利用高频磁场制备自生梯度复合材料的熔体温度选择

研究了通过在熔体凝固过程中的不同温度范围施加高频磁场制备自生梯度复合材料的工艺.对于Al/Mg2Si/Si自生梯度复合材料,近似计算及实验结果表明:Al Mg2Si二元共晶区(555～595C)是施加高频磁场的最佳温度范围,此时处于低粘性熔体中的增强颗粒容易被外加电磁阿基米德力分离.高频磁场施加温度过高或过低,均不易使增强颗粒产生梯度分布效果.     

用人工神经网络方法预测鼓泡塔气含率

A new correlation for the prediction of gas hod up in bubble columns was proposed based on an extensive experimental database set up from the literature published over last 30 years .The updated estimation method relying on artificial neural network,dimensional analysis and phenomenological approaches was used and the model prediction agreed with the experimental data with average relative error less than 10%.     

An improved light attenuation technique for measuring large interfacial areas

A laser-based light attenuation technique was successfully used to measure interfacial areas as high as 5832 m²/m³ and Sauter mean bubble diameter varying between 50 and 5600 μm. Good agreement between this approach and the photographic technique was obtained particularly at low gas holdups.     

纳米碳酸钙原位聚合聚氯乙烯树脂的性能及应用

介绍了纳米碳酸钙原位聚合聚氯乙烯的结构和性能,同时对该树脂进行了有关的应用试验,并对其发展前景作了科学展望。     

原位聚合法研制纳米胶囊相变材料

采用超声波工艺及细乳液原位聚合方法,研制了以聚苯乙烯为囊壁、正十八烷为囊芯的纳米胶囊相变材料;系统探讨了聚合反应各因素如引发剂、链转移剂、表面活性剂以及正十八烷/苯乙烯比等对乳胶粒子的形态、胶囊材料热性能的影响,对所研制的胶囊相变材料进行激光衍射粒度分析、透射电镜及差示扫描量热等表征.实验结果表明,在引发剂AIBN 0.5%(油相质量百分比,下同);链转移荆DD在T0.4%;复合乳化剂(SDS/OP10)总量2%,配比1:1及正十八烷/苯乙烯比=1:1条件下,胶囊呈球形均匀分布,聚苯乙烯囊壁能将正十八烷囊芯很好包裹住,其胶囊Z均直径124nm,相变焓可达124.4kJ·kg-1.     

Current problems in the modelling of chemical reactors

Modelling of chemical reactors is reviewed with an emphasis on process development and scale-up. A distinction is made between modelling of chemical kinetics, of rate processes in volume elements and of whole reactors. Examples are mainly taken from papers presented at the Sixth International Symposium on Chemical Reaction Engineering. Special attention is given to the modelling of single phase reactors, fixed beds, trickle beds, fluid beds, and gas bubble reactors.     

PX氧化鼓泡塔反应器内的TA浓度分布

利用新建的D476鼓泡塔冷模实验装置和沉降—扩散模型对工业鼓泡塔PX氧化反应器内的TA浓度分布进行了实验和数学模拟研究。结果表明,由于PX氧化气速较大,塔内TA浓度接近均匀分布。     

垂直管内弹状气泡上升中壁面传递的实验研究

垂直管内弹状流壁面传递是诸多工业应用中需研究的重要问题之一。今用极限扩散电流技术,对弹状气泡上升时瞬时壁面剪应力和传质系数进行了测定,结果显示:当基于表观气速的Froude数FrG < 0.74时,壁面剪应力随弹状气泡和液塞的到来呈现方向相反的交替变化,壁面传质系数亦相应变化;而当FrG > 0.74时,剪应力方向一直向下,说明液膜向下流动,且弹状气泡和液塞的到来对壁面传质系数的影响很小。这说明下落液膜射流穿透了液塞段,控制了整个壁面传递过程。研究还对下落液膜区、尾迹区及液塞段的不同传递特征及机理进行了分析, 并结合气泡塔熔融结晶器中弹状气泡上升时的传热,对结晶操作条件的合理选择进行了讨论。     

脲醛树脂微胶囊包覆红磷阻燃剂制备工艺的研究 Ⅰ.预聚物合成工艺研究

研究了脲醛树脂的预聚物通过原位聚合对红磷进行包覆的一些影响因素。实验表明影响预聚物质量的主要因素是第一阶段尿醛比(F/U)1,第二阶段尿醛比(F/U)2,反应温度和pH值。制备预聚物的最佳条件为:第一阶段尿醛比为2.3∶1(摩尔比),第二阶段尿醛比为1.3∶1(摩尔比),pH值为5.1,反应温度为75℃。制备的预聚物来包覆红磷,颜色为白色;用微胶囊红磷阻燃聚乙烯,当含量为9%时,在500℃下残余物为4.85%。     

Bubble Formation at a Rotating Cylindrical Surface in Cross‐Flowing Liquid

A novel method of gas sparging from a rotating cylinder is proposed, which prevents against formation of large attached gas cavities in cross‐flowing liquids including those flowing downwards. Experimental and theoretical results regarding critical rotation speed necessary to remove the attached cavity, bubble formation process and size distribution of the produced bubbles in a low viscosity system (air‐water) are presented in this study.