The influence of NaCl and CO2 on the atmospheric corrosion of magnesium alloy AZ91

The influence of NaCl and CO₂ on the atmospheric corrosion of magnesium alloy AZ91 is studied in the laboratory. Samples were exposed under carefully controlled air and flow conditions; the relative humidity was 95%, the temperature was 22.0°C and the concentration of CO₂ was < 1 ppm or 350 ppm. Different amounts of sodium chloride (0–70 μg/cm²) were added before exposure. The corrosion products were analyzed by gravimetry, ion chromatography, X‐ray diffraction and scanning electron microscopy. Mass gain and metal loss results are reported. The combination of high humidity and NaCl is very corrosive towards AZ91. However, the NaCl‐induced corrosion is inhibited by ambient concentrations of CO₂. Exposure in the absence of CO₂ gives rise to heavy pitting, with brucite, Mg(OH)₂, being the dominant corrosion product. In the presence of CO₂ a layer of hydrated magnesium hydroxy carbonate, Mg₅(CO₃)₄(OH)₂ · 5 H₂O forms. A tentative corrosion mechanism is presented that explains the behavior in the two environments.     

The emulsifying properties of a polysaccharide isolated from the fruit of Cordia abyssinica

Polysaccharide was isolated from Cordia abyssinica and its effect, at differing concentrations, on its emulsifying ability was determined. Emulsions of vegetable oil containing up to 1% of the polysaccharide in phosphate pH 7.4 buffer, were prepared by using a hand piston homogenizer. Emulsification was assessed by diluting samples of the emulsions in sodium dodecyl sulphate and measuring absorbance at 500 nm. Addition of increasing concentrations of the polysaccharide up to 1% enhanced emulsification and emulsion stability. Above 1% concentration the polysaccharide solutions were too viscous for making emulsions conveniently. At a constant concentration of the polysaccharide, addition of up to a 1% concentration of salt enhanced emulsion formation. Further addition of salt above 1% resulted in no further changes in emulsifying ability, but the stability of the emulsions formed decreased on increasing the concentration of salt above 1%. The effect of pH on emulsifying ability was investigated by preparing emulsions using buffers of different pH, from pH 3 to pH 13. The polysaccharide had poor emulsifying ability below pH 7. Emulsifying ability increased with pH between pH 7 and 11. At pH above 11 there was a decrease in emulsifying ability.     

镀锌钢带工艺技术改造

本介绍了将氰化钠镀锌溶液转换为氯化钾镀锌溶液的镀锌工艺过程，从工艺、健康、环保、成本等方面进行阐述。     

N,N′-二(β-十八酰氧基)乙基乙二胺二乙酸钠的合成及性能研究

用 N,N′-二羟乙基乙二胺、氯乙酸钠合成了 N,N′-二羟乙基乙二胺二乙酸钠(中间体),中间体再与硬脂酰氯反应制备了一种新型 Gemini 两性表面活性剂 N,N′-二(β-十八酰氧基)乙基乙二胺二乙酸钠。对产物合成条件进行了考察,优化的反应条件为:n(硬脂酰氯):n(中间体)=2.5,溶剂 V(水):V(氯仿)=1:2,pH=9.0～10.0,反应温度15～20℃,反应时间5 h。通过红外光谱和质谱分析确定了产物结构,并测试了产物的表面性能。结果表明,在25℃时,该产物的临界胶束浓度为0.24 mmol/L,临界胶束浓度下的表面张力为35.7 mN/m;即时泡沫高度为250 mm,5 min 后泡沫高度为220 mm;乳化时间为22.48 min(甲苯-水物系)和4.65 min(正己烷-水物系),亲水-亲油平衡值为5.4,等电点为 pH 3.3～6.5。     

Coincidence Doppler broadening spectroscopy in polyvinyl chloride after doping with Al2O3

Coincidence Doppler broadening of annihilation radiation (CDBAR) and Vickers hardness techniques were performed to study pure Al₂O₃, pure polyvinyl chloride (PVC), and doped PVC with different concentrations of Al₂O₃ (10–50%). The CDBAR ratio curves with respect to pure PVC were presented and reflect the momentum distribution of all the samples. The peak around 14.5 ×10^?3 m_oC in the CDBAR ratio curves suggests a large contribution of positron annihilation with the Al₂O₃. There is a linear correlation between the height of this peak and the Al₂O₃ concentration. The S‐ and W‐parameters were extracted from the CDBAR spectra and increase with increasing the Al₂O₃ concentration showing discontinuity at 30% of Al₂O₃ concentration on PVC. The present data confirmed that there is no positronium formation in pure Al₂O₃ as a result of smaller S‐parameter. The Vickers hardness increases with increasing the Al₂O₃ concentration in PVC showing a linear dependence with two different slopes depend on the Al₂O₃ concentration range. A correlation between the Vickers hardness (macroscopic data) and the W‐parameter (microscopic data) was observed. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

三氯乙酰氯的合成与应用

综述了三氯乙酰氯的合成方法及其在农药、医药等领域中的应用。     

佛尔哈德法测定氯化除汞上清液中的氯量

控制pH4-6，用锌粉还原氯化除汞上清液中的汞（Ⅱ）离子，取置换后液加入过量的硝酸银标准溶液，以硫酸铁铵溶液作指示剂，用硫氰酸钾标准滴定溶液滴定来测定氯量。该方法的检出限：0．25mg／100mL，回收率：98％-101％。     

从氯化铅渣中回收铅铋的研究

本文以柿竹园有色金属矿粗铋火法精炼、气化除铅产出的铅渣为原料，在常压下采用氯化钠水溶液进行浸出处理，有效地分离了铅和铋，并将铅制成了化工产品黄丹及硫酸铅