Separation of di- and tripeptides with solvent extraction and an emulsion liquid membrane

The extraction equilibria of various di- and tripeptides with di-2-ethylhexylphosphoric acid (D2EHPA) were studied at low pH values. The complex extracted to organic phase consisted of one molecule of peptide and two molecules of D2EHPA dimer. The extraction constants of the peptides correlated well with the distribution coefficients of peptides between 1-octanol and water, which is a measure of hydrophobicity. The permeation rates of peptides through an emulsion liquid membrane were examined by using D2EHPA as a carrier, Span 80 as an emulsifier and kerosene as a diluent. The rates varied considerably with peptide type, depending upon the hydrophobicity.     

中温低氰液体碳氮共渗及其应用效果

通过金相、硬度、耐磨性等测试分析表明，在“６０３”液体渗碳基础上研制出的新型中温低氰液体碳氮共渗剂对薄片件进行薄层碳氮共渗．能完全满足技术要求，并且取得了良好经济和社会效益．     

用二甲基二氯硅烷水解物代替混合环体生产107甲基室温硫化硅橡胶

分析了１０７甲基室温硫化硅橡胶生产中造成粘度波动和收率较低的因素，通过改变原料，用二甲基二氯硅烷水解物代替甲基混合环体，提高了产品收率、降低了成本，粘度也易于控制     

棉铃宝高效液相色谱分析方法研究

本法采用同一色谱条件反相高效液相色谱法测定棉铃宝中甲基对硫磷和辛硫磷的含量，方法简单易行，具有较高的精密度和准确度，其回收率分析为甲基对硫磷９９．５９％，辛硫磷１０１．０％。     

马来酸酐在乙丙橡胶上的接枝共聚

马来酸酐在乙丙橡胶上的接枝共聚,用过氧化苯甲酰为引发剂的效果优于偶氮二异丁腈。研究了温度、马来酸酐用量和引发剂用量等对接枝率的影响。用红外光谱和薄层色谱证明了接枝物的存在。用接触角技术测定了接枝物的表面性能。     

结晶器液面自动控制系统在唐钢板坯连铸机的应用

介绍了涡流法和同位素法2种结晶器钢水液面自动控制检测方式,及其在唐钢板坯连铸机的应用.     

Stabilization of bioethanol recovery with silicone rubber‐coated ethanol‐permselective silicalite membranes by controlling the pH of acidic feed solution

In order to produce highly concentrated bioethanol by pervaporation using an ethanol‐permselective silicalite membrane, techniques to suppress adsorption of succinic acid, which is a chief by‐product of ethanol fermentation and causes the deterioration in pervaporation performance, onto the silicalite crystals was investigated. The amount adsorbed increased as the pH of the aqueous succinic acid solution decreased. The pervaporation performance also decreased with decreasing pH when the ternary mixtures of ethanol/water/succinic acid were separated. Using silicalite membranes individually coated with two types of silicone rubber, pervaporation performance was significantly improved in the pH range of 5 to 7, when compared with that of non‐coated silicalite membranes in ternary mixtures of ethanol/water/succinic acid. Moreover, when using a silicalite membrane double‐coated with the two types of silicone rubber, pervaporation performance was stabilized at lower pH values. In the separation of bioethanol by pervaporation using the double‐coated silicalite membrane, removal of accumulated substances having an ultraviolet absorption maximum at approximately 260 nm from the fermentation broth proved to be vital for efficient pervaporation. Copyright © 2005 Society of Chemical Industry     

板坯连铸涡流检测钢水液位系统的应用

介绍了新一代RAM型涡流传感钢水液位控制仪在莱钢板坯连铸机上的应用及其效果。     

Development of a Magnetic Suspension Densimeter and Measurement of the Density of Toluene

The development of a magnetic suspension densimeter that has been built for measurement of the density of compressed liquid at pressures up to 30 MPa in the temperature range 20 to 150°C is described. The densimeter was first built by the author and his coworkers at NIST. We describe here further improvements made on a second system built at NMIJ based on the same principle. The densimeter uses a small coil suspended from an electronic balance. Within the coil is placed a sample cell in which the pressurized sample and a buoy, which is a permanent magnet, are enclosed. For measurement of density, balance readings are recorded (1) with the buoy at rest and (2) with the buoy in magnetic suspension. The measurement procedure is basically a hydrostatic weighing, which is simpler than those of conventional magnetic densimetry. As an example, measurements of toluene density performed as part of an inter-laboratory comparison are presented. The data agreed with reliable literature values to within a few hundredths of a per cent.     

竖直狭缝通道中液氮沸腾强化换热的实验研究

实验表明，狭缝间隙对液氮自然对流核态沸腾换热有明显的影响，在低热流密度下，间隙小的狭缝沸腾换热比间隙大的狭缝明显增强，当狭缝间隙小于实验压力下气泡的脱离直径时，对于同样的热流密度，传热温差减小一个数量级以上，沸腾换热系数提高十几倍到二十倍以上，当热流密度增加一定程度（＞4W/cm^2)时，间隙小的狭缝沸腾换热比间隙大的狭缝有所减弱。