Tc trend in high-Tc superconductors

In our previous works, we have shown that most existing ceramic superconductors can be considered to be built of superconductor-semiconductor composite and we have estimated the change in phonon spectrum of the intrinsic superconductor unit if a semiconductor unit is attached to it. Moreover, the proximity effect under the size quantization condition has been examined in the superconductor-semiconductor composite. Each of the stated effects by itself could causeT _c enhancement in general as more semiconductor blocks are added to the system. We extend our study in this paper to analyze the combined actions of phonon spectral change and proximity effect without size quantization condition onT _c variation in members of the Tl₁ series of high-T _c superconductors. Our results indicate that an optimumT _c is obtained if the stated effects are included in the idealized unit cells of the superconductors made up of a superconductor-semiconductor array.     

提高大直径井眼机械钻速的几项措施

随着我国西部地区石油勘探开发的进展，5000－7000m的深探井所钻数量不断增多，套管程序增加，特别是大尺寸井眼所钻深度明显加大。由于国产大尺寸钻头结构单一、型号少，破岩机械能量和水力能量不足，在易斜井段目前尚无可靠的防斜保直措施，以及钻井液性能不适宜等原因，大尺寸井眼的钻这远远低于215．9mm井眼的钻速。据此，提出了几项可以提高大尺寸井眼钻速的措施：增加大尺寸钻头的种类，采用阶梯式扩眼钻头，强化钻井参数和水力参数，选用中速动力钻具，改善钻井液性能以及采用冲击旋转钻具等。     

高透明耐冲击聚氯乙烯接枝聚合研究

研究高透明耐冲击聚氯乙烯接枝聚合工艺，讨论了加料顺序、复合分散体系以及采用聚集粒子乳液、并用碱性物质调节其ｐＨ值等对接枝聚合物性能的影响，确定了接枝聚合最佳工艺条件。     

泥浆制备中工艺改造的研究

根据室条件下粉磨试验结果，发现球磨过程中筛上料变化存在的突变范围，提出两次加料一次加水可改变泥浆颗粒分布，并找出适宜的加料种类与时间。另外给予测粒度分布提供了宝贵的试验基础数据。     

Direct preparation of particles from liquid suspension for ESEM or SEM analysis

A simplified method for the preparation of particles from liquid suspensions has been developed. Particles are deposited directly on carbon planchets for rapid analysis by environmental scanning electron microscopy or by conventional scanning electron microscopy after an additional drying step. This is accomplished by filtering the liquid through thin carbon planchets. Three different grades of graphite were investigated for their suitability as the source material for these planchets. The high quality isomolded graphite is recommended for the filtration and direct observation of particles by electron microscopy. This technique is demonstrated for particles in hydraulic fluid and aquatic suspended particulate material from a natural water source.     

A polydispersed particle system representation of the porosity for non-saturated cementitious materials

In this paper, the porosity of cementitious materials is described in terms of pore size distribution by means of a 3-dimensional overlapping sphere system with polydispersivity in size. On the basis of results established by Lu and Torquato [B. Lu, S. Torquato, Nearest-surface distribution functions for polydispersed particle systems, Phys. Rev. A 45(8) (1992) 5530-5544] and Torquato [S. Torquato, Random Heterogeneous Media: Microstructure and Macroscopic Properties. Springer-Verlag: New York, 2001] providing relations for nearest-neighbor distribution functions, the volume fraction of pores having a radius larger than a prescribed value is explicitly expressed. By adopting an appropriate size distribution function for the sphere system, it is shown that the pore size distribution of cementitious materials as detected for instance by mercury intrusion porosimetry (MIP), which generally points out several pore classes, can be well approached. On the basis of this porosity representation, the evaluation of the capillary pressure in function of the saturation degree is provided. The model is then applied to the simulation of the saturation degree versus relative humidity adsorption curves. The impact of the pore size distribution, the temperature and the thickness of the adsorbed water layer on these parameters are assessed and analyzed for three model materials having different pore characteristics.     

On-line mass spectrometry system for measurements at single-crystal electrodes in hanging meniscus configuration

We present the construction and some first applications of an On-line electrochemical mass spectrometry system for detecting volatile products formed during electrochemical reactions at a single-crystal electrode in hanging meniscus configuration. The system is based on a small inlet tip made of porous Teflon and a Peek holder, which is brought in close proximity (ca. 10–20 μm) to the electrode surface. The tip is connected to the mass spectrometer by glass and metal tubing. Because of the small amount of gas entering the mass spectrometer, no differential pumping is needed during the measurement. The tip construction and preparation introduced here leads to reproducible voltammetry with very good cleanliness characteristics. The presence of the tip has no significant influence on the blank voltammetry of a Pt(111) in sulfuric acid, and on voltammetric responses for CO adlayer oxidation, methanol oxidation, and hydroxylamine electrochemistry on Pt(111). The formation of gaseous products in these reactions can be followed accurately and is in good agreement with earlier results obtained by other mass spectrometric or spectroscopic techniques. The time response and tailing of the setup is on the order of seconds and mainly determined by the distance between the tip and the electrode.     

Feasibility study on the use of polyallyldiglycol-carbonate cell dishes in TUNEL assay for alpha particle radiobiological experiments

In the present work, we have studied the feasibility of a method based on polyallyldiglycol-carbonate (PADC) films to investigate the effects of alpha particles on HeLa cervix cancer cells. Thin PADC films with thickness of about 20 μm were prepared from commercially available CR-39 films by chemical etching to fabricate custom-made petri dishes for cell culture, which could accurately record alpha particle hit positions. A special method involving “base tracks” for aligning the images of cell nuclei and alpha particle hits has been proposed, so that alpha particle transversals of cell nuclei can be visually counted. Radiobiological experiments were carried out to induce DNA damages, with the TdT-mediated dUTP Nick-End Labeling (TUNEL) fluorescence method employed to detect DNA strand breaks. The staining results were investigated by flow cytometer. The preliminary results showed that more strand breaks occurred in cells hit by alpha particles with lower energies. Moreover, large TUNEL positive signals were obtained even with small percentages of cells irradiated and TUNEL signals were also obtained from non-targeted cells. These provided evidence for the bystander effect.     

Solid State Concepts to Understand Catalysis Using Nanoscale Metallic Particles

New advances in theoretical background and recent experimental results concerning nanometer scale metallic clusters are presented. We will begin by a presentation of the advantages and the limitations of synchrotron radiation techniques to characterise nanometer scale entities. Then, through a review of recent papers, we try to make a link between metallic surfaces and nanometer scale monometallic clusters in the case of the interaction with a small molecule, namely NO.     

高速钢高温形变诱发析出的研究

本文探讨了高速钢在高温形变过程中碳化物析出的行为及奥氏体组织状态对析出的影响。用透射电镜和扫描电镜分析了不同热处理状态奥氏体的组织结构,分析了高温形变过程中碳化物析出的部位,颗粒尺寸及形态。试验表明, 碳化物主要在奥氏体的缺陷处呈点状和点列状析出,大小为20mμ。处于回复状态的奥氏体缺陷诱发碳化物析出,析出碳化物钉札缺陷阻止再结晶进行。当再结晶驱动力较大时,由于动态再结晶充分发展,使缺陷大量消除,碳化物析出显著地减少。