CFRP强度复合Weibull分布的物理特征分析

本文对ＣＦＲＰ材料疲劳后剩余强度的复合Ｗｅｉｂｕｌｌ分布的物理特征进行了初步分析。指出树脂基复合材料失效（破坏）机理的双重性（基体和纤维失效模型）决定了剩余强度（累积损伤程度）测试结果的分布特征。复合Ｗｅｉｂｕｌｌ分布曲线的特征与分析结果对设计、使用及材料研究都有重要参考意义。     

核测井仪器中的磁屏蔽研究

核测井仪器受套管剩磁的影响比较严重，常常用在探测器的周围缠绕多层坡莫合金带的方法进行磁屏蔽，由于缠绕的坡莫合金圆筒不能闭合，加上缠绕过程中坡莫合金带的形变造成材料本身磁导率的下降，传统的磁屏蔽方法的效果不好。本文介绍一种简单易行、磁屏蔽效果较好的方法，实验的结果说明用电工纯铁做探测器的外壳可以达到令人满意的效果。     

AHMED experiments on hygroscopic and inert aerosol behaviour in LWR containment conditions: experimental results

Hygroscopic NaOH, CsI, CsOH and inert Ag aerosol behaviour at different temperatures and relative humidities (RH) has been studied in a well instrumented and controlled vessel of 1.81 m³ total free volume. Homogeneous thermal-hydraulic conditions for aerosol measurement in the vessel were achieved. The aerosol number and mass concentration were measured continuously during the experiments using a Condensation Nucleus Counter and a Tapered Element Oscillating Microbalance. The particle size distribution and chemical composition in the test conditions were measured by Berner low pressure impactors. In the case of NaOH the half life of the aerosol mass concentration was more than four times longer at low RH (22%) as compared to high RH (96%). The half lives of the CsOH and CsI aerosols were only twice as long at low RH as compared to high RH. Thus at high RH (96–97%) the half lives of CsOH and CsI were twice as long as the half life for the NaOH aerosol. The faster decay of the NaOH aerosol is due to the smaller density decrease of NaOH during water condensation. CsOH particles grew rapidly to their equilibrium size at all humidities. The measured equilibrium size for CsOH aerosol agree well with the calculated particle size at different RHs. Experimental results were also compared with calculations obtained by severe accident computer codes. These calculated results will be presented in a later paper.     

矿化剂对氧化铬绿色釉呈色性能的影响

针对氧化铬绿色釉存在色调暗不够鲜艳的缺点，研究了矿化剂对其呈色性能的影响，经分光光度分析的扫描电镜测试，表明矿化剂具有一定的助熔作用和还原性，从而提高了氧化铬绿色釉的鲜艳度和着色力，增强了装饰性，同时矿化剂还能降低烧成温度，节约能源，具有应用价值。     

Some factors affecting the electrical properties of carbon-black-loaded butyl rubber during vulcanization

Butyl rubber mixtures loaded with 70 phr general purpose furnace black (GPF) and tetramethyl thiuram disulphide (TMTD)/S as vulcanizing system were prepared. The kinetics of their electrical conductivity development during the vulcanization process were followed by using an especially devised system. It was found that the increase in the electrical conductivity during vulcanization obeys an exponential growth function with time constant τ, which markedly decreases with increasing vulcanization temperature as well as with the efficiency of the vulcanizing system. After completion of the vulcanization process, about 80 min, the samples obtained possess reasonable stability and reproducibility of electrical conductivity.     

直流电动机参数测定

根据直流电机的可逆原理并利用常规的实验仪表，可以简便、准确地测出直流电动机的主要参数－电磁转矩、输出转矩和效率．     

单轴-平面W型复合锶铁氧体的制备及其吸波特性研究

用草酸盐共沉淀和微量掺杂法研制六角晶系W型Ni,Zn,Co,Al多元复合锶铁氧体，通过调节Ni2W同Co2W的摩尔比例，可使该种铁氧体易磁化方向从C单轴型向垂于C轴的平面型转化，控制置换锶铁氧体中部分Fe3 的微量掺杂Al3 ，可以调整4πMs值，提高磁晶各向异性场，测试分析了5种不同含Co量的W型复合锶铁氧体粉料涂层的吸波特性，发现其自然共振吸收峰随Co含量增加向低频方向偏移，最高吸收峰可达32．8dB，是适用于电子隐形技术的高品位的微波吸收剂。     

添加剂对尖晶石型锰酸锂性质表征的影响

以LiOH·H_20和MnO_2为原料,分别掺入H_2BO_3、Al_2O_3、SiO_2和P_2O_5等添加剂,用固相分段法制备尖晶石型锰酸锂。结果表明,SiO_2和P_2O_5可以有效地改善LiMn_2O_4的电化学性能,H_3BO_3对锰酸锂的电化学性能影响不大,而Al_2O_3破坏了LiMn_2O_4的电化学性能。面扫描结果显示,Si或P元素各自都均匀地分散于LiMn_2O_4的物相中。从元素电负性和原子半径的角度分析了B、Si、P和Al元素对尖晶石型LiMn_2O_4结构和性能的影响。     

Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing

The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior.     

电磁胀形磁场力的有限元分析

研究电磁胀形过程中工件受到的磁压力沿长度方向和厚度方向的分布是工件变形分析的基础。采用有限元方法对电磁胀形过程中作用工件上的磁场力进行了数值模拟。在磁场特性理论分析的基础上确立了模型的边界条件，得到了磁场力沿工件长度和厚度方向的分布规律。模拟结果与测量值基本吻和。