安棚深层系凝析气井射孔压井液技术研究

介绍了一种保护油气层的射孔压井液技术，该技术所用的配方具有低密度，低表面张力且具有较强的防膨能力等特点，在安棚深层系低孔低渗油田安3003等凝析气井作业中现场试验，解决了安棚深层系低压气井的水锁伤害等问题，对低孔低渗油气田作业入井流体的研究与应用具有较好的借鉴意义。     

一种复合型数值方法的改进与算法实现

文中对原有的复合方法进行了改进,提出了一种新的复合型数值方法,这种方法解决了原方法求解含源项的问题时存在数值震荡的缺点。为了验证算法的有效性,对计算流体力学中一阶浅水波问题的两个典型的算例进行了数值模拟,在解的光滑性、锐利性等几个方面做了分析,结果表明改进后的方法既消除了数值震荡现象,又能准确地逼近真解,求出锐利的间断,是一种行之有效的数值方法。     

井冈山水厂设计体会

阐述水厂设计中对水厂规模、水源地、净水厂位置及净水工艺的确定过程，根据原水的特点，通过分析对无阀滤池进行改良。     

热压/热变形Nd2Fe14B/α-Fe纳米双相永磁体的研究

为了制备各向异性块状Nd2Fe14B／α—Fe纳米双相永磁体，研究了热压／热变形工艺参数与样品微观组织结构、磁性能之间的关系。结果表明，饱和磁化强度Js随模压温度的升高而提高；而剩磁Jr、内禀矫顽力Hcj和最大磁能积(BH)max开始都随模压温度的升高而上升，但超过一定温度后反而降低；同时提高热压压力会使磁性能增加，而热变形温度对磁性能影响很小。热变形后样品垂直于压力方向的磁性能略高于平行于压力方向，呈现出轻微的各向异性。Nd2Fe14B／α—Fe纳米双相永磁材料在热压／热变形后没有产生晶粒的择优长大，在晶体学上仍然是各向同性的。     

电接点压力表补水泵定压系统的应用

阐述了电接点压力表补水泵定压系统的一些应用问题 ,给出了电接点压力表定压点的上、下限计算公式 ,并提出了该系统补给水泵、补给水箱及安全阀的设计选型方法     

油管电热清防蜡技术在强水敏油田的应用

江苏油田的庄 2、韦 2油田属强水敏油田 ,采用热 (水 )洗油井和化学清防蜡效果较差 ,两油田每年因洗井造成地层污染影响的产量损失在 5 0 0 0t以上 ,约占油田产量的 4 5 %。根据集肤效应 ,采用油管电热清蜡技术 ,在含水小于 6 0 %、井斜小于 4 0°的油井上可正常使用 ,一般通电加热 4 0～ 80min后 ,油井井口温度能达到 5 0℃左右 ,最高可达到 6 5℃以上 ,连续加热 5～ 6h即可达到清蜡目的 ,电热清蜡为周期 6 0～ 90d。影响电热清蜡主要指标因素是油井的产液量 ,产液量越小 ,所需要的加热电流和加热电压也越小 ,井口温度达到最高值越低 ,清蜡效果越差。试验的 7口井平均年度投入产出比达到 1∶5 ,经济效益和社会效益十分明显。     

Variation de la plombemie en fonction de la contamination par le plomb de l'eau livree a la consommation: Variation of the blood lead level as a result of lead contamination of the subjects drinking water

The combination of the chemical aggressivity of water and lead piping, as is well known, can cause severe cases of lead poisoning in those who consume such water. After a great number of observations and epidemiological studies which have strongly incriminated this metal in a wide range of pathologic conditions, other materials have been gradually substituted for lead; however, the problem remains.In compliance with a European Directive to survey the risk of lead poisoning (Council Directive, 1977), a random sample of 321 residents was selected from the Vosgian Mountains of France. This region is noted for its high incidence of cases of lead poisoning: 150 reported during 8 months in 1983 (Barbier et al., 1983).During the course of a health evaluation, a blood sample was taken from each subject for lead analysis. At the same time, a sample of tap-water (after running for 5 s) was taken from each subject home. Both lead analyses (blood and water) were performed by electrothermal atomization-atomic absorption spectrophotometry. Because of the log-normality of the distributions of the blood lead levels and the concentrations of lead in the drinking water, a logarithmic transformation was performed so that the results are expressed as the geometric mean, which for the amount of lead in the drinking water of our sample was found to be 0.16 mg l^?1.Among the subjects of this study, 28% are served by water containing more than 0.10 mg l^?1 of lead (the standard for France) and 48% by water containing more than 0.05 mg l^?1 (the European and WHO standard). In concurrence with numerous authors, our study indicates that, among our subjects, the blood lead level is much higher in men than in women (geometric means 22.9 and 15.0 μg dl^?1 respectively); this difference is highly significant (t-test:P < 0.001). Table 1 summarizes the results, by sex, obtained in this region compared with those from a study (Huel, 1982) concerning an urban French population whose geometric mean blood lead levels were 15.9 μg dl^?1 for men and 11.4 μg dl^?1 for women. The irrespective of sex, is highly significant (P < 0.001). Table 2 shows the significance of the relation between these subjects, high blood lead levels and the concentration of lead in their drinking water, while Fig. 1 shows that for contamination levels up to 0.02 mg l^?1 of lead in water, the blood lead level remains relatively stable, while above this apparent “threshold” value, the blood lead level begins to increase finally reaching quite high values in response to high contamination levels, suggesting a direct translation of increases in the water above the 0.02 mg l^?1 level to increases in the blood.     

抗裂合成纤维混凝土在尼尔基发电厂房工程中的应用

为了提高发电厂房水轮机混凝土蜗壳的抗裂、抗渗、抗冲击、抗震、抗冲耐磨性能，在尼尔基水利枢纽工程蜗壳混凝土的施工中掺加抗裂合成纤维，厂房项目部试验人员对蜗壳混凝土进行了掺加抗裂合成纤维（CTA Fiber）试验，试验结果及工程实际应用效果良好，提高了工程质量，支持了国家重点工程建设。     

台缙高速公路苍岭隧道水文地质勘察与涌水量预测

以台缙高速公路苍岭隧道为例，通过水文地质综合勘探方法，查明隧道不同裂隙发育程度岩体的渗透系数K值。然后利用地下水动力学法、地下水径流模数法对隧道开挖涌水量进行了预测。通过施工检验发现，涌水段位置和涌水量总体较接近，说明预测工作对隧道的施工开挖和排水设计具有指导意义。     

实炉底节能连续式加热炉

轧钢生产使用实炉底连续式加热炉加热钢坯，炉内双纵滑管用耐热耐高温材料，无水冷，起到节约水、电的作用，达到节能增效的目的。