稀土硝酸盐与邻香草醛缩邻氨基苯甲酸配合物的合成与表征

由邻香草醛缩邻氨基苯甲酸（以Ｈ２Ｌ表示）与稀土硝酸盐作用合成了３种新固体配合物。并对合成的配合物进行了元素分析、红外光谱、紫外光谱、差热—热重及摩尔电导分析，确定配合物的组成为〔Ｌｎ（ＨＬ）（ＮＯ３）（Ｈ２Ｏ）〕ＮＯ３（Ｌｎ＝Ｄｙ，Ｅｒ，Ｔｍ）。研究了配合物的配位方式和某些物理化学性质。     

The chloride stress-corrosion cracking behavior of stainless steels under different test methods

Chloride-induced stress-corrosion cracking (SCC) is one of the failure modes of stainless steels. Highly alloyed austenitic stainless steels S32654, S31254, and N08028, and duplex grades S32750 and S31803 possess much improved resistance to SCC compared with S30400 and S31600 steels. With the development of a database, SSData, experimental data collected from calcium chloride tests, autoclave tests, and drop evaporation tests were evaluated. Stress-corrosion cracking data generated by autoclave tests agreed well with the practical service conditions and can be used to discriminate alloys for SCC resistance in sodium chloride solution. Drop evaporation test data can be used in situations where evaporation may occur and cyclic loading may be involved. The SCC resistance of alloys under each method increased with increasing molybdenum equivalent Mo + 0.25Cr + 0.1Ni. For a given alloy, the testing result depends on the stress state and environment; different test methods can give different ranking orders concerning SCC resistance. The performance of duplex stainless steels in a chloride-containing environment at higher temperatures was not as good as expected when dynamic loading was involved.     

镁合金表面喷铝防腐蚀层的微观组织分析

在AZ91D镁合金表面热喷铝，用以提高其表面的耐腐蚀性能。采用SEM，EPMA等方法对AZ91D表面喷铝扩散层的组织进行了仔细的观察与分析，发现在防腐蚀层上有大量的Mg17Al12相存在，且呈决状及非连续片状分布。经显微硬度测定，喷铝层硬度较镁合金基体高；腐蚀后这种相凸出于基体，比镁合金基体有较好的耐腐蚀性能。     

硝酸铵的膨化机理研究

膨化硝酸铵是一种自敏化改性硝酸铵,由硝酸铵溶液在专用表面活性剂作用下,经真空强制析晶工艺制得.文中研究了膨化硝酸铵制备的膨化过程和专用表面活性剂的作用,结果表明:在真空和表面活性剂作用下,硝酸铵溶液由不饱和状态至饱和状态,进而达到过饱和状态,最终导致硝酸铵的快速结晶和体系的膨胀.在真空干燥过程中,形成中心空穴、微细孔道和裂缝,它们使膨化硝酸铵的起爆感度提高;专用表面活性剂具有降低硝酸铵溶液表面张力、发泡剂和加快结晶成核的作用.     

Direct electroless Ni-P deposition on AM50 magnesium alloy from sulfate bath

A bright electroless Ni-P deposition on AM50 magnesium alloy in a sulfate plating bath was proposed by using direct plating process with non-chromate pretreatment. The electroless Ni-P plating on AM50 magnesium alloy has an admirable appearance and good adhesion. The results indicate that the electroless Ni-P deposition with non-chromate pretreatment has better adhesion than that of zinc immersion coating. Anodic polarization curves indicate that the electroless Ni-P deposition obtained from the sulfate bath has similar corrosion-resistance to that obtained from basic nickel carbonate bath. The deposition process generates less pollutant by a non-chromate plating bath and is suitable for the magnesium alloys manufacture because of its low cost. The hardness of the electroless Ni-P plated AM50 is about HV 720.6 and HV 969.7 after heat treatments at 180℃ for 2 h. The wear resistance of Ni-P plated magnesium alloy specimens is about 5 to 9 times as high as that of bare magnesium alloys.     

The influence of NaCl and CO2 on the atmospheric corrosion of magnesium alloy AZ91

The influence of NaCl and CO₂ on the atmospheric corrosion of magnesium alloy AZ91 is studied in the laboratory. Samples were exposed under carefully controlled air and flow conditions; the relative humidity was 95%, the temperature was 22.0°C and the concentration of CO₂ was < 1 ppm or 350 ppm. Different amounts of sodium chloride (0–70 μg/cm²) were added before exposure. The corrosion products were analyzed by gravimetry, ion chromatography, X‐ray diffraction and scanning electron microscopy. Mass gain and metal loss results are reported. The combination of high humidity and NaCl is very corrosive towards AZ91. However, the NaCl‐induced corrosion is inhibited by ambient concentrations of CO₂. Exposure in the absence of CO₂ gives rise to heavy pitting, with brucite, Mg(OH)₂, being the dominant corrosion product. In the presence of CO₂ a layer of hydrated magnesium hydroxy carbonate, Mg₅(CO₃)₄(OH)₂ · 5 H₂O forms. A tentative corrosion mechanism is presented that explains the behavior in the two environments.     

Oxidative radical generation via nitrogen dioxide dimer conversions induced by amide groups of macromolecules

The features of initiation of free radical reactions in polymers by dimers of nitrogen dioxide are considered. The conversion of planar dimers into nitrosyl nitrate in the presence of amide groups of macromolecules has been revealed. Nitrosyl nitrate initiates radical reactions in oxidative primary process of electron transfer with formation of intermediate radical cations and nitric oxide. As a result of subsequent reactions, nitrogen‐containing radicals are produced. The dimer conversion has been exhibited by estimation of the oxyaminoxyl radical yield in characteristic reaction of p‐benzoquinone with nitrogen dioxide on addition of aromatic polyamide and polyvinylpyrrolidone to reacting system. The isomerization of planar dimers is efficient in their complexes with amide groups, as confirmed by ab initio calculations. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

氯氧镁水泥对不饱和树脂的阻燃性能与阻燃机理研究

采用极限氧指数法、热重分析和烟密度测试法研究了氯氧镁水泥在不饱和树脂（UP）中的阻燃作用和阻燃机理。研究表明经偶联剂处理后的氯氧镁水泥对UP具有良好的阻燃抑烟效果，并通过增加UP在高温下的热稳定性和降低热失重速率等机理发挥阻燃作用：氯氧镁水泥含量在40％内对UP的力学性能影响较小，是一种新型的无机添加型阻燃剂。     

共沉淀法制备锰锌软磁铁氧体前躯体共沉过程中钙、镁深度脱除的热力学分析

通过对Fe(Ⅱ)-Mn(Ⅱ)-Zn(Ⅱ)-Ca(Ⅱ)-Mg(Ⅱ)-NH3-NH4HCO3-H2O体系的热力学分析，得到各金属离子浓度与pH的关系，从而确定共沉法制备锰锌软磁铁氧体前躯体共沉过程中钙、镁深度脱除的共沉区域。热力学分析结果表明，溶液中钙、镁的含量随着体系pH的增大而降低，在相同条件下镁的溶解度大于钙的溶解度。为减少进入共沉粉中的钙、镁含量，需要保证在铁、锰、锌共沉完全的基础上降低体系的pH。当溶液中[C]T=0．1mol／L，[N]T=1．0mol／L时，pH控制在6．23～6．50之间可以大大降低进入共沉粉中的钙、镁含量。确定共沉过程钙，镁深度脱除的共沉区域，对于生产高纯锰锌软磁铁氧体前躯体具有重要的指导意义。