裂隙岩体边坡稳定性的渗流与应力耦合分析

用裂隙岩体渗流与应力耦合分析的四自由度全耦合法对岩质边坡进行耦合分析,通过强度折减有限元法求解岩体边坡的稳定安全系数。四自由度全耦合法建立了同时以渗流水压和位移为未知量的耦合方程组,使得渗流场与应力场的求解能够一次性完成,与两场交叉迭代分析方法相比达到了彻底的完全耦合。通过强度折减,整个系统达到不稳定状态,有限元计算将不收敛,此时的折减系数就是安全系数。算例表明由此求得的边坡稳定安全系数和滑动面都与传统方法十分接近。     

AHMED experiments on hygroscopic and inert aerosol behaviour in LWR containment conditions: experimental results

Hygroscopic NaOH, CsI, CsOH and inert Ag aerosol behaviour at different temperatures and relative humidities (RH) has been studied in a well instrumented and controlled vessel of 1.81 m³ total free volume. Homogeneous thermal-hydraulic conditions for aerosol measurement in the vessel were achieved. The aerosol number and mass concentration were measured continuously during the experiments using a Condensation Nucleus Counter and a Tapered Element Oscillating Microbalance. The particle size distribution and chemical composition in the test conditions were measured by Berner low pressure impactors. In the case of NaOH the half life of the aerosol mass concentration was more than four times longer at low RH (22%) as compared to high RH (96%). The half lives of the CsOH and CsI aerosols were only twice as long at low RH as compared to high RH. Thus at high RH (96–97%) the half lives of CsOH and CsI were twice as long as the half life for the NaOH aerosol. The faster decay of the NaOH aerosol is due to the smaller density decrease of NaOH during water condensation. CsOH particles grew rapidly to their equilibrium size at all humidities. The measured equilibrium size for CsOH aerosol agree well with the calculated particle size at different RHs. Experimental results were also compared with calculations obtained by severe accident computer codes. These calculated results will be presented in a later paper.     

裂隙岩体中掏槽爆破的影响因素分析

对裂隙岩体中掏糟爆破布孔的影响因素进行了研究，并根据裂分布的情况提出相应的布孔方法和原则。对有关的工程施工具有实际意义。     

松软矿体有底柱高分段崩落法的改进方案

锦屏磷矿对其东山采区松软矿体所使用的分段崩落法做了集中快速采准施工、增加分段高度、实行水平或上向扇形深孔连续崩矿等改进,简化了采场结构,矿石损失率由原来的63％下降到改进后的20.34％,贫化率由23.92％下降到15.10％。     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

On-line mass spectrometry system for measurements at single-crystal electrodes in hanging meniscus configuration

We present the construction and some first applications of an On-line electrochemical mass spectrometry system for detecting volatile products formed during electrochemical reactions at a single-crystal electrode in hanging meniscus configuration. The system is based on a small inlet tip made of porous Teflon and a Peek holder, which is brought in close proximity (ca. 10–20 μm) to the electrode surface. The tip is connected to the mass spectrometer by glass and metal tubing. Because of the small amount of gas entering the mass spectrometer, no differential pumping is needed during the measurement. The tip construction and preparation introduced here leads to reproducible voltammetry with very good cleanliness characteristics. The presence of the tip has no significant influence on the blank voltammetry of a Pt(111) in sulfuric acid, and on voltammetric responses for CO adlayer oxidation, methanol oxidation, and hydroxylamine electrochemistry on Pt(111). The formation of gaseous products in these reactions can be followed accurately and is in good agreement with earlier results obtained by other mass spectrometric or spectroscopic techniques. The time response and tailing of the setup is on the order of seconds and mainly determined by the distance between the tip and the electrode.     

Analysis of trace mercury in water by solid phase extraction using dithizone modified nanometer titanium dioxide and cold vapor atomic absorption spectrometry

A new method for analysis of trace mercury in water samples was developed, based on the combination of preconcentration/separation using dithizone-modified nanometer titanium dioxide (TiO2) as a solid phase extractant and determination by cold vapor atomic adsorption spectrometry (CVAAS). Dithizone was dissolved with alcohol and loaded on the surface of nano-sized TiO2 powders by stirring. The static adsorption behavior of Hg2 on the dithizone-modified nanoparticles was investigated in detail. It was found that excellent adsorption ratio for Hg2 could be obtained in the pH range of 7-8 with an oscillation time of 15 min, and a 5 mL of 3.5 mol·L-1 HCl solution could quantitatively elute Hg2 from nanometer TiO2 powder. Common coexisting ions caused no obvious influence on the determination of mercury. The mechanisms for the adsorption and desorption were discussed. The detection limit (3σ) for Hg2 was calculated to be 5 ng·L-1. The proposed method was applied to the determination of Hg2 in a mineral water sample and a Zhujiang River water sample. By the standard addition method, the average recoveries were found to be 94.4%-108.3% with RSD (n = 5) of 2.9%-3.5%.     

飞行时间二次离子质谱--强有力的表面、界面和薄膜分析手段

二次离子质谱（Secondary ion mass spectrometry，简称SIMS）是一种对表面灵敏的质谱技术，建立在表面各种类型带正、负电荷原子或分子发射的基础上。用飞行时间（Time of flight，简称TOF）仪器对这些二次离子进行质量分析，能确保并行质量登录、高质量范围、高流通率下的高分辨和精确质量测定这些优异性能。配合细聚焦扫描一次离子束，可在优于1nm的高深度分辨和优于50nm的横向分辨本领下，实现对表面优于单层ppm(百万分之一）量级的极高检测灵敏度。当今TOF－SIMS已发展为一种成熟且完善的表面分析技术。极高的灵敏度，再加上即使对大分子及不易挥发性分子都独具的敏感性，使它成为很多高技术领域不可缺少的分析手段，这些领域包括微电子学、化学和材料科学以至纳米技术和生命科学等。本文简述了TOF－SIMS的原理、仪器及其多方面的应用和展望。     

大体积砼产生裂缝的原因及防治措施

大体积砼裂缝问题是建筑业普通关心的问题.对砼裂缝进行控制,就必须研究砼结构中裂缝产生的原因以及在实际的设计和施工过程中采取合理的、经济的措施来控制裂缝.本文通过对大体积砼裂缝成因的理论研究,提出了合理的裂缝控制的设计和施工措施.     

调谐质量阻尼器参数设计中的两个问题

本文以单自由度系统安装一个调谐质量阻尼器（简称TMD）为例，对抗风和抗震两类不同激励工况下TMD的参数设计问题进行了理论研究与对比分析。通过给出相对误差系数的概念，定量评价了不同的参数方法对TMD减振性能的影响程度。本文的研究为TMD的参数设计提供了理论指导。