Pool boiling on a superhydrophilic surface

Titanium Dioxide, TiO₂, is a photocatalyst with a unique characteristic. A surface coated with TiO₂ exhibits an extremely high affinity for water when exposed to UV light and the contact angle decreases nearly to zero. Inversely, the contact angle increases when the surface is shielded from UV. This superhydrophilic nature gives a self-cleaning effect to the coated surface and has already been applied to some construction materials, car coatings and so on. We applied this property to the enhancement of boiling heat transfer. An experiment involving the pool boiling of pure water has been performed to make clear the effect of high wettability on heat transfer characteristics. The heat transfer surface is a vertical copper cylinder of 17 mm in diameter and the measurement has been done at saturated temperature and in a steady state. Both TiO₂-coated and non-coated surfaces were used for comparison. In the case of the TiO₂-coated surface, it is exposed to UV light for a few hours before experiment and it is found that the maximum heat flux (CHF) is about two times larger than that of the uncoated surface. The temperature at minimum heat flux (MHF) for the superhydrophilic surface is higher by 100 K than that for the normal one. The superhydrophilic surface can be an ideal heat transfer surface. Copyright © 2002 John Wiley & Sons, Ltd.     

简并量子拍频三能级系统中的光场压缩效应

本文讨论了V-型简并量子拍频三能级原子与单模相干辐射场相互作用时的动力学行为，并研究了光场的压缩效应。     

测量输入光窗台阶指标的指示表的选择

阐述了对近贴聚焦型微通道板像增强管中输入光窗台阶高度和平整度指标进行测量时，所用指示仪表的选择依据，并详细分析了指示表在检定过程中的误差来源，进一步计算出其合成标准不确定度和扩展不确定度，从而选定可用于测试的指标表。     

轻型钢结构吊车梁设计方法及节点构造

通过分折和研究单层门式刚架轻型钢结构厂房中的吊车梁设计，总结了轻型钢结构吊车梁的设计方法和节点连接构造，对合理设计吊车梁，降低用钢量提出了设计建议。     

轻质油中C1—C7轻烃的地球化学特征

作者对5个盆地18个轻质油样品作了C_1—C_7轻烃分析,检测出29种单体轻烃。通过轻烃组成特征研究,认识到石蜡指数(PI_1)和庚烷值(PI_2)作为成熟度的指标,不受沉积盆地类型影响;C_6,C_7烃类族组分受母质类型影响较大。陆相(含煤地层)有机质生成轻质芳烃(苯)的含量比海相有机质要高。新疆塔里木盆地沙参2井原油的轻烃分析资料表明,该井油源岩为海相沉积。     

雅克拉凝析气田高压脱水工艺的成功应用

雅克拉凝析气田位于新疆阿克苏境内，2005年11月29日建成投运的260×10⁴m³/d雅克拉集气处理站是目前中石化最大的高压凝析气处理装置。该站的高压分子筛脱水工艺为两塔流程，采用差压再生（吸附压力5.9 MPa、再生压力2.8 MPa）、再生气自动回收工艺技术，并采用时序控制程序自动切换，具有工艺简单可靠、自动化程度高、热能利用率高、脱水露点深度高、操作维护简单、投资较少、运行成本低等优点，自建成投产以来运行稳定，效果十分显著。该工艺装置的成功应用，对类似脱水装置设计、操作具有一定参考价值。     

Identification of gaps in mangrove forests with airborne LIDAR

Mangrove forests change frequently due to disturbances from tropical storms, frost, lightning, and insects. It has been suggested that the death and regeneration of trees in small gaps due to lightning may play a critical role in mangrove forest turnover; however, the large-scale quantification of spatial pattern and areas of gaps is lacking for investigating this issue. Airborne light detection and ranging (LIDAR) technology provides an effective way for identifying gaps by remotely obtaining direct measurements of ground and canopy elevations. A method based on an alternative sequential filter and black top-hat mathematical morphological transformation was developed to extract gap features. Comparison of identified gap polygons with raw LIDAR measurements and field surveys shows that the proposed method successfully extracted gap features in mangrove forests in Everglades National Park. There are 400–500 lightning gaps per square kilometer in mangrove forests at the study sites. The distribution of gap sizes follows an exponential form and the area of gaps with sizes larger than 100 m² account for 55–61% of the total area of gaps. The area of gaps in the mangrove forest in Everglades National Park is about 4–5% of the total forest area and the average gap formation rate is about 0.3% of the total forest area per year, indicating that lightning gaps play an important role in mangrove forest dynamics.     

住宅电气设计中应注意的细节问题

就住宅电气设计中，常常被忽略的细节问题进行阐述，提出了在住宅室内几个功能区内，如何使灯具和插座的布置更合理，以最大限度地满足居住者的需求。     

浅谈侧窗采光和门窗节能措施

充分利用天然光，改善门窗的绝热性能，是建筑节能的重点手段。     

活性炭吸附法脱除加氢催化柴油中的硫化物

采用5种活性炭对加氢催化柴油进行吸附脱硫,通过对活性炭的吸附效果及工艺参数的研究,探索了活性炭吸附脱硫最适宜的工艺条件。实验结果表明,分别选用比表面积为854.97,1 108.61 m2/g,相应微孔平均孔径为0.581 4,0.627 4 nm的活性炭,在粒度为40~80目,流速为0.25 mL/m in,吸附柱高径比为30/1的条件,可将不同原料油中有机硫含量分别从1 354.96,665.50μg/g降至360.40,69.61μg/g,脱硫率分别为73.40%和89.54%;在20~100℃时,随着温度的升高,活性炭吸附脱硫效果增强。