stoichiometric amount of potassium hydroxide with oxygen was studied. In the most favorable conditions, over 80% of conversion of 2-nitrotoluene and 50% of selectivity to 2-nitrobenzaldehyde was achieved. Effects of the reaction parameters on the conversion of the reactant and the selectivity of the product were examined. These results, together with EPR spectroscopic study, show that a benzyl anion was formed in the early stage of the reaction, which was then converted to the final product via a free radical mechanism.     

NdBO_3和 Nd(BO_2)_3的标准生成自由能

用 CaF_2单晶和 ZrO_2(+MgO)为固体电解质分别构成原电池:■和 Pt,B_((s)),NdBO_(3(s)),Nd(BO_2)_(3(s))|ZrO_2|Cr_2O_(3(s)),Cr_((s)),Pt联合测了 NdBO_3和 Nd(BO_2)_3的标准生成自由能:ΔG~0_(NdBO_3)=-1757+3.8×10~(-1)TΔG~0_(Nd)(BO_2)_3=-3435+8.8×10~(-1)T由此求出由氧化物生成 NdBO_3及 Nd((BO_2)_3)的反应的标准生成自由能变化:1/2Nd_2O_(3(s))+1/2B_2O_(3■)=NdBO_(3(s))ΔG~0_(NdBO_3)=-242+1.4×10~(-1)T和 1/2Nd_2O_(3(s))+3/2B_2O_(3(s))=Nd(BO_2)_(3■)ΔG~0′_(NdBO_2)3=-693+4.6×10~(-1)T     

Implicit integration and consistent tangent modulus of a time‐dependent non‐unified constitutive model

This paper describes the implicit integration and consistent tangent modulus of an inelastic constitutive model with transient and steady strain rates, both of which are time‐ and temperature‐dependent; the transient rate is influenced by the evolution of back stress decomposed into parts, while the steady rate depends only on applied stress and temperature. Such a non‐unified model is useful for high‐temperature structural analysis and is practical owing to the ease in determining material constants. The implicit integration is shown to result in two scalar‐valued coupled equations, and the consistent tangent modulus is derived in a quite versatile form by introducing a set of fourth‐rank constitutive parameters into the discretized evolution rule of back stress. The constitutive model is, then, implemented in a finite element program and applied to a lead‐free solder joint analysis. It is demonstrated that the implicit integration is very accurate if the multilinear kinematic hardening model of Ohno and Wang is employed, and that the consistent tangent modulus certainly affords quadratic convergence to the Newton–Raphson iteration in solving nodal force equilibrium equations. Copyright © 2003 John Wiley & Sons, Ltd.     

喇曼自由电子激光器辐射谱的测量

本文报道了利用微波栅摄谱仪测量在超辐射工作条件下的喇曼自由电子激光器辐射谱的初步结果。观察到了毫米波自由电子激光器的调谐特性。实验结果表明,辐射谱的中心频率随波荡场强度的增加而减小,这与考虑波导模影响的集体制式自由电子激光的有关理论预言相符。     

Tannins/melamine–urea–formaldehyde (MUF) resins substitution of chrome in leather and its characterization by thermomechanical analysis

A new sulfonated melamine–urea–formaldehyde (MUF) resin of relatively low melamine content, prepared according to a sequential formulation, has been shown to be highly effective when coupled with different natural vegetable tannins to produce leather with the same good characteristics of leather prepared with chrome salts. In particular, the antishrinkage effectiveness of the leather prepared according to the new approach is comparable to that obtained with chrome tanned leathers. The comparison of the traditional leather shrinkage temperatures test method with a new thermomechanical analysis (TMA) test method in tension yields thermograms presenting three major modulus of elasticity (MOE) peaks. These are closely connected to molecular level phenomena determining the shrinkage temperature of leather. The three determining parameters appear to be as follows: (1) The average value of the temperatures at which the three MOE peaks occur: the higher the value of this average, the lower is the shrinkage of leather. (2) The average of maximum MOE values of the TMA peaks: the higher this average is, the better is the leather in regard to antishrinkage effectiveness. This means the leather maximum MOE at each peak is a measure of the resistance to the contraction force induced by heat. (3) The relative intensity of the first TMA peak in relation to the second: the higher the value of the MOE for the first TMA peak is in relation to the second peak, the lower the leather shrinkage appears to be. However, it has not been possible to better define or quantify this latter effect. This new TMA test method in tension has also yielded a mathematical relationship correlating the thermogram peak temperatures and MOE averages with the traditional shrinkage temperature to a high degree of confidence. A previous TMA test method, in compression, has proven to yield more problematic and finally not very reliable results when one needs to apply it to a wide variety of different cases. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 1889–1903, 2003     

自由锻锤上冷冲厚板新工艺

介绍了自由锻锤上冷冲厚板工艺的特点和模具主要结构。以及如何解决凸凹模间隙、选用小间隙冲孔时刃口磨损加剧的问题。研制出了降低磨损。提高模具寿命的润滑剂配方。设计了适合自由锻锤上厚板冲孔的模具，对在自由锻锤上厚板冲孔进行了有益的尝试。扩大了自由锻设备的加工范围。解决了不具备大型压力机情形下的生产难题。     

The analysis of solvation in ionic liquids and organic solvents using the Abraham linear free energy relationship

The contentions made in an earlier paper [J Chem Technol Biotechnol 80 : 133–137 (2005)] that the coefficients of the Abraham solvation equation do not provide meaningful information on the molecular properties of ionic liquid solvents is refuted. The objections noted in the earlier paper disappear when the solvation equation model is correctly applied to the experimental data. It is further shown that the coefficients of the Abraham solvation equations can be used to characterize ionic liquids and can be used to select solvents for the solubility of gaseous solutes. Copyright © 2006 Society of Chemical Industry     

Binding, relational memory, and recall of naturalistic events: A developmental perspective.

This research was an investigation of children's performance on a task that requires memory binding. In Experiments 1 and 2, 4-year-olds, 6-year-olds, and adults viewed complex pictures and were tested on memory for isolated parts in the pictures and on the part combinations (combination condition). The results suggested improvement in memory for the combinations between the ages of 4 and 6 years but not in memory for the isolated parts. In Experiments 2 and 3, the authors also examined the developmental relationship between performance in the combination condition and free recall of a naturalistic event, finding preliminary evidence that performance on a memory task that requires binding is positively related to performance in episodic memory. (PsycINFO Database Record (c) 2010 APA, all rights reserved)