首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   63210篇
  免费   5053篇
  国内免费   2353篇
电工技术   1971篇
技术理论   1篇
综合类   3023篇
化学工业   19063篇
金属工艺   1137篇
机械仪表   2730篇
建筑科学   1240篇
矿业工程   1185篇
能源动力   2203篇
轻工业   12474篇
水利工程   284篇
石油天然气   20348篇
武器工业   121篇
无线电   408篇
一般工业技术   2666篇
冶金工业   970篇
原子能技术   106篇
自动化技术   686篇
  2024年   330篇
  2023年   794篇
  2022年   1497篇
  2021年   1817篇
  2020年   1991篇
  2019年   1980篇
  2018年   1699篇
  2017年   2142篇
  2016年   2265篇
  2015年   2093篇
  2014年   3412篇
  2013年   3831篇
  2012年   4174篇
  2011年   4368篇
  2010年   3181篇
  2009年   2988篇
  2008年   2627篇
  2007年   3427篇
  2006年   3721篇
  2005年   3277篇
  2004年   2916篇
  2003年   2705篇
  2002年   2351篇
  2001年   1981篇
  2000年   1793篇
  1999年   1492篇
  1998年   1229篇
  1997年   1038篇
  1996年   798篇
  1995年   624篇
  1994年   502篇
  1993年   348篇
  1992年   314篇
  1991年   236篇
  1990年   165篇
  1989年   123篇
  1988年   58篇
  1987年   55篇
  1986年   25篇
  1985年   65篇
  1984年   63篇
  1983年   39篇
  1982年   31篇
  1981年   9篇
  1980年   18篇
  1979年   3篇
  1978年   3篇
  1977年   4篇
  1976年   4篇
  1951年   7篇
排序方式: 共有10000条查询结果,搜索用时 62 毫秒
91.
乙烯基硅氧烷改性苯丙乳液的研究   总被引:2,自引:0,他引:2  
在苯乙烯 -丙烯酸酯乳液共聚反应后期 ,加入少量乙烯基硅氧烷 ,制得改性苯丙乳液 ,通过红外光谱初步确定了聚合物结构。研究了反应温度、反应时间、有机硅加入方式、乳化剂用量等因素对反应进程、乳液稳定性及涂膜性能的影响。  相似文献   
92.
低温低渗透砂岩油藏窜流大孔道深部封堵技术研究   总被引:4,自引:0,他引:4  
所用堵剂为高强度的淀粉接枝聚丙烯酰胺交联凝胶SAMG-1,由<6%淀粉、4.5%-5.5%丙烯酰胺、0.003%-0.006%交联剂组成,35℃成胶时间受淀粉和交联剂用量控制,为18-20小时以上,成胶前黏度-100 mPa.s。该堵剂具有长期稳定性,在储层岩心中注入深度15 cm的堵剂,在35℃候凝48小时后及老化90天后,封堵强度分别为0.61和0.59 MPa/cm,封堵率分别为98.6%和98.1%。该堵剂优先进入高渗层,注入0.5 PV并成胶后,2组双填砂管组成的模型低、高渗管渗透率保留率分别为68.4%、0.7%和69.4%、0.0%。吉林扶余油田西一区+15-8.2区块有水井6口,油井13口,含水率达91.5%,注入水最快在5天内到达油井。报道了该区块整体深部调剖封堵窜流通道的情况,详细叙述了+15-9.2井施工中通过注入压力和井底回压控制注入流量,使堵剂陆续进入原生和次生孔道的工艺作业,该井设计注入堵剂92 m3。6口水井整体调剖后,油井产液量差别减小,产油量增加,有效期已超过了9个月,共增油843 t,含水平均下降3.87%。图7表1参8。  相似文献   
93.
江苏复杂小断块油藏老井侧钻实践与认识   总被引:2,自引:0,他引:2  
利用停关、低效井实施老井侧钻,其条件包括油藏、井身及技术经济等3个方面。侧钻效益的好坏与油藏类型、侧钻目标有着很大关系,侧钻断块油层、挖掘构造高部位剩余油成功率高,边底水、高渗透油藏侧钻效果好。实践表明,老井侧钻是提高江苏复杂小断块油藏开发效果,降低投资、提高效益的一项重要手段。  相似文献   
94.
研究了以集合论为基础的调度优化模型。给出了该离散型优化问题的求解算法。根据优化结果,在G2实时智能平台上开发了包含监视子系统和调度子系统的调度支持系统。在中国石化股份有限公司长岭分公司的试用结果表明,该调度系统可以提高炼油厂的生产效率,从而提高炼油厂的经济效益。  相似文献   
95.
