Effect of cationic surfactant and inorganic anions on the electrochemical behavior of carbon steel in formation water

Corrosion behavior of carbon steel in formation water associated crude oil from Egyptian western desert was studied at various concentrations of dodecyl dimethyl ammonium chloride (CS) as a cationic surfactant. Polarization curves indicate that CS has a good inhibition efficiency for carbon steel in formation water and behaves as cathodic inhibitor. The inhibition efficiency was found to increase with increase in CS concentration until reaches a maximum constant value corresponding to the critical micelle concentration of CS and decrease with increase in solution temperature. The adsorption of CS follows the kinetic thermodynamic model and Flory-Huggins isotherm. Thermodynamic parameters obtained indicate that that the presence of the CS increases the activation energy. Polarization and Impedance measurements indicate that the addition of KI has a significant synergistic effect with CS and results in increase the inhibition efficiency of CS in formation water.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

Growth and optical property of zinc oxide thornballs

A new microstructure, thornball, of zinc oxide (ZnO) was synthesized by a very simple solid vapor deposition process under lead oxide (PbO) atmosphere. The microthornballs consist of numerous needles, which extend outwards in all directions symmetrically. They have dimensions of 120 μm in diameter, while the average diameter of the needles is about 100-200 nm. The needles on the balls grow along the 〈0 0 0 1〉 orientation and have gradient compositions along radial. Control experiments proved that PbO played an important role in the growth. Additionally, photoluminescence property was observed and provided the evidence that PbO did not deteriorate the optical properties of ZnO thornballs. This kind of microstructures has potential applications in the field of photochemical catalysis.     

降低氧化铝生产中熟料折合比的探讨

在氧化铝生产过程中，熟料折合比是烧结法一项重要的综合性指标，本文通过对熟料折合比的定义、计算公式的剖析，分析了生产过程中影响熟料折合比的主要因素，对有效降低熟料折合比的措施进行了探讨。     

Pressure infiltration of boron nitride preforms with molten aluminum

The infiltration of compacted cubic BN (cBN) with molten aluminum has been investigated as a potential route for a cheap and easy method of manufacturing cBN/metal composites. CBN compacts have been infiltrated with molten Al at a temperature between 670 and 800 °C and pressure of 15 MPa in vacuum. At these temperatures no pronounced interactions between hexagonal and cubic BN with Al was observed, allowing the complete infiltration of cBN with 12 μm mean grain size. After infiltration at 800 °C, the temperature was increased without pressure to convert aluminum into borides and AlN. The hardness of the resulting materials depends on the content of hexagonal, cubic BN and the rate of conversion of Al into borides and AlN. The infiltration height of less than 1 mm obtained from infiltrating the 3 μm cBN powder green compacts gave a hardness of 22.0 ± 0.6 GPa after heat treatment.     

Behaviour of ±45° glass/epoxy filament wound composite tubes under quasi-static equal biaxial tension–compression loading: experimental results

The primary aim of this paper is to present results describing in detail the behaviour of ±45° E-glass/MY750 (GRP) tubes, of various wall thicknesses, subjected to equal biaxial tension–compression loading, generated under combined internal pressure and axial compression. The role played by the non-linear lamina shear has also been assessed by comparing various shear stress–strain curves for embedded laminae (extracted from tests on ±45° tubes subjected to circumferential: axial stress ratios SR=1:0, 1:−1 and 2.3:−1) with that of an ‘isolated’ lamina (measured from torsion of 90° tubes). Extracted shear failure strains, for embedded laminae, were more than four fold larger than those measured at ultimate failure for an ‘isolated’ lamina. Soft characteristics were observed in the embedded lamina and these were believed to be due to interaction between early matrix damage initiation (and propagation) and shear. Factors affecting the behaviour of the tubes, such as bulging, scissoring, thermal stresses and stress variation through the thickness are discussed.     

Gold Medal Award for Life Achievement in the Application of Psychology: Edwin A. Fleishman.

The 2004 Gold Medal Award for Life Achievement in the Application of Psychology was awarded to Edwin A. Fleishman, for his significant contributions to the science and applications of psychology, which he has sustained over his remarkable career. He is cited for his research, which has had a profound influence on our understanding of human capabilities, their measurement, their development, and their application in the world of work. Through his many influential leadership roles, as president of the International Association of Applied Psychology and three divisions of the American Psychological Association, and as editor of the Journal of Applied Psychology, he has helped shape our profession. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

微区电阻测试方法及新测试仪研制

文章对国内外开展微区薄层电阻测试的方法进行了综述，特别对改进范德堡四探针技术方法的测试原理、测试过程与测试结果进行了论述与分析，对微区电阻测试方法的进一步发展提出了一种可操作的方法，并研制出新型四探针测试样机。     

Substituted uracils as corrosion inhibitors for copper in 3% NaCl solution

Substituted uracils were tested as corrosion inhibitors of copper in 3% NaCl medium using electrochemical polarisation, impedance measurements and non-electrochemical techniques (weight loss, IR and UV-visible). This study permitted to follow the evolution of the inhibitory effect of the uracil derivatives, according to their substituents, on copper in 3% NaCl medium. Comparison of results showed that dithiouracil (DTUr) was the best inhibitor. The maximum inhibition efficiency reached 98% at 10⁻³ M. DTUr adsorbs on the copper surface according to the Frumkin isotherm model.     

Action of chelators on solid iron in phosphate-containing aqueous solutions

To study the effect of strong iron-ligands on steel corrosion, mild steel electrodes were immersed in solutions containing 20 mM phosphate buffer (pH=7.2) and between 0.01 mM and 1 M of either the iron(II)-chelators 2,2^′-bipyridine or FerroZine, or the iron(III)-chelators citrate or acetylacetonate. Resulting surface reactions were investigated by quantifying the electrochemical potential (E), the electrochemical polarization resistance (R_p), the corrosion current (I_corr) and the release of iron into solution. The surface was further analyzed by scanning electron microscopy (SEM/SEM-EDAX) and atomic force microscopy. Concentrations of 0.1 mM of any of the chelators led to slight, temporary changes in E, I_corr and R_p. Concentrations of 10 mM resulted in characteristic changes of E, which were the same for all chelators and in the precipitation of FePO₄ in the case of citrate and acetylacetonate, or vivianite [Fe₃(PO₄)₂ · 8H₂O] in the case of bipyridine and FerroZine. Concentrations of 1 mM of both iron(III)-chelators led to a temporary drop of E similar to that found with 0.1 mM chelator. With iron(II)-chelators, E dropped to about −500 mV before oscillating for several days. The amplitudes of the oscillations were up to 200 mV with periods of 30 and 20-25 min for bipyridine and FerroZine, respectively.