一种新的带优先权控制的ATM交换结构

本文在Ｋｎｏｃｋｏｕｔ交换结构的基础上，探讨一种新的ＡＴＭ交换结构，使其本身带有优先权控制功能，以适应不同业务对信元丢失率及时延的不同要求。这种结构既能最大限度地有效利用系统资源，又能满足不同用户对业务质量的不同要求，并能降低交换结构复杂度。     

Magnetic properties of nickel filament polymer-matrix composites

The magnetic properties of polyethersulfone-matrix composites with 3-19 vol.% polycrystalline nickel filaments (0.4 (im diam) were investigated. These filaments were found to exhibit hysteresis energy loss 10800 J/m³ of nickel and coercive force 16.9 kA/m, compared to corresponding values of 4930 J/m³ and 4.7 kA/m for 2 μ.m diam polycrystalline nickel fibers, 1020 J/m³ and 0.5 kA/m for 20 μm diam polycrystalline nickel fibers, and 1280 J/m³ and 2.3 kA/m for solid polycrystalline nickel.     

微型电磁继电器的制作和仿真分析

介绍了一种基于MEMS技术的微型电磁继电器的制作过程和仿真分析.这种微继电器的大小约是4mm×4mm×0.5mm,主要采用普通的微加工技术来完成全部制作工艺.与传统继电器相比,这种继电器采用平面线圈来代替螺线管线圈,有利于MEMS工艺,并且提出了一种双支撑的悬臂梁结构做为活动电极,具有较高的灵敏性和稳定性.另外,还进行了一些有关线圈通过激励电流后对活动电极产生电磁力的理论计算和仿真分析,利用这些结果可以对这种电磁继电器的结构和参数进一步优化.     

MPC系统模块结构中的流场研究

本研究中,应用Simple数值计算方法开发了求解MPC系统模块结构中二维流场分布的计算软件。为了验证计算结果的精确性,用多普勒测速仪实测了用有机玻璃制成的MPC模块二维模型的流场,模拟计算结果与实测值对比取得了较好的一致性。四种不同流出角的MPC模块平均总压损失计算结果表明,已开发的软件可作为设计低流阻MPC模块的良好工具。     

双室工频感应炉的研制

介绍了双室工频感应炉的工作原理,炉子主要结构及其技术特征。     

Evaluation of a system of wind tunnels for field studies of ammonia loss from grassland through volatilisation

Rates of ammonia (NH₃) loss from a ryegrass sward measured using a system of small wind tunnels were compared with concurrent measurements made using a micrometeorological mass balance method. Measurements were made during two experiments within a circular plot (radius 10m) treated with urea at a rate of 200kgNha^?1. In the first experiment, air speed through the tunnels was adjusted as necessary to maintain a value of approximately 1ms^?1. This value differed on most occasions from the mean ambient wind speed which was measured at a height of 250mm and which ranged from 0.61 to 2.95ms^?1. Rates of loss measured using the wind tunnels differed by a factor of between two and five from those measured using the mass balance method; there was no consistent pattern in the differences between the rates of loss. The total losses of NH₃ measured during 15 days were equivalent to 49.1 and 30.2kg Nha^?1 for the mass balance and wind tunnel methods, respectively. In the second experiment, air speed through the tunnels was adjusted as necessary to maintain a value as close as possible to the mean ambient wind speed measured at a height of 250mm. Rates of NH₃ loss measured using the two methods did not differ significantly; total losses of NH₃ during 17 days were equivalent to 96.9 and 101kg Nha^?1 for the mass balance and wind tunnel methods, respectively. The difference between the findings of the two experiments could be attributed to the direct effect of air speed through the tunnels rather than to differences between ambient temperatures and those inside the tunnels. During and following periods of rain the rates of loss measured using the tunnels were up to six times greater than those observed with the mass balance method. Rates of loss measured by the two methods became similar again when the tunnels were moved following rain. The study demonstrates that enclosures can be designed and operated to provide reliable measurements of the rate of NH₃ loss from grassland. Potential applications of the two methods are discussed.     

用改进的逐次逼近解法计算二维井间电磁场

提出了一种计算积分方程的新方法——改进的逐次逼近解法 (MSAM) ,并用该方法计算了轴对称二维井间电磁场。与传统的逐次逼近解法 (SAM)相比 ,该方法收敛性强 ,应用范围广 ,可适用于高电导率对比地层。由于不必进行直接的大型矩阵求逆运算 ,因此与积分方程的直接解法 (IE)相比 ,该方法计算速度更快 ,所需内存更少。采用矩阵求逆方法计算了成层介质中的二维 Green函数 ,并对含 Green函数的积分进行了简化 ,从而加快了计算速度。数值计算结果显示 ,在地层电导率对比度达到 2个数量级时 MSAM仍收敛 ,且计算结果与直接求解积分方程的结果一致 ,因此 MSAM是一种有效的计算轴对称二维井间电磁场的方法     

热带城市垃圾典型组分的热解特性研究

对热带城市垃圾的几种典型组分进行了热解实验，得到了它们的失重曲线，通过对失重曲线进行分析，得到了这几种典型组分的热解规律，并通过建立热解动力学模型，求出了其中两种组分的活化能E和频率因子A。     

电火花铣削钛合金电极损耗在线补偿研究

根据电火花铣削等损耗理论，对用电火花铣削钛合金的加工中电极损耗补偿作了分析阐述。并根据正交试验的数据对理论分析结果进行对比，同时给出了一定的结论和建议。     

Dynamic-mechanical properties of polybutadiene rubbers

The dynamic properties of high-cis (98%) and cis-trans (42% cis) polybutadienes, crosslinked with 0.1 to 1.0% of crosslinking agent, have been studied using a torsion pendulum method over the temperature range ?170 to +20°C. For the high-cis rubber plots of damping factor (tan δ) against temperature showed the expected peak in the glass-transition region with an additional peak in the neighbourhood of 0°C attributable to crystallization. The cis-trans rubber showed two damping maxima in the transition region, separated by 30 to 40°C (depending on the degree of crosslinking), suggesting incipient phase separation of the component structures. The rebound resilience of the high-cis rubber at room temperature exceeded that of the cis-trans, reaching 92% at the highest crosslink density. Plots of resilience versus temperature for both rubbers showed a single minimum in the glass transition region.