铁氧体法处理沉镍残液研究

采用铁氧体法处理沉镍残液,此法处理沉镍残液效果明显。研究了pH值、温度、搅拌时间、投料比对处理效果的影响。试验结果表明:在pH=11~12,温度50℃,搅拌时间25~30 min,投料比10的操作条件下,处理后的沉镍残液中各重金属离子浓度均达到排放标准。     

光谱法研究Ni[S2P（OCH2CH2Ph）2]2与α,α＇-联吡啶加合反应

利用紫外光谱法研究了Ni[S2P（OCH2CH2Ph）2]2与α,α-联吡啶的加合反应。研究发现Ni[S2P（OCH2CH2Ph）2]2与α,α-联吡啶形成1∶1型加合物,在25℃的苯溶剂中,加合物的离解度α=0.07,稳定常数K稳^θ=2.1×10^6。     

硅基底上制备纳米镍粒子

采用微波加热法在单晶硅基底上制备纳米镍粒子。考察了镍源、还原剂、表面活性剂、加热方式等实验条件对单晶硅基底上制备纳米镍粒子的影响。对硅基底上纳米镍粒子的成分、结构及表面形态进行了表征。结果表明:以水合肼为还原剂、氯化镍为镍源,微波加热3 min在硅基底上可以制备出直径为30 nm的均匀单一分布的纳米镍粒子。     

含铁低镍白色金合金镍渗出及抗变色性能

研究Fe元素部分取代镍对白色金合金镍渗出以及抗变色性能影响.指出当Fe等元素取代合金中的部分Ni元素后,由于镍含量降低,合金的镍释放率出现下降,镍降低导致表面镍钝化膜的破坏.当镍质量分数低于2.5%时,合金的镍释放量反而升高.Fe对合金的漂白效果弱于镍,Fe的加入会导致合金抗变色性能降低.均匀化退火热处理对该实验系列金合金材料的抗变色性能影响不大,但可减少合金成分的偏析,有效降低合金的镍渗出量.     

Antiferromagnetic Exchange Interactions. Part 1. Newly Reported Nickel(II) Complex of the Antiprine Schiff Base of 3-Formylsalicylic Acid

This study reports the magnetic properties of newly reported nickel(II) complex of the antiprine Schiff base of 3-formylsalicylic acid. Using the isotropic magnetic interaction model it is suggested that there is a strong antiferromagnetic interactions between metal centers in dimeric units. It is also suggested that the system become demagnetized below a certain temperature. An erratum to this article can be found at     

导电有机硅密封剂的研究

以镀银镍粉为导电填料、端羟基聚二甲基硅氧烷为基胶、经硅烷表面处理的白炭黑为补强填料,有机锡为催化剂,制成了高导电室温硫化双组分有机硅密封剂;研究了导电机理、镀银镍粉的加入量对有机硅密封剂的导电性能和电磁屏蔽性能的影响。结果表明,当镀银镍粉的体积分数超过25%时,有机硅密封剂的电性能明显提高;当镀银镍粉的体积分数达到35%以上时,有机硅密封剂的体积电阻率下降近10个数量级;当镀银镍粉的体积分数为50.5%时,有机硅密封剂在高频率范围具有良好的电磁屏蔽性能。     

The effect of sulfur on the dissociative adsorption of methane on nickel

The dissociative adsorption of methane was carried out on a Ni(100) surface covered with various amounts of sulfur under the high incident flux conditions of 1 Torr methane. Auger electron spectroscopy was used to measure the rate of carbon buildup and thus to determine the initial methane decomposition rates on the surface. It was shown that the sulfur atoms poison this reaction by a simple site-blocking process. These results are consistent with the activated dissociative adsorption of methane on Ni(100) occurring via a direct adsorption process.     

（Nb，Ti）C－Ni金属陶瓷的抗氧化性

用热等静压方法制备了（Ｎｂ，Ｔｉ）Ｃ－Ｎｉ金属陶瓷并作了８５０℃，９００℃，１０００℃及１１００℃下的等温氧化和室温～１１００℃的不等温氧化试验。在高温下，该金属陶瓷的表面被氧化成ＴｉＯ＿２，ＮｉＯ，ＮｉＴｉ＿３。认为Ｏ＿２通过氧化层向反应界面的扩散是控制氧化速率的主要步骤。氧化增重遵循抛物线规律，其激活能约为２３４ｋＪ／ｍｏｌ。     

催化加氢制备3,4-亚甲二氧基苯胺

3,4 亚甲二氧基硝基苯在95%乙醇溶剂中用雷尼镍催化加氢制备了3,4 亚甲二氧基苯胺。对催化剂用量和活性稳定性进行了研究,讨论了溶剂用量、温度、压力等因素对加氢反应的影响。结果表明最佳工艺参数为:雷尼镍∶乙醇∶3,4 亚甲二氧基硝基苯=0.15∶6∶1(质量比),反应温度40℃,氢压0.45～0.50MPa,搅拌速度450r/min,反应至不再吸氢为止,产品收率在97%以上,纯度为98%。     

Oxidation and intergranular disintegration of the aluminides NiAl and NbAl3 and phases in the system Nb-Ni-Al

The oxidation behavior is very different for an aluminide with a wide homogeneity range such as -NiAl than for a line compound such as NbAl ₃.Oxidation of -NiAl at temperatures 1273 K leads to a slow-growing -alumina layer. The metal phase beneath the scale remains as -NiAl; however, cavity formation is observed. The cavity formation may be favored by sulphur surface segregation. Oxidation of NbAl ₃ at temperatures 1273 K initially leads to -Al ₂O₃,but the Al depletion causes the formation of Nb ₂ Al beneath the oxide layer. Cracking of the Al ₂O₃ layer opens Nb ₂ Al to the atmosphere, which oxidizes rapidly to Nb ₂O₅ and NbAlO₄.After consumption of the Nb ₂ Al, a layer of Al ₂O₃ formed again on the NbAl ₃ phase, but failure of the alumina and the fast growth of the other oxides occur as a repeated process. Thus, NbAl ₃ exhibited rapid linear oxidation kinetics. Multiphase alloys in the system Nb-Ni-Al generally behave better than NbAl ₃,and the low oxidation rates of -NiAl can be approached. In the temperature range below 1273 K, with a maximum at 1000 K, both NiAl and NbAl ₃ show the pest phenomenon, an intergranular disintegration. Preceding the disintegration, oxygen diffuses into the grain boundaries of the material and Al ₂O₃ is formed at the grain boundaries, beginning from the surface region. NiAl is susceptible only in a very limited range of oxygen pressures and temperatures, whereas NbAl ₃ is much more susceptible.