Secondary ion emission from Ti and Si targets induced by medium energy Ar ion bombardment - Experiment and computer simulation

The paper presents experimental results of secondary ion energy distributions obtained for Ti and Si targets bombarded by 20-30 keV monoisotope Ar⁺ ion beam. The influence of the extraction voltages between target and a slit of the electrostatic energy analyzer entrance on the energy distributions of secondary ions was investigated. After optimization of the secondary ion extraction system, the mass spectra of secondary ions were also measured. The investigations were done using recently built experimental system. Experimental data are compared with the computer simulation results obtained using TRQR and SATVAL codes.     

Model for Nanoscopic Domain Formation in Dipalmitoyl-PC/Dilauroyl-PC/Cholesterol Mixture

We describe the lyotropic liquid crystalline phase transitions in the lipid mixture dipalmitoil-PC/dilauroy-PC/cholesterol by 3D spin-1 lattice model. The formation of nanoscale domains with the characteristic size about 300 nm was studied in experiments on confocal fluorescence microscopy (CFM) (G. V. Feigenson and J. T. Buboltz, Biophys. J. 80, 2775 (2001)). The structure parameters of the lamellar vesicle in dipalmitoil-PC-rich phase, corresponding to these regions, are verified by numerical Monte Carlo simulations on the lattice. We point its superconductivity analogy properties at the region of phase stability for composition-dependent nanoscopic region.     

Control of Wind-Induced Self-Excited Oscillations by Transfer of Internal Energy to Higher Modes of Vibration. II: Application to Taut Cables

In Part I of this paper, a theoretical basis is presented using a two-degrees-of-freedom model. In this second part of the study, the passive control and the two types of semiactive controls introduced in Part I are examined numerically for a taut cable experiencing wind-induced galloping motion. The passive and the semiactive control schemes for taut cables show a good similarity with the results obtained for the two-degrees-of-freedom model. The potential of using these control schemes in practical applications to flexible structures is demonstrated.     

S1240一次呼叫转移命令不成功故障的排除

对S1240交换机一次呼叫转移命令不成功故障排除的过程进行了分析。     

Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

甲基丙烯酸三氟乙酰氧乙酯的聚合

对甲基丙烯酸三氟乙酰氧乙酯(TFAOEMA)的阴离子聚合及原予转移自由基聚合进行了研究。常用的阴离于引发剂如丁基锂、1，1-二苯基已基锂等很难引发TFAOEMA的阴离子聚合，而碱性较弱的引发剂如三乙基铝却容易引发，且产率较高。以氯化亚铜、五甲基二乙基三胺、溴代丙酸乙酯为引发体系的TFAOEMA的本体原子转移自由基聚合符合活性聚合特征。但在四氢呋喃为溶剂的原子转移自由基聚合中却存在活性中心失活现象。以末端含卤素的聚甲基丙烯酸甲酯为大分子引发剂，引发TFAOEMA的原子转移自由基聚合，得到了含氟双嵌段聚合物。     

Influence of the Transport Properties of the Crystal/Heat Transfer Surface Interfacial on Fouling Behavior

One method to reduce fouling is to extend the induction time by a defined modification of the interfacial interactions between the heat transfer surface and the crystalline deposit. Since these interactions are a result of both molecular and mechanical forces, two approaches for fouling mitigation have been developed: (a) Modification of the energy related properties of the heat transfer surface and (b) Modification of the geometry related properties of the heat transfer surface.     

螺旋翅片管的换热计算

本文引入区域平均表面传热系数的概念。在实验研究的基础上进行了肋基和肋端温度分布预测及肋片换热数值计算。     

管内含蜡原油降温过程中的放热问题

利用两种管段和两种原油，进行了降温过程自然对流放热参数的测试和研究。采用滞流点确定降温第二阶段中凝油边界的移动，区分管内的对流区与导热区。由实验数据回归得到适用于含蜡原油降温过程的自然对流放热准则方程式。用该方程式计算的自然对流放热系数值比按无限空间自然对流准则方程式计算值小20％～50％。