Effect of Additives on Magnetic Properties of High Frequency MnZn Power Ferrite

In keeping with the advance of more compact and more power-saving electronic equipment, the demand is increasing for smaller and more efficient switching power supply. Therefore, it is necessary to provide the adequate magnetic power ferrite materials to satisfy the demand. Such ferrite materials have to meet the following main requirement: 1) high initial permeability (μ i ); 2) high saturation magnetic induction (Bs); 3) high Curie temperature (Tc); 4) high electrical resistivity (ρ ); 5)…     

Viscoelastic Windows of Pressure-Sensitive Adhesives

A viscoelastic window (VW) concept has been proposed to identify different types of pressure-sensitive adhesives (PSA's). Such viscoelastic windows are constructed from the values of dynamic storage modulus: G' and dynamic loss modulus G' at frequencies of 10^-2 and 10² rad/sec. These frequencies are chosen because the range covers most of the time scales corresponding to the uses of PSA's at different application rates in performance tests. A four quadrant concept has also been recommended to categorize different types of PSA's based on the location of their VW's on the log-log cross plot of G' and G'. It was found that for most PSA's, the range of G' and G' at room temperature within these selected frequencies falls between 10³ and 10⁶ Pascals. The proposed four-quadrants (top-left hand quadrant of high G' and low G', top-right hand quadrant of high G' and high G', lower left hand quadrant of low G' and low G', and lower right-hand quadrant of low G' and high G') correspond respectively to (1) non-PSA or release coatings (2) high shear PSA's, (3) removable PSA's and medical PSA's and (4) quick and cold stick PSA's. It was also observed that the VW's of general purpose permanent PSA's occupy the central region which straddles part of the four quadrants.     

用屏蔽暂堵技术封堵水平井裂缝性漏层

克拉玛依油田HW702水平井的大斜度段和水平段,将穿越纵向裂缝发育的二叠系佳木河组储层。为安全钻进和保护油层,用超细碳酸钙和磺化沥青复配后加入复合离子钻井液中成屏蔽暂堵的堵漏钻井液。室内用岩心试验,屏蔽暂堵后渗透率可降为0,暂堵深度小于3cm,可用酸化和射孔解堵。现场使用效果也很好,使HW702水平井顺利完钻,并获得工业油气流。     

MODELING WATER LOSS DURING FRYING OF POTATO STRIPS: EFFECT OF SOLUTE IMPREGNATION

The effect of solute impregnation on water loss and oil uptake during potato strip frying was studied. Blanched potato strips were impregnated at 25°C by soaking in a solution of sucrose-NaCl-water, 20-5-75% by weight. After rinsing and air drying, strips were deep fried in sunflower oil at 160, 170 and 180°C. A control treatment, consisting of potato strips blanched but not soaked and later air dried was also conducted. Solute impregnation provided a decrease of the oil uptake. Two models, based on Fick's law were used to describe water loss during frying. The first one is the classic model with an effective moisture diffusion coefficient assumed a constant value. The second model considers that diffusion coefficient varies during the frying process. For a given frying temperature, constant diffusion coefficient for control potatoes resulted in lower values than the impregnated ones. The variable diffusivity model showed a two-stage behavior: during the first stage of frying, diffusion coefficient increased with frying temperatures, but from a given time on an inverse behavior began. This last fact was found to be related to an increase of the measured peak force needed to penetrate the potato crust.     

Ti 离子注入 LiNbO_3表面光学性能

本文研究了 x,y,z 三种切向的 LiNbO_3单晶片注入350keV 高能 Ti 离子(注入剂量为1.5×10~(17)/cm~2)后的表面光学性能。利用光谱仪及 AUEL 椭偏仪对三种切向 LiNbO_3试样在不同工艺处理后的光透射率及折射率进行了测试。注入损伤造成的光损耗可通过热处理消除,使晶格结构恢复至与完整晶格排列相近;注入层的折射率可增加11—13％左右。     

浅谈天馈线电压驻波比对微波电路的影响

天馈线电压驻波比是微波电路运行的重要指标，通过典型事例来阐述天馈线电压驻波比的劣化对微波电路的影响，并根据多年实践经验提出天馈线维护需注意的事项。     

一种新型谐振腔增强型光调制器结构的研究

提出了一种新型谐振腔增强型(RCE)光调制器结构,它由一个对称型谐振腔增强型光调制器和一个高反镜所构成.利用传输矩阵法对该器件的插入损耗及临界吸收厚度进行了模拟分析,并同传统谐振腔增强型光调制器的相关性能进行了比较.分析结果表明,这种结构解决了传统谐振腔增强型光调制器的临界吸收厚度与插入损耗之间相互制约的矛盾,可同时获得低临界吸收厚度和低插入损耗.     

水电站施工期水土流失预测

水电站建设的水土流失问题主要体现在施工期和运行期，并以施工期的影响较为突出．如不采取必要的减免措施，将会对周围生态环境造成无法挽回的损失。本文阐述了水电站建设水土流失的几种常用的预测方法，对水土流失量进行预测，并结合具体工程实例对水电站建设过程中新增水土流失量进行了预测。     

不甩线圈的多星形移相变极

对于某些槽数和极数比的多星形移相变极电机,提出与前人不同的是在两种极数下均不甩去线圈的绕组方案,使绕组利用率高,且线圈及其联接都较简单.这种绕组方案在一种极数下并联支路略有不平衡,其所引起的电机定子铜耗的增加是极其有限的,不致影响电机的正常运行.     

高频MnZn功率铁氧体烧结工艺研究

按照氧化物陶瓷工艺对高频MnZn功率铁氧体烧结工艺条件进行了研究。烧结温度越高，晶粒越大，晶界越薄，电阻率越低，磁芯损耗越大，起始磁导率和烧结密度分别在1240℃和1230℃达到最大值。延长保温时间，可以使晶粒充分生长，晶界变薄，电阻率减小，损耗增大。保温3h后，起始磁导率和烧结密度均可达到最大值。氧分压越低，材料起始磁导率越高，电阻率越小，损耗越大，但氧分压低于5％后烧结密度不再继续增加。