网络分解法的误差分析

网络分解法是求解电大尺寸复杂结构电磁问题的重要方法之一,关于网络分解法误差分析的研究有着重要的理论意义和实用价值.本文给出了网络分解法的误差估计,并对于脉冲基函数转换成三角基函数的情况给出了三角基函数个数的最优公式,数值结果表明了分析的正确性.     

Partial scan design and test sequence generation based on reduced scan shift method

This paper presents a partial scan algorithm, calledPARES (PartialscanAlgorithm based onREduced Scan shift), for designing partial scan circuits. PARES is based on the reduced scan shift that has been previously proposed for generating short test sequences for full scan circuits. In the reduced scan shift method, one determines proch FFs must be controlled and observed for each test vector. According to the results of similar analysis, PARES selects these FFs that must be controlled or observed for a large number of test vectors, as scanned FFs. Short test sequences are generated by reducing scan shift operations using a static test compaction method. To minimize the loss of fault coverage, the order of test vectors is so determined that the unscanned FFs are in the state required by the next test vector. If there are any faults undetected yet by a test sequence derived from the test vectors, then PARES uses a sequential circuit test generator to detect the faults. Experimental results for ISCAS'89 benchmark circuits are given to demonstrate the effectiveness of PARES.     

用于X光激光实验的反射式线聚焦光学系统的设计和分析

基于三维光线追迹的象差计算,对卢瑟福实验室用离轴球面反射线聚焦系统作了分析。然后,首次提出了用于X光激光实验的两类新的反射式线聚焦构型,即反射式光楔列阵和光锥列阵系统,并作了计算。最后,对所得结果作了比较和讨论。     

Cost-effective smart power CMOS/DMOS technology: design methodology for latch-up immunity

To answer to the need of a cost effective smart power technology, an original design methodology that permits implementing latch-up free smart power circuits on a very simple CMOS/DMOS technology is proposed. The basic concept used to this purpose is letting float the wells of the MOS transistors most susceptible to initiate latch-up. The efficiency of the design methodology is experimentally shown.     

集群移动通信系统的组网设计

本文对集群移动通信系统在组网设计时应考虑的问题进行了分析，并提出了具体步骤和方法，可供集群系统组网设计时参考。     

锥形有源条半导体光放大器增益和饱和特性分析

以行波半导体光放大器速度方程为基础，采用传输矩阵方法，对锥形结构半导体光放大器的增益和饱和特性进行理论研究。讨论了不同锥形长度，不同结构时的增益和饱和特性差异。理论研究表明，锥形结构能改善半导体光放大器的偏振灵敏度。在同一锥度下，长锥形长度能提高饱和增益，降低偏振度。在进行半导体光放大器有源条结构设计时要综合考虑锥度及锥形长度的影响，以实现结构优化 。     

无源微波遥感用于地震预报的实验研究

对无源微波遥感用于地震预报在理论研究的基础上对不同岩性不同结构的岩石试件进行了加载实验，测量了岩石试件的微波辐射随载荷的变化．实验得出：岩石试件的微波辐射能量随岩石应力状态变化而显著变化；而且，不同的波段变化的幅度不同；同一波段不同极化方式的波随应力变化的变化量也不同；微波辐射能量的变化能够被卫星微波遥感探测器探测到．实验还发现，岩石试件临破裂前出现明显的微波辐射异常．     

Standard reference materials for cements

The eight portland cements and two calcium aluminate cements in the Standard Reference Material (SRM) 1880 series are among the most popular SRMs in the catalog of the National Institute of Standards and Technology (NIST) Standard Reference Materials Program. Numerous laboratories rely on them for elemental analysis and qualification for ASTM C 114-00 Standard Test Methods for Chemical Analysis of Hydraulic Cement. NIST has collected new candidate materials from around the world and partnered with Construction Technology Laboratories (CTL) in their preparation and certification. This paper describes the procedures taken at NIST and CTL to prepare and test materials for certification including the homogeneity testing, the X-ray fluorescence methods and the statistical data analysis performed for value assignment.     

油田开发经济运行质量研究与应用

提出了油田开发经济运行质量的研究方法和技术思路。对胜利油区几种典型的油藏类型进行了经济运行质量评价。以老河口油田桩106块为例，提出了提高油田经济运行质量的三条基本途径，取得了较好的实际应用效果。