Ti,N,Mg对M2高速钢凝固组织和硬度的影响

为了改善Ｍ２高速钢共晶碳化物的分布，本文利用小凝固试样变质的方法研究了Ｔｉ，Ｎ和Ｍｇ对Ｍ２高速钢凝固组织和硬度的影响。试验结果表明，加入Ｔｉ或Ｔｉ－Ｎ后，共晶碳化物形态和分布有很大改善，而加入Ｔｉ－Ｎ后对凝固组织有轻微的细化作用，但只添加Ｔｉ不补碳时，钢的淬火硬度和回火硬度均下降；加入适量的Ｍｇ可以使片状的Ｍ２Ｃ型共晶碳化物转为鱼骨状的Ｍ６Ｃ型共晶碳化物，使其分布有所改善，Ｔｉ和Ｍｇ复合加入可以明     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

煤气压缩机存在问题及改造措施

对煤气压缩机运行以来所存在的问题进行了分析，相继采取的改造措施及取得的效果作了探讨。重点阐述了油冷却器的改造。     

土壤因子对植物缺铁失绿的影响

本文主要从土壤 pH ,重碳酸盐 ,和氮素形态等几方面综述了各种土壤因子对土壤缺铁失绿的影响 ,并提出了进一步加强研究的方向     

竖直狭缝通道中液氮沸腾强化换热的实验研究

实验表明，狭缝间隙对液氮自然对流核态沸腾换热有明显的影响，在低热流密度下，间隙小的狭缝沸腾换热比间隙大的狭缝明显增强，当狭缝间隙小于实验压力下气泡的脱离直径时，对于同样的热流密度，传热温差减小一个数量级以上，沸腾换热系数提高十几倍到二十倍以上，当热流密度增加一定程度（＞4W/cm^2)时，间隙小的狭缝沸腾换热比间隙大的狭缝有所减弱。     

离心式空压机轴承技术改造

针对离心式空压机各级轴振动值超标的现象进行技术攻关,解决了制约装置安全平稳生产的瓶颈问题。     

DO浓度对SUFR系统同步硝化反硝化的影响

采用螺旋升流式反应器（SUFR）处理生活污水，考察了好氧反应池中DO浓度对其同步硝化反硝化的影响。结果表明，在好氧反应池上部溶解氧浓度为3．0～3．5mg／L时，发生了明显的同步硝化反硝化现象，其对TN的去除量占SUFR系统对TN去除总量的16％左右；好氧反应池中的同步硝化反硝化反应只发生在池的下部，其中、上部只进行了好氧硝化反应；SUFR系统中好氧反应池上部的最佳溶解氧浓度范围为3．0～3．5mg／L，此时系统的硝化和反硝化效果最佳，好氧反应池中的脱氮效果也较好，系统对TN的去除率〉84％。     

丙烯压缩机振动偏高原因分析及解决方法

在丙烯腈生产过程中,发现其关键设备丙烯制冷压缩机轴振动值不断上升,针对此种情况对机组进行了分析与探讨,并制定解决方案。结果表明压缩机转子未采用正确的动平衡试验是造成轴振动的主要原因。采取正确的检维修方案是保证机组长周期运行、装置长周期运行的关键。     

加氢联合装置压缩机组的防喘振控制

阐述了喘振的发生、危害及其控制。介绍了加氢联合装置Triconex的TS-3000控制系统防喘振控制器的特性和各种控制线、防喘振控制的算法和操作。采用该系统后可以有效地实现防喘振控制，提高机组的控制灵敏度、稳定性及工艺生产过程的安全性和可靠性。