转炉炼钢静态模型的初步探讨

根据转炉炼钢的物理化学反应机理，从质量平衡和能量平衡的计算出发，通过小参数变动，导出了增量式静态模型中矿石方程和供氧方程的系数。所得结论与新日铁资料基本相符。同时，还进行了炉料和产物的计算，分析了改变废钢比对生产的影响。     

The Role of Metastable Atoms in a Homogeneous Atmospheric Pressure Barrier Discharge in Helium

A one-dimensional fluid model for homogeneous atmospheric pressure barrier discharges in helium is presented by considering elementary processes of excitation and ionization including a metastable atom effect. Using this model we investigate the behaviours of the helium metastable atoms in discharges as well as their influence on the discharge characteristics. It is shown that the metastable atoms with a relatively high concentration during the discharge are mainly produced in the active phase of the discharge and dissolved in the off phase. It is also found that the metastable atom collisions can not only provide seed electrons for discharges but also influence the concentration of ions. A reduction of matestable atom density results in a drop in the charged particle densities and causes a qualitative change in the discharge patterns.     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

溶胶—凝胶法制备基于荧光猝灭原理的光纤氧传感器在线监测水中溶解氧

利用氧分子对金属钌化合物的荧光具有猝灭作用的特性,构造出基于荧光猝灭原理的光纤氧传感器。就用于水中溶解氧在线监测的光纤光谱仪的搭建、传感器探头的设制及传感膜的制作过程进行探索,并对传感器的响应性能进行考察。结果表明以联吡啶钌等作为荧光指示剂以溶胶-凝胶法制备的传感膜对溶解氧的响应具有良好的可逆性,稳定性,较快的响应时间和较长的使用寿命。与标准法相对照,用本仪器系统测定了不同盐度的人工海水中的溶解氧浓度,两种方法在不同浓度水平下的溶解氧测定值均无显著性差异。本法的日内和日间RSD在1.7％～5.0％之间。     

Oxidation of porous nanocrystalline titanium nitride. II. Scale structure and composition

We have used x-ray phase analysis to study the composition of the products of reaction between oxygen and nanocrystalline powders with particle sizes 15, 40, 55, and 80 nm, and also specimens pressed (and sintered) from them. The powders were oxidized in air at 100°C (400 h) to 500°C (5 min), while the sintered specimens were oxidized at 600–900°C for 15, 120, and 240 min. In all cases, in the initial oxidation step the oxynitride Ti(O_xN_y) is formed, which over time is oxidized to TiO, Ti₂O₃, Ti₃O₅, TiO₂ (anatase) and TiO₂ (rutile). In the range 600–800°C, formation of a continuous oxide layer and conversion of anatase to rutile slows down diffusion of oxygen in the scale. We have established that at 900°C, the growth rate of the scale thickness increases and so the reflections from the oxynitride are barely noticeable on the diffraction patterns taken from the surface of the oxidized specimen. In these diffraction patterns, along with strong reflections from the rutile, we also observed weak reflections from lower oxides and anatase, which may be due to reaction between oxygen and the titanium ions diffused to the scale surface. We have concluded that at T > 850°C, the mechanism for oxidation of TiN changes. This is due to superposition of counterdiffusion of titanium ions on the diffusion of oxygen. __________ Translated from Poroshkovaya Metallurgiya, Nos. 3–4(448), pp. 72–78, March–April, 2006.     

Phosphorus Inputs to Lake Simcoe from 1990 to 2003: Declines in Tributary Loads and Observations on Lake Water Quality

Total phosphorus (TP) inputs to Lake Simcoe have led to hypolimnetic dissolved oxygen (DO) depletion and loss of cold water fish habitat. Since 1990, efforts have been made to reduce the total TP input to the lake below a defined target of 75 t/year, which was predicted to lead to reductions in spring TP concentration and improvements in end-of-summer hypolimnetic DO concentrations. The total TP load to the lake during the most recent period of record (1998/99-2003/04) ranged from 53 to 76 t/yr and averaged 67 t/yr, compared to an average of 114 t/yr estimated between 1990/91 and 1997/98 (range 85-157 t/yr). Reductions in TP loads from the catchment via tributary discharge (∼26 t) accounted for the majority of the decrease in total load between the two time periods. Total P concentrations decreased significantly in four out of six long-term monitored tributaries; however, concentrations in all six tributaries remain above the level recommended to avoid nuisance plant growth (30 μg/L). Although TP loads to the lake are currently below the target 75 t/yr, excessive growths of filamentous algae and macrophytes continue to be a problem in the nearshore zone. End-of-summer minimum hypolimnetic DO concentrations (average 4.3 mg/L, 1998/99-2003/04) remain substantially below the level (7 mg/L) that is considered protective of lake trout. Efforts to reduce TP loads to the lake therefore need to continue.     

An on-line microcomputer-based respiratory monitor for manual materials handling

The main objective of the present study is to develop a low cost microcomputer-based respiratory system that is capable of computing the oxygen consumption and minute ventilation of individuals engaged in manual materials handling on an on-line basis. The design, specifications, and merits of the system are given. The software package developed was written in assembly language for the IBM AT personal computer.     

Internal-corrosion inhibitors for pipelines in heat-supply systems carrying water with a high oxygen content

The reliability of heat-supply systems is determined primarily by internal corrosion of the pipelines. The concentration of oxygen in the water exerts a major influence on the corrosion. In systems with a standard oxygen content, OéDF-Zn is a highly effective corrosion inhibitor. However, there are systems in which the quality of deaeration of the make-up water of the heat-supply system is low (or deaeration is nonexistent), and the concentration of oxygen is considerably above the standard value. Classed among these systems, for example, are the HWS systems, which are incorporated into closed heat-supply systems. The oxygen concentration in these systems is analyzed to assess the situation. __________ Translated from élektricheskie Stantsii, No. 6, June 2007, pp. 35–39.     

水浴法加温液氧泵

1　故障现象一次 ,我们用KL -1 5型制氧制氮车开机制氮 ,给一只容积为 40升、最高工作压力为1 4 7MPa的气瓶灌充氮气 ,当气瓶充气压力升高到一定值时不再上升。反复开泵 ,压力基本不变。液氧泵停止时 ,出口压力无明显下降。经分析判断导致气瓶压力升高到一定值时不再上升的原因是由于液氧泵被冻结所致。2　排除方法首先关闭液氧泵。拧开制冷机氢气放气阀 ,使压力下降到 1 0MPa。开大放气阀 ,使二级压力保持在 0 3 5MPa左右。调整正流空气调节阀 ,调节好中部温度。关闭液氮进液氧泵阀和气氮出液氧泵阀。戴棉布手套 ,拆开液氮进口接头、…