A novel compact circuit for 4-PAM energy-efficient high speed interconnect data transmission and reception

Transmission of signals, whether on-chip or off-chip, places severe constraints on timing and extracts a large price in energy. New silicon device technologies, such as back-plane CMOS, provide a programmable and adaptable threshold voltage as an additional tool that can be used for low power design. We show that one particularly desirable use of this freedom is energy-efficient high-speed transmission across long interconnects using multi-valued encoding. Our multi-valued CMOS circuits take advantage of the threshold voltage control of the transistors, by using the signal-voltage-to-threshold-voltage span, in order to make area-efficient implementations of 4-PAM (pulse amplitude modulation) transceivers operating at high speed. In a comparison of a variety of published technologies, for signal transmission with interconnects of 10-15 mm length, we show up to 50% improvement in energy for on-chip signal transmission over binary encoding together with higher limits for operating speeds without a penalty in circuit noise margin.     

基于PMM8731和SI-7300的步进电机驱动电路

PMM8731是日本三洋电机公司生产的步进电机脉冲分配器。而SI-7300则是日本三青公司生产的高性能步进电机集成功率放大器。它们和单片机一起可构成一种高效电机控制驱动电路。文中介绍了PMM8713与SI-7300的功能 ,给出了由它们组成的功率驱动电路及其在步进电机上的应用方法     

探讨电石法PVC烟气治理方法

分析了电石法PVC生产链中电石炉烟气及电厂烟气二氧化硫的排放情况,指出利用电石炉烟气中的CO合成氨、再将合成氨用于燃煤电厂烟气的"氨法"脱硫是具有较大应用潜力的循环经济产业链。     

Heat Transfer Analysis for Gas-to-Liquids Transportation Through Trans Alaska Pipeline

Gas-to-liquids (GTL) technology involves the conversion of natural gas to liquid hydrocarbons. In this article, theoretical studies have been presented to determine the feasibility of transporting GTL products through the Trans-Alaska Pipeline System (TAPS). To successfully transport GTL through TAPS, heat loss along the route must be carefully determined. This study presents heat transfer and fluid dynamic calculations to evaluate this feasibility. Because of heat loss, the fluid temperature decreases in the direction of flow and this affects the fluid properties, which in turn influence convection coefficient and pumping power requirements. The temperature and heat loss distribution along the pipeline at different locations have been calculated. Fairly good agreement with measured oil temperatures is observed. The powers required to pump crude oil and GTL individually, against various losses have been calculated. Two GTL transportation modes have been considered; one as a pure stream of GTL and the second as a commingled mixture with crude oil. These results show that the pumping power and heat loss for GTL are less than that of the crude oil for the same volumetric flow rate. Therefore, GTL can be transported through TAPS using existing equipment at pump stations.     

电力负荷削峰减载系统在珠钢电炉的应用

借助现场采集装置,在计算机上获取每一分钟的冶炼工艺电能需求量,显示当前15分钟时段已发生的电耗量,调整用户设定,实现需量自动刷新、报警和专家分析推荐后续用量;实现平稳用电并减少对电网冲击,同时降低电能最大需用量以减少成本。     

The Minimum PAPR Code for OFDM Systems

In this letter, a block code that minimizes the peak‐to‐average power ratio (PAPR) of orthogonal frequency division multiplexing (OFDM) signals is proposed. It is shown that peak envelope power is invariant to cyclic shift and codeword inversion. The systematic encoding rule for the proposed code is composed of searching for a seed codeword, shifting the register elements, and determining codeword inversion. This eliminates the look‐up table for one‐to‐one correspondence between the source and the coded data. Computer simulation confirms that OFDM systems with the proposed code always have the minimum PAPR.     

Carbon nanofibers as hydrogen adsorbing materials for power sources

Porous carbon nanofibers are synthesized by CVD method from acetylene with use of iron-containing catalysts. Activation of the nanofibers in melted potassium hydroxide results in increasing surface area from initial 300–400 m² g⁻¹ to 1700 m² g⁻¹. As follows from XRD data, activated nanofibers do not contain regular packages of graphene layers, but retain high electric conductivity. Deposition of copper improves electrochemical hydrogen storing characteristics of carbon nanofibers. Carbon nanomaterials obtained can be used as hydrogen storing materials in batteries instead of hydride forming metals.     

32位MIPS微处理器中乘法器的设计和实现

在Booth算法的基础上,结合MIPS 4KC微处理器中的流水线结构和乘法器的工作过程,提出了一种改进的Booth乘法器的设计方法,并采用全制定方法实现,用这种方法实现的乘法器单元具有面积小、单元电路可重复性好、版图设计工作量小、功耗低等特点.     

CDMA系统中联合功率控制、波束赋形与多用户检测

应用功率控制、波束赋形和多用户检测可以有效地消除和减少CDMA系统中的干扰。本文结合波束赋形和多用户检测的特性，提出一种应用波束赋形增益和多用户相关矩阵的解相关算法。基于算法的复杂性，提出一种区分聚集用户进行多用户检测的的算法。由于波束赋形能够消减主瓣波束之外的多用户干扰，对聚集移动台采用解相关检测达到减少运算量和消除多用户干扰的目的。对算法进行了仿真分析，证明了本算法的优越性。     

SIMADYN D控制器在武钢热轧动态无功补偿系统中的应用

SIMADYN D控制器应用于动态无功补偿，标志武钢动态无功补偿控制实现数字化突破。提高了系统的可靠性、调节精度和动态指标。