一种环氧树脂阻尼灌封胶的热氧加速老化研究

研究了某种环氧树脂阻尼灌封胶在热氧老化的作用下分子结构、硬度、断面形貌以及动态力学性能随时间的变化．傅立叶红外光谱图表明，所制备的样品环氧基团反应比较完全，热氧老化后试样表面由仲胺和环氧基团形成的酯键发生了部分断裂和氧化；邵氏硬度的增加、瓦向高温区移动则表明在老化过程中复杂的固化反应仍然继续进行；最大损耗因子（tanδmax）波动较小表明试样老化后分子结构几乎保持不变；SEM图片显示试样的冲击断裂由老化前的韧性转变为老化后的脆性断裂．     

Effects of compressive and tensile stress on the growth mode of epitaxial oxide films

Oxide films were deposited on different substrates by laser molecular beam epitaxy. Reflection high-energy electron diffraction was performed to in situ investigate the change of growth mode and the lattice relaxation during the growth. An asymmetrical phenomenon was found in the two kinds of strain states, compressive stress and tensile stress of heterostructures with different lattice mismatch. In the case of BaTiO₃/SrTiO₃ (2.2%), 2D layer-by-layer growth mode without lattice relaxation can be maintained for a longer period for BTO films on STO with compressive stress, comparing to STO films on BTO with tensile stress. When MgO films were deposited on SrTiO₃ with a large mismatch of 7.8%, compressive stress leads to rapid lattice relaxation with a very thin wet layer, and 3D strained island were observed. As a comparison, SrTiO₃ films on MgO with tensile stress were configured. No RHEED patterns can be observed duo to a large tensile stress.     

基体温度对磁控溅射沉积ZAO薄膜性能的影响

利用中频交流磁控溅射方法 ,采用氧化锌铝陶瓷靶材 [w(ZnO) =98%、w(Al2 O3 ) =2 % ]制备了ZAO(ZnO∶Al)薄膜 ,观察了基体温度对ZAO薄膜的晶体结构、电学和光学性能的影响 ,采用X射线衍射仪对薄膜的结构进行了分析 ,采用光学分度计和电阻测试仪测量了薄膜的光学、电学特性 ,采用霍尔测试仪测量了薄膜的载流子浓度和霍尔迁移率。结果表明 :沉积薄膜时的基体温度对薄膜的结构、结晶状况、可见光透射率以及导电性有较大的影响。当基体温度为 2 5 0℃ ,Ar分压为 0 8Pa时 ,薄膜的最低电阻率为 4 6× 10 -4Ω·cm ,方块电阻为 35Ω时 ,可见光 (λ =5 5 0nm)透射率高达 92 0 %。     

掺Nd纳米ZnO薄膜特性研究

研究了用真空蒸发法在玻璃衬底上制备稀土掺杂纳米ZnO薄膜结构、导电性及光透射性能。结果显示 ,在 5 0 0℃氧化、热处理稀土元素Nd掺杂后能够明显改善纳米ZnO薄膜的结构特性 ,薄膜的晶粒尺寸随掺杂含量的增加而减小。掺Nd使ZnO薄膜的电性能有所改善但使纳米ZnO薄膜的光透射性有所降低。     

Evolution of grain structure in thin film reactions

In this paper, we examine, both experimentally and theoretically, the kinetics of formation and microstructure of product phases in thin film reactions, using the Nb/Al and Ti/Al systems as our prototypes. The results of calorimetry and microscopy studies are interpreted using simple kinetic and morphology models. In particular, the kinetic models employed here focus on the nucleation and growth components of the phase formation process and the morphology models provide a starting point for the classification of product grain structures. An erratum to this article is available at .     

Measurement of specimen charging in scanning electron microscopy with a kelvin probe

A vibrating Kelvin probe in form of a platinum wire loop is used to measure the surface potential U_s on electron-irradiated free-floating metal and insulator specimens as a function of electron energy E. This allows an accurate measurement of the critical electron energy E₂ for no charging. At energies below E₂, the positive charging increases with decreasing energy to U_s=2–5 eV at E=0.5 keV and switching off the collector bias of the Everhart-Thornley detector. A two-to threefold increase of U_s is observed when the bias is switched on. For E > E₂, the strong increase of a negative surface potential can be measured. Insulating films free-supported on a conductive substrate show a steep decrease to small positive and negative U_s when the film thickness becomes lower than the electron range at a critical energy E₃ > E₂. At insulating specimen the temporal decrease of charging can be measured when the electron beam is switched off.     

反应离化团束（RICB）法生长CN硬质薄膜

用反应离化团束（ＲＩＣＢ）法，以低分子量聚乙烯为蒸发材料，氨气为反应气体，在ＮａＣｌ（１００）和Ｓｉ（１００）衬底上淀积Ｃ－Ｎ薄膜，透射电子衍射（ＴＥＭ）分析表明薄膜中含有β－Ｃ３Ｎ４晶粒，Ｘ射线光电子谱（ＸＰＳ）和红外吸收谱（ＩＲ）表明存在Ｃ，Ｎ原子的化学键合。     

端羟基聚二甲基硅氧烯改性环氧树脂

用羟基封端的聚二甲基硅氧烷改性环氧树脂，得到具有两相结构的改性树脂，其耐热性明显提高．环氧树脂／有机硅（20／80）共混物涂层有很低的表面能，主要的机械性能则变化不大，可作为一种疏水性防护徐层．     

氮化钛薄膜的高分辨AES谱和XPS谱研究

着重讨论了TiNx薄膜俄歇电子谱的定量分析方法和X射线光电子谱中线形的变化。利用已知组元强度定量分析技术和Ti的LMV俄歇电子峰，探讨TiNx薄膜中N含量的定量方法。由该方法给出的定量结果与X射线光电子谱定量结果相一致。同时，利用X射线光电子谱测定了TiN和Ti2N2p轨道的结合能。并针对Ti2p峰形随N含量的变化，给出新的解释。