HART协议物理层设备的测试（II）

本文介绍HART协议物理层设备的测试要求、测试设备、测试方法及测试时的一些特别说明。     

W‐band physical layer design issues in the context of the DAVID–DCE experiment

This paper aims at focusing on the aspects concerning the physical layer design for an innovative satellite communication experiment. Such an experiment, denoted by the acronym DAVID–DCE (Data and Video Interactive Distribution—Data Collection Experiment) is based on the exploitation of the W‐band (75–110 GHz) for high‐bit‐rate satellite transmission. The potential advantages of using of the W‐band are mainly related to the great bandwidth availability, and to the absence of interference. Moreover, an expected result of the experiment is a substantive improvement in the communication system's performances in the presence of meteorological phenomena (e.g. rain) as compared with the more conventional Ka‐band satellite transmission. On the other hand, problems to be faced concern the non‐ideal behaviours of hardware devices employed for high‐frequency digital transmission. In particular, carrier recovery and timing recovery are the most crucial signal‐processing tasks to be carefully considered in the design of the physical level of the system, because they considerably suffer from hardware impairments. The purpose of this work is to illustrate the proposed solutions in terms of the most critical modulation, demodulation and synchronization design issues, together with the effects of non‐ideal behaviours of hardware components on BER performances. Copyright © 2004 John Wiley & Sons, Ltd.     

自适应RBF神经网络在CDMA移动通信上行链路功率控制中的应用研究

提出了一种自适应RBF神经网络功率控制方案。详细研究了该网络在DS-CDMA通信中，进行上行链路闭环功率控制(基于信扰比(SIR))的应用理论，给出了该网络参数的计算方法。最后用计算机仿真法模拟出该控制器的运行性能。结果表明基于SIR的自适应RBF神经网络功率控制器能自适应地调整移动台的发射功率，使基站接收信号的信扰比始终非常接近于一个常数，且有比定步长功率控制更小的SIR跟踪误差，从而可以降低接收信号的中断概率、提高信道容量。     

Optical and structural properties of MOVPE grown GaxIn1−xAs/InP strained multiple quantum well atructures

This paper presents a study of the structural and optical properties of strained GaInAs/ InP multiple quantum well (MQW) structures fabricated by LP-MOVPE. The composition of the Ga _x In_1−x As films ranged fromx = 0.17 tox = 1.0 and was determined by sputtered neutral mass spectrometry (SNMS) on thick layers. The structures of the MQW samples with well widths from 1.5 to 5 nm were investigated by high resolution x-ray diffraction (HR-XRD). Simulations of the diffraction patterns showed that transition layers of approximately 2 monolayer (ML) thickness with high lattice mismatch exist at the interfaces. Photoluminescence (PL) measurements indicate well widths of a multiple of a monolayer with local variations of one monolayer. The PL peak energies vary smoothly with the Ga concentration. These results were confirmed by optical absorption measurements.     

在建坝体中部分浆砌石的控制爆破拆除

某在建大坝部分浆砌石坝体因质量不合格须爆破拆除。保护余留坝体免受爆破影响是此工程的重点,为此,采用了小直径浅孔和微差爆破分层拆除方法,被拆除部分和被保护部分之间预留保护层。爆破施工过程中,利用超声波观测法和压水试验法判断被保护坝体是否受到了爆破震动的影响。根据判断结果,调整爆破参数,以减小爆破震动。文中论述了爆破参数的选择、保护层厚度的确定,同时介绍了安全控制技术、测点布置以及监测结果。     

聚氨酯干法涂层的应用

介绍了涂层织物的特点及聚氨酯在涂层整理中的作用,并对干法直接涂层工艺进行了探讨.     

主动约束层阻尼板结构动力学建模研究

将有限元法和GHM法相结合，给出了建立主动约束层阻尼（ACLD）板结构动力学模型的新方法。建模时，考虑到粘弹材料（VEM）的纵向位移影响，采用GHM方法描述VEM的本构关系，解决了VEM的力学特性随温度和频率变化的难点，避免因VEM的复杂本构关系而产生的微分积分方程。算例表明本文给出的建模方法是准确的，ACLD结构能够有效控制结构振动。     

烷基烷氧基硅烷的合成方法及其在涂料中的应用

介绍了烷基烷氧基硅烷的合成方法(包括烷基的引入方法和烷氧基的形成方法)、近几年来在涂料中的应用及其结构与性能的关系。     

挡土墙填土曲线破裂面的地震主动土压力分析

在地震作用影响下，墙后填土处于极限平衡状态时，假定破裂面为一条通过墙趾的旋轮线。从墙后土楔中取出一微薄水平层，研究其在水平惯性力下的平衡，得到的地震土压力分布和土压力合力作用点位置均与实验结果相吻合。