Electrochemical properties of ultra-long,aligned, carbon nanotube array electrode in organic electrolyte

The electrochemical properties of an electrochemical double-layer capacitor electrode based on an ultra-long (500 μm), aligned, carbon nanotube array (ACNTA) in Et₄NPF₆/propylene carbonate electrolyte are examined. The specific capacitance of the ACNTA electrode in an organic electrolyte is 24.5 F g⁻¹, which is larger than that obtained in an aqueous electrolyte. The results of ac impedance measurements show that the ACNTA electrode gives a high power density and an excellent rate capability in an organic electrolyte. It is shown that the ACNTA electrode has a lower equivalent series resistance and a better rate capability than activated carbon electrode. This is due to the fact that ACNTA possesses a larger pore size and a more a regular pore structure. Both these features are conformed by scanning electron microscopic and nitrogen gas adsorption studies.     

离子交换法合成三氨基胍叠氮酸盐

三氨基胍叠氮酸（ＴＡＺ）分子中的含氮量高达８５．７％，燃烧分解时不仅－Ｎ３可释放３６７ｋＪ／ｍｏｌ的键能，而且放出大量的氮气，是一个提高比冲，降低燃烧温度的理想的推进剂两组分之一。     

微波高压提取快速测定饲料含氟量的探讨

采用微波高压制样技术,快速提取饲料中的氟元素,结合氟离子选择性电极标准添加和电位极差测试方法,能够快速、准确地测试饲料中的含氟量     

High concentration erbium doping of silicon-rich SiO2 thin films on silicon

In this work, high concentration erbium doping in silicon-rich SiO₂ thin films is demonstrated. Si plus Er dual-implanted thermal SiO₂ thin films on Si substrates have been fabricated by using a new method, the metal vapor vacuum arc ion source implantation with relatively low ion energy, strong flux and very high dose. X-Ray photoelectron spectroscopy measurement shows that very high Er concentrations on the surfaces of the samples, corresponding to 10 at.% or the doping level of 10²¹ atoms cm⁻³, are achieved. This value is much higher than that obtained by using other fabrication methods such as the high-energy ion implantation and molecular beam epitaxy. Reflective high-energy electron diffraction, atomic force microscopy and cross-section high-resolution transmission electron microscopy observations show that the excess Si atoms in SiO₂ matrix accumulate to form Si clusters and then crystallize gradually into Si nanoparticles embedded in SiO₂ films during dual-ion implantation followed by rapid thermal annealing. Er segregation and precipitates are not formed. Photoluminescence at the wavelength of 1.54 μm exhibits very weak temperature dependence due to the introduction of Si nanocrystals into the SiO₂ matrix. The 1.54-μm light emission signals from annealed samples decrease by less than a factor of 2 when the measuring temperature increases from 77 K to room temperature.     

碱-碳酸盐反应热力学讨论

应用热力学方法探讨了温度对碱 碳酸盐反应的影响 ,反应温度升高时 ,反应的推动力减弱。对碱与碳酸盐发生反应生成沉淀时所需碱的浓度以及温度的影响进行了讨论。 2 98K ,pH≥ 10 .6时 ,碱 碳酸盐反应能发生 ,反应温度升高 ,碱 碳酸盐反应所需碱的浓度相应增大。对氢氧化锂与碳酸盐反应可能生成碳酸锂沉淀时溶液的碱的浓度作了计算 ,2 98K ,pH≥ 13.1时 ,氢氧化锂与碳酸盐反应除生成水镁石和方解石外还能生成碳酸锂沉淀 ,反应温度升高时 ,反应生成碳酸锂沉淀所需碱的浓度变化不大     

Study of Lateral Spread of Ions Emitted from 2.3 kJ Plasma Focus with Hydrogen and Nitrogen Gases

The characteristics of ion beams of hydrogen and nitrogen with different filling pressures emitted from the plasma focus device of 2.3 kJ energy are investigated. CR-39 SSNTDs are employed for the registration of tracks of ions. The exposed detectors are etched in 6N NaOH solution at 70°C and then examined with an optical microscope. The ion flux is estimated to be of the order of 10^5–6 tracks/cm². The flux with the radial position does not exhibit any regular pattern of variation.     

抽余C_4烃中异丁烯催化逆流水合制叔丁醇

采用大颗粒离子交换树脂催化剂,在φ100mm×10m的反应器中进行了异丁烯催化逆流水合制叔丁醇的中间试验。考察了反应温度、水油体积比和抽余C4烃的流速等对异丁烯转化率的影响。试验结果表明,异丁烯催化逆流水合制叔丁醇的适宜操作条件为:反应温度80~90℃,水油体积比为4~5,抽余C4烃的流速为0.45~0.55mm/s。在此条件下,异丁烯的转化率可达88.8%。工业装置运转结果表明,异丁烯转化率大于75%。     

内热式液态合金离子源

本文介绍了一种实用的液态合金离子源结构，我们利用本结构研制成功了Ａｕ－Ｓｉ和Ａｕ－Ｓｉ－Ｂｅ液态合金离子源，测出了它们的发射特性。     

Macroscopic model for multispecies ion-exchange kinetics

A model for multispecies ion-exchange kinetics based on the Nernst-Planck equation is suggested. It is analyzed in comparison with the “locally-determinate” model described by Hwang and Helfferich [1]. The model makes possible simple computation. The conditions for the occurrence of unusual kinetic curves with a maximum are clarified. The proposed model is developed for different types of kinetic problems and verified by the experimental investigation of a kinetics in ternary systems.     

离子注入硅的线源非相干光瞬时退火温度计算

本文利用高温模型,计算了在我们的实验条件下对离子注入硅进行线源非相干光瞬时退火的退火温度,并与实验结果比较,两者符合得较好。