石墨粉末化学镀镍工艺研究

导电填料是构成高性能电磁波屏蔽材料和吸收材料的主要原材料。对石墨粉末化学镀镍提出采用含有浓硫酸和K2Cr2O7的溶液进行氧化、含有SnCl2的溶液进行敏化以及含有PdCl2的溶液进行活化的前处理工艺，在粒径为5～20μm的石墨粉末表面得到了均匀的高镍（wNi〉90％）低磷合金镀层，解决了石墨粉末化学镀镍难的问题。讨论了镀液中各组分含量、温度及搅拌速度对化学镀镍的影响。石墨粉末经该化学镀镍工艺处理后导电性及电磁屏蔽性能良好，是较好的电磁屏蔽用导电填料。     

不同粒径可膨胀石墨无卤阻燃高密度硬质聚氨酯泡沫塑料研究

采用高速混合破碎机对可膨胀石墨（EG）进行处理，制得不同粒径的EG。考察了不同粒径EG填充的硬质聚氨酯泡沫塑料（RPUF）的微观形态，研究了EG对于RPUF燃烧行为的影响。结果表明：EG的粒径越小，其在聚氨酯体系中的分散就越困难；20％未经处理的EG粒子（EG0）填充的RPUF氧指数为39．5％，比未填充的RPUF氧指数提高了近一倍，而经过13min破碎的EG粒子（EG13）其氧指数仅为23．5％，与纯RPUF的氧指数在同一水平；水平垂直燃烧结果可进一步验证氧指数结果，当EGO填充量超过10％时，RPUF燃烧已经达到了V-0级，而RPUF／EG13因其阻燃性能较差只能用水平燃烧分级。由此可见，EGO可有效提高RPUF的阻燃性能，而EG13对RPUF的燃烧性能几乎没有影响；研究同时提出了不同粒径EG无卤阻燃高密度硬质聚氨酯泡沫塑料的阻燃机理。     

柔性管设计中允许竖向变形的合理取值

本文分析了地下埋设的柔性管的竖向变形与管壁弯曲性能的关系，讨论了几类不同材质管道承受一定的工作压力时它们的竖向变形的合理取值。     

Dynamic output feedback control of a flexible air-breathing hypersonic vehicle via T–S fuzzy approach

By utilising Takagi–Sugeno (T–S) fuzzy set approach, this paper addresses the robust H_∞ dynamic output feedback control for the non-linear longitudinal model of flexible air-breathing hypersonic vehicles (FAHVs). The flight control of FAHVs is highly challenging due to the unique dynamic characteristics, and the intricate couplings between the engine and fight dynamics and external disturbance. Because of the dynamics’ enormous complexity, currently, only the longitudinal dynamics models of FAHVs have been used for controller design. In this work, T–S fuzzy modelling technique is utilised to approach the non-linear dynamics of FAHVs, then a fuzzy model is developed for the output tracking problem of FAHVs. The fuzzy model contains parameter uncertainties and disturbance, which can approach the non-linear dynamics of FAHVs more exactly. The flexible models of FAHVs are difficult to measure because of the complex dynamics and the strong couplings, thus a full-order dynamic output feedback controller is designed for the fuzzy model. A robust H_∞ controller is designed for the obtained closed-loop system. By utilising the Lyapunov functional approach, sufficient solvability conditions for such controllers are established in terms of linear matrix inequalities. Finally, the effectiveness of the proposed T–S fuzzy dynamic output feedback control method is demonstrated by numerical simulations.     

沙棘柔性坝拦沙效应的试验研究

在野外试验基地进行了沙棘柔性坝拦沙效应试验。基于试验数据,分析了不同含沙水流条件下沙棘柔性坝对沿程含沙量及出入口悬沙粒径分布的影响,并探讨了沙棘柔性坝的阻力特性。结果表明,沙棘柔性坝对不同含沙水流的拦沙效果显著不同,对原型沙B的拦截效果最好,其次为原型沙A,最后为模型沙。对250~1 000μm粒径范围内的原型沙拦截效果最佳,且原型沙含沙量与中值粒径之间呈现正相关关系,对100~1 000μm粒径范围内的模型沙的拦截效果较好。各不同含沙水流条件下的沿程含沙量主要受沙棘柔性坝阻力的影响。本研究有助于深入理解沙棘柔性坝的拦沙效应,并对沙棘植物柔性坝这一生态工程在砒砂岩区沟道的推广应用提供理论依据。     

可膨胀石墨催化合成醋酸丁酯

可膨胀石墨对醋酸丁酯的合成具有较高的催化活性。最佳条件是正丁醇与醋酸的摩尔比为1：1．15，催化剂用量为醇和酸总质量的5．59％，反应时间55min，醋酸丁酯收率可达98％以上。     

Electrodeposition of Pd–Ag alloy nanowires on highly oriented pyrolytic graphite

This paper reports findings of an investigation of Pd–Ag alloy nanowires on the step edges of highly oriented pyrolytic graphite (HOPG) by electrochemical deposition at room temperature. Scanning electron microscopy (SEM) images reveal that these alloy nanowires (109–430 nm) are uniform in diameter, and have lengths up to 100–500 μm. The electrodeposition process involves the initial formation of nanowires induced at the step edges of the oxidized HOPG substrate at a very negative potential and subsequent growth at a constant low current density to coalesce the discontinuous nanowires. Alloy nanowires with a 20–25% silver content can be obtained when the ratio of Pd and Ag in the solution is carefully controlled. The SEM images demonstrate that the alloy nanowire arrays are continuous, parallel, ordered, well-aligned and have a narrow distribution of diameters. The Pd–Ag alloy nanowire arrays are promising materials for fabricating hydrogen nanosensors.     

定量校准曲线法测定超高纯试剂丙酮中铁含量的研究

目前最常用的分析曲线法(标准曲线法、校准曲线法)、内标法、标准加入法等,对丙酮这类基体成分丰富的样品测定,其定量校准存在显著的系统误差.实验证实,通过保证标准系列中基体组成、浓度及酸度与待测样基本相同,来制作工作曲线进行定量校准(下称定量校准曲线法),能得到较为理想的结果.     

Development of flexible organic light‐emitting diode on barrier film and roll‐to‐roll manufacturing

To come out with a successful organic light‐emitting diode (OLED) lighting business, it is very important to have clear differentiation of OLED from LEDs. Flexible OLED has merits, such as capability to be mounted on the curved wall, which is not easy for LEDs to achieve the feature. There are several approaches to make flexible OLEDs especially among those plastic barrier films that can bring high level of flexibility, which could not be achieved by any conventional lighting method. In this paper, barrier films with various water vapor transmission rate values, including 10^{? 6} order, are applied, and the conditions to have almost no dark spot growth under 85 °C and 85% high temperature/humidity test are shown. Flexible OLED panels are manufactured with the world's first roll‐to‐roll equipment using plastic barrier film.     

石墨材料的疲劳

对迄今前人在石墨材料上所开展的疲劳研究工作进行了综述，以不同的疲劳设计方法为线索，一方面通过对石墨寿命评价的S-N曲线来分析石墨的疲劳行为；另一方面从疲劳裂纹扩展的角度来分析在外应力作用下有预制裂纹的石墨的疲劳行为。总结了石墨疲劳研究的主要进展，归纳了石墨疲劳研究中的关键问题，在此基础上对石墨材料的疲劳研究前景进行了展望。