高分子表面活性剂对超声辐照下苯乙烯乳液聚合的影响   总被引:1,自引:0,他引:1  
在超声辐照引发苯乙烯乳液聚合中加入一种新型的以羧甲基纤维素为基础的高分子表面活性剂(CMC—A9),讨论了高分子表面活性剂对反应动力学的影响。实验表明,超声辐照下初级自由基并非由通常认为的高分子表面活性剂产生,而是十二烷基硫酸钠在超声辐照下断裂,产生自由基。通过对反应动力学的研究,发现超声辐照下乳液聚合机理不同于常规乳液聚合,聚合反应过程只有两个阶段,即加速期和减速期,不存在恒速期。加入CMC—A9高分子表面活性剂,可以在较短的时间内和较低的超声功率下达到较高的单体转化率。  相似文献   
96.
Chemical Composition and Microstructure of Polymer‐Derived Glasses and Ceramics in the Si–C–O System. Part 2: Characterization of microstructure formation by means of high‐resolution transmission electron microscopy and selected area diffraction Liquid or solid silicone resins represent the economically most interesting class of organic precursors for the pyrolytic production of glass and ceramics materials on silicon basis. As dense, dimensionally stable components can be cost‐effectively achieved by admixing reactive filler powders, chemical composition and microstructure development of the polymer‐derived residues must be exactly known during thermal decomposition. Thus, in the present work, glasses and ceramics produced by pyrolysis of the model precursor polymethylsiloxane at temperatures from 525 to 1550 °C are investigated. In part 1, by means of analytical electron microscopy, the bonding state of silicon was determined on a nanometre scale and the phase separation of the metastable Si–C–O matrix into SiO2, C and SiC was proved. The in‐situ crystallization could be considerably accelerated by adding fine‐grained powder of inert fillers, such as Al2O3 or SiC, which permits effective process control. In part 2, the microstructure is characterized by high‐resolution transmission electron microscopy and selected area diffraction. Turbostratic carbon and cubic β‐SiC precipitate as crystallization products. Theses phases are embedded in an amorphous matrix. Inert fillers reduce the crystallization temperature by several hundred °C. In this case, the polymer‐derived Si–C–O material acts as a binding agent between the powder particles. Reaction layer formation does not occur. On the investigated pyrolysis conditions, no crystallization of SiO2 was observed.  相似文献   
97.
根据石油开采业对石油机械产品的需求 ,利用机械理论基础知识 ,通过实践设计 ,提出了对几何尺寸长的金属管类进行调质处理后的均匀冷却方法 ,以满足其性能要求。  相似文献   
98.
Oleuropein, a polyphenolic glucoside, constituent of olive fruit and oil, has been previously shown to exhibit, in vitro, potent properties as a biological antioxidant. In the present paper, two new properties are demonstrated in vitro as well, concerning its vascular protection activity, against the atheromatic lesion formation and its blood antithrombotic effect. Firstly, it was found that the oxidation of low-density lipoproteins (LDL), induced by different quantities of total polar materials (TPM), was inhibited by 10 μ M (final concentration) of oleuropein, revealing approx. 50% protection. Secondly, platelet-rich human plasma aggregation, induced by either the platelet-activating factor or adenosine diphospate or arachidonic acid, was inhibited by oleuropein. The 10 μ M (final concentration) of oleuropein was proven to be the most effective among the tested concentrations against LDL oxidation, while an IC50=0.41 mM was calculated for its inhibitory activity against platelet aggregation induced by 0.7 μ M platelet-activating factor.  相似文献   
99.
任丘油田雾迷山油藏抽油机井系统效率初步探讨   总被引:3,自引:1,他引:2  
总公司1996年对任丘雾迷山油藏抽油机井进行测试,系统效率高达51%~68%,其结果出乎意料。从影响抽油机系统效率的几大因素入手,分析出任丘雾迷山油藏抽油机井系统效率高的主要原因。任丘雾迷山油藏属裂缝性破酸盐岩油藏(即灰岩油战),由于其裂缝发育、渗透性好、油层厚度大、地层温度高、油气比小、饱和压力低等,使得抽油机井生产呈现如下特点:()大泵径,长冲程,低冲次大排量采油;(2)中浅京挂,小沉没度;(3)抽汲流体为液体单相,泵充满程度高;(4)部分井为连抽"带喷"状态,抽油系活塞底部受力大;(5)井液粘度低,油井不结蜡,摩阻损失小。由于这些特点以及近年来使用的新型节能抽油机,使得抽油机井系统效率大大高于其它油田抽油机井系统效率。  相似文献   
100.
提出了应用油水融合技术在合成氨部分氧化法制气中以水代汽的工艺途径,并分析了其效果和意义。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号