Synthesis of silicon oxynitride by infiltration-mediated combustion

Silicon oxynitride Si₂N₂ O was synthesized from a mixture of Si, SiO₂, and Si₃N₄ by infiltrationmediated combustion in nitrogen gas. The chemical/phase composition of product and process parameters (temperature and burning velocity) were studied upon variation in charge composition and initial pressure of gas reagent. Parameters of the reaction yielding single-phase Si₂N₂O have been optimized.      

CH_4、CO_2与O_2制合成气的研究 Ⅱ工艺条件的影响

在固定床反应器中考察了１２％Ｎｉ－５％ＲＥ－２％Ｃｕ－２％Ｌｉ／Ａｌ２Ｏ３（ｍａｓｓ）催化剂在ＣＨ４、ＣＯ２与Ｏ２催化氧化重整制合成气反应中催化剂粒径、工艺操作条件（空速与温度）及原料气配比对反应的影响，确定了较佳的操作条件：催化剂粒径２０～４０目，反应最佳温度为８００℃，ＳＶ＝４×１０４ｍｌ／（ｇ·ｈ）。同时看到在不同的原料气配比的条件下该催化剂的活性亦很稳定，不仅达到了反应平衡，且产物Ｖ（ＣＯ）／Ｖ（Ｈ２）比有很强的调变性。     

Oxidation of methane over platinum in a solid proton-conducting electrolyte cell

Studies of the complete oxidation of methane on a Pt electrode-catalyst in the cell with a solid proton-conducting electrolyte (CH₄ + O₂, Pt ¦ SrCe_0.92Dy_0.08O₃ ¦ Pt, H₂O + N₂) were carried out. The non-Faradaic effect of electrochemical hydrogen pumping on the rate of methane oxidation has been demonstrated. The induced change in the reaction rate at anodic polarization of a Pt electrode-catalyst was over two orders of magnitude higher than the rate of hydrogen pumping from the reaction zone through the electrolyte.     

甲烷和乙烷共同转化制乙烯的研究

甲烷和乙烷可以同时在Ｗ－Ｍｎ／ＳｉＯ２催化剂上得到活化生成乙烯。原料乙烷和甲烷体积比在０．１１～０．２５的范围内，当甲烷转化率为２０％左右时，共进料反应产物中乙烯体积浓度为８％～１２％，达到炼油厂催化裂化干气中乙烯的浓度。     

乙烯裂解炉辐射段流动与燃烧的三维数值模拟

用计算流体力学软件Fluent6.2对中国石油化工股份有限公司燕山分公司E-BA-107乙烯裂解炉辐射段内的流动和燃烧做了三维数值模拟研究。为保证计算的准确性,使用GAMBIT2.2软件建立了与裂解炉实际尺寸完全一致的几何模型;在计算过程中采用了标准k-ε湍流模型、离散坐标辐射模型和有限速率/涡流耗散燃烧反应模型等计算模型。通过模拟计算得到了裂解炉炉膛内的温度、烟气流速及烟气组成的分布:底部燃烧器和侧壁燃烧器的燃烧使附近的炉墙处于温度分布均匀的高温区,为裂解反应提供了均匀的辐射墙面;炉管底部比其他部位的温度低;底部燃烧器的高速射流产生的旋涡可为炉管提供一定的对流热;出口烟气的平均温度和组成的模拟计算值与设计值接近,表明数值模拟有较高的精度,具有实际意义。     

燃气不换向蓄热式熔铝炉

蓄热式熔铝炉是一项先进节能技术，但至今在铝行业普及率不高，主要是一次性投资较大，维修费用较高。新近开发的燃气不换向蓄热式烧嘴，设备投资少、系统简化、设备故障少，使用安全可靠。     

High-Pressure (up to 140 MPa) Dynamic Viscosity of the Methane and Toluene System: Measurements and Comparative Study of Some Representative Models

The dynamic viscosity of toluene and methane mixtures containing 25.03, 37.19, 49.95, 64.11, and 95.00 mol% methane has been measured using a falling-body viscometer. The measurements (280 data points) have been performed in the temperature range 293.15 to 373.15 K and at pressures up to 140 MPa. The data have been discussed in the framework of recent representative models (hard-sphere scheme, friction theory, and free-volume model) as well as with simple mixing laws and empirical models (particularly the LBC model and the self-referencing model) used in the literature. This comparative study shows that the average absolute deviation of the models is between 4.9 and 26.8%, and the maximum deviation is between 11.6 and 49.5%.     

汽油机爆震强度的分析

分析了汽油机缸内气体爆震燃烧压力的频率特性并推导了爆震压力共振频率计算公式。研究表明：在爆震工况下，缸内压力在高频域中有几个共振峰，峰的大小表明了汽油机爆震强度。汽油机的表面振动在这些共振频率峰处也出现相应振动峰。表面振动峰与缸力压内峰值近似成正比。汽油机表面振动峰值可作为爆震强度的评价指标，该结论在ＣＡ１１０２汽油机上得到了证实。     

Anaerobic digestion of alkaline black liquor using an up-flow anaerobic sludge blanket reactor

The anaerobic digestion of alkaline black liquor from a cereal straw pulping mill was studied in batch (serum bottles) and continuous systems (up-flow anaerobic sludge blanket reactor—UASB). The batch digestion studies confirmed that lignin and related compounds (LRC) in the alkaline black liquor were the main inhibitory substances and could not be decomposed by anaerobic bacteria. At organic loading rates of 5–10 kg COD m^?3 day^?1, the UASB reactor achieved 50–60% COD removal efficiencies. Gas production was 2–3 dm³ per dm³ of alkaline black liquor. Two different sludge types were examined in the reactor: granular and cluster-like sludges. Sludge in a cluster, which involved many small granules and flocs, tended to form larger aggregates and possessed good settling ability.     

降低锅炉飞灰可燃物的途径

介绍在发电厂锅炉运行过程中降低燃烧低挥发分高热值燃料飞灰含碳量的途径