Stability of AB5-type hydrogen storage alloys

In this paper, we deduced an empirical equation for predicting the stabilities of the hydrides of AB₅-type compounds with the consideration of the effects of geometrical factor and electric factor. The theoretical curves derived from this equation are in good agreement with the test results of La_1−xCa_xNi₅, Ml_1−xCa_xNi₅ and La_1−xCe_xNi₅ compounds. With this model, we can easily interpret the phenomenon that the initial partial substitution of R by Ca in R_1−xCa_xNi₅ (R is rare earth metal) compounds cause an increase of hydrogen desorption pressure to a maximum value, whereas in the range of larger Ca content x the hydrogen desorption pressure decreases with increasing x.     

萃取预分离法分离富铕中钇矿新工艺

采用一种新的串级萃取方式--萃取预分离法分离富铕中钇矿的新工艺.原料首先流入十几的三出口预先粗分离工艺,其萃余液La～Gd(TbDy)直接流入Nd/Sm工艺;中间出口流入(Gd)Tb～HoY(Er)Gd～Dy/Ho～LuY细分离工艺;出口负载有机相(Ho)Er～LuY流入Gd～Dy/Ho～LuY的洗涤段.结果表明,新工艺的粗分离工艺将占原料约70%的La～Gd(TbDy)预分离掉,使流入Gd～Dy/Ho～LuY工艺的稀土量减少约70%;由于Gd～Dy/Ho～LuY分组的萃余液GdTbDy含Ho2O3小于0.03%,省去原工艺的GdTbDy/HoY分离;新工艺的处理能力提高30%,酸碱消耗减少20%以上,贵重稀土元素Eu和Tb的存槽量大大减少.     

稀土稳定氧化锆超细粉末的合成机理研究

依据Al(Ⅲ )、Zr(Ⅳ )的水解聚合机理 ,把锆、铝和钇的无机盐溶液按一定组成混合在一起 ,通过加入乙二醇作为络合剂和调节溶液的PH值来获得溶胶 ,并直接蒸馏溶胶来获得干凝胶 ,最后制得ZrO2 (Y2 O3 ) -Al2 O3 系粉末。研究结果表明 :该工艺不仅制粉时间快、成本低、产量大 ,而且粒子均匀 ,粒径在 2 0～ 5 0nm之间 ,具有一定的可行性     

New catalyst systems for the polymerization of acetylene

The catalytic activities of WCI₆Ph₄Sn, MoCl₅Ph₄Sn and tetrabenzyltitanium were examined in the polymerization of acetylene. The structure, morphology and electrical conductivity of the doped and non doped polyacetylene were also studied.     

甲酸甲酯合成与转化的催化技术

本文评述了甲酸甲酯(MF)合成与转化的催化技术,展示了从MF出发发展C_1化学的可能途径,在MF的合成方面详细地分析了从甲醇出发的羰化法、脱氢法和氧化法催化技术,简介了我们的有关研究工作。     

The influence of F doping on the activity of PbO2 film electrodes in oxygen evolution reaction

The PbO₂ and F⁻-doped PbO₂ (F-PbO₂) film electrodes have been prepared by an electrodeposition process onto platinum substrate. The changes of their electrochemical activity for oxygen evolution (OE) reaction with accelerated electrolysis time have been studied. The results show that the activity of the electrodes decreases with increasing electrolysis time. This can be attributed to the conductivity variations, which are caused by the decrease of the oxygen vacancy concentration in PbO₂ films during OE. The mechanism of the decrease of the oxygen vacancies has been investigated. For F-PbO₂ film electrodes, though its electrochemical activity is somewhat lower than that of undoped one, its activity stability is much higher in comparison with that of PbO₂. The influence of F⁻ doping on the activity of PbO₂ film electrodes has been also discussed.     

离子色谱法测定配煤、焦炭和焦油中的氯含量

研究了用带电导检测器的离子色谱对配煤、焦炭和焦油中的Cl- 进行测定的方法。在YSA型8126A-4# 阴离子分离柱上用3.5mmol/LNa2CO3、5.3mmol/LNaHCO3做淋洗液对Cl-进行测定,方法简便快速。Cl-的检出限为2×10-6。该法也适用于F-、NO2-、NO3-、SO42-等的测定。     

Performance evaluation of an importance sampling technique in a Jackson network

Importance sampling is a technique that is commonly used to speed up Monte Carlo simulation of rare events. However, little is known regarding the design of efficient importance sampling algorithms in the context of queueing networks. The standard approach, which simulates the system using an a priori fixed change of measure suggested by large deviation analysis, has been shown to fail in even the simplest network settings. Estimating probabilities associated with rare events has been a topic of great importance in queueing theory, and in applied probability at large. In this article, we analyse the performance of an importance sampling estimator for a rare event probability in a Jackson network. This article carries out strict deadlines to a two-node Jackson network with feedback whose arrival and service rates are modulated by an exogenous finite state Markov process. We have estimated the probability of network blocking for various sets of parameters, and also the probability of missing the deadline of customers for different loads and deadlines. We have finally shown that the probability of total population overflow may be affected by various deadline values, service rates and arrival rates.     

Structure and properties of polyimide‐bonded magnets processed from prepolymers based on diacetyl derivatives of aromatic diamines and dianhydrides

We report a novel method of polyimide (PI) synthesis from prepolymers based on dianhydrides and diacetyl derivatives of aromatic diamines that facilitate the preparation of a melt processable mixture at 300 ± 10°C of the prepolymer and magnetic Nd‐Fe‐B alloy to provide PI‐bonded magnets with enhanced properties. It is shown that chemical structure of the prepolymers strongly influences viscosity behavior via crystallization of the oligoimide in the melt, leading to formation of PI with rigid‐rod like structure. This structural ordering of the prepolymers based on diacetyl derivative of diamine used in this study, if not controlled, leads to exponential increase of melt viscosity with time, making it practically impossible to prepare melt processable mixture of the magnetic particles and the PI prepolymers at elevated temperatures. The results obtained demonstrate that appropriate dianhydrides and diacetyl derivatives of diamines that do not lead to crystallization of oligoimides in prepolymer mixture can be used under controlled processing conditions to prepare melt‐processable PI‐bonded magnets containing rigid‐rod like PI structure that significantly increases thermal stability of the magnets. The temperature dependencies of the magnetic properties of the PI‐bonded magnets under conditions that they are likely to encounter during their service life were found to be remarkably similar to that of commercial thermoplastic magnets such as injection‐molded nylon magnets. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 478–485, 2006     

Effects of oxidation on I2 doping of trans-polyacetylene as studied via e.s.r. and conductivity measurements

Oxidation of trans-polyacetylene lowers the activation energy for conduction from 16 kcal mol^?1 to 11 kcal mol^?1 for oxidation levels of (C₂H₂O_n)_x, n = 0.144, 0.207 and 0.550. Maximum conductivity levels for 0 < x < 0.144 doped with I₂ were almost identical. At long I₂ doping times all samples exhibited some loss of conductivity. E.s.r. experiments indicate that: (1) linewidth is directly proportional to oxygen content, and (2) iodine doping is not diffusion controlled