湿法磷酸过滤设备和管道结垢原因分析及控制研究

分析湿法磷酸过滤设备与管道结垢的主要原因是氟硅酸钾、钠盐因磷酸液相温度下降而沉积下来。提出采用添加剂,抑制或提前析出氟硅酸钾、钠盐,同时进行了5种添加剂的实验室研究:均有较好的阻垢效果,但最终选择添加剂E(氟硅酸),阻垢率可达70%以上,添加量以0.5g/100g磷矿为宜。     

结晶法净化湿法磷酸生产磷酸二氢钾研究

研究了三聚氰胺结晶法净化湿法磷酸复分解生产精细磷酸二氢钾工艺中磷酸三聚氰胺与氯化钾反应生产磷酸二氢钾的工艺条件。采用二次正交组合实验设计，对反应过程中反应温度，反应时间，搅拌速度，氯化钾用量，氯化钾初始浓度等诸因素的一次作用，二次作用及交互作用对五氧化二磷转化率的影响进行了研究，得到了适宜的工艺条件，所得磷酸二氢钾达到HG2321－91质量标准。     

红河州磷肥厂6万t／a半水－二水法磷酸装置试生产情况

主要介绍了红河州磷肥厂引进的６万ｔ／ａ半水一二水法磷酸生产技术及三年来该装置的试生产情况，着重介绍了针对试生产中存在问题进行的技术改造。现该套装置运行正常，生产指标已接近设计值。     

由二氧化碳出发合成有机碳酸酯

对以二氧化碳为原料合成有机碳酸酯的环氧路线、酯交换和直接合成方法作了综合评述 ,认为直接合成是最佳的合成路线。碳酸酯的直接合成可在均相及多相催化体系中进行 ,负载金属、金属甲氧基化合物及碱均可作为催化剂。直接法研究的关键在于高性能催化剂的开发、由二氧化碳对金属 -氧键插入反应导致的催化循环的构筑及耦合反应的应用。     

Electrochemical pitting behaviour of type 321 stainless steel in sulfide-containing chloride solutions

The pitting behaviour of type 321 stainless steel in sulfide-containing chloride aqueous environments was studied using cyclic potentiodynamic polarization. A well-established correlation between H₂S and Na₂S₂O₃ in the study of corrosion was applied, that is, H₂S was simulated by Na₂S₂O₃. The major factors affecting the pitting corrosion of type 321 stainless steel are the Cl^- concentration, solution pH and temperature. The results clearly indicate that both E_pit and E _pp decrease with increasing Cl^- concentration and temperature, while I _pass is more sensitive to temperature variation. E _pit decreased with decreasing pH in the range 2 < pH < 7.5. The surface morphology and chemistry of the corroded type 321 stainless steel resulting from anodic polarization in 0.01 M S₂O ₃ ^2- -containing Cl^- solution were analysed by XRD, SEM and EPMA. A higher concentration of sulfur was found in the pits, and the dark surface film was mainly composed of FeS and -Fe₂O₃. The results describe the pitting behaviour of type 321 stainless steel in sulfide-containing Cl^- aqueous environments.     

湿法磷酸生产装置衬胶防腐技术及胶板的选用

介绍衬胶防腐在湿法磷酸生产中的应用 ,特别是真空设备设计衬胶防腐的要点以及目前我国湿法磷酸装置中国产 (含合资、独资企业 )胶板的特点和选用、施工中应注意的事项。     

Direct ethoxylation of fatty methyl ester over Al-Mg composite oxide catalyst

For the purpose of estimating the reaction mechanism of the direct ethoxylation of a fatty ester in the presence of an Al-Mg composite oxide catalyst, a labeled fatty methyl ester C₁₁H₂₃CO¹⁸OCH₃ containing ¹⁸O isotope was synthesized and directly ethoxylated. The product was evaluated by gas chromatography-mass spectrometry (GC-MS). The GC-MS spectra showed that the ¹⁸O isotope label was present only in the methoxy group at the molecular end of the ethoxylated fatty methyl ester. This supports the reaction mechanism of coordination anionic polymerization where the bond between the acyl and methoxy groups of the fatty methyl ester molecule was broken, caused by the bifunctional effect of the acid-base active sites; an intermediate chemisorption species was formed; and then ethylene oxide was addition-polymerized sequentially, in parallel.     

A/O结合循环式活性污泥法处理海产品加工废水

针对海产品加工废水氨氮含量较高的特点。舟山兴业有限公司的污水处理工程采用两段A/O结合循环式活性污泥法工艺，工程验收合格后运行一年多来，排放废水的各项污染指标均达到国家《污水综合排放标准》（GB8978-1996）的二级标准，处理系统具有很好的抗冲击能力和脱氮效果。     

Surface modification of a biomedical poly(ester)urethane by several low‐powered gas plasmas

Several low‐powered gas plasmas were employed to treat a biomedical poly(ester)urethane using the treatment gases of CO₂, O₂, NH₃, and SO₂ with different treatment time (2, 5, 10, and 15 min). The changes of the physical and chemical characteristics of the biopolymer surface were studied. Surface morphology was evaluated by scanning probe microscopy, which showed increased roughness of the surface after plasma treatment. The wettability of the surface was examined by static water contact angle (SCA) measurements, which presented that there was a decrease of SCA in all plasma treatments compared with the untreated surface and that each gas plasma had an optimum treatment time accompanied by a minimum contact angle. X‐ray photoelectron spectroscopy indicated the changes of the surface functional groups. The data demonstrated that CO₂ and O₂ plasmas resulted in the incorporation of oxygen‐containing groups, while NH₃ plasma resulted in the combination of nitrogen‐containing groups, and SO₂ plasma resulted in the formation of sulfur‐containing groups. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 101: 1273–1282, 2006     

热法磷酸的发展趋势与研究方向

简述了工业制磷酸的生产方法和热法磷酸生产工艺的发展,分析了热法磷酸今后的发展方向,提出了热法磷酸燃烧塔结膜物的研究课题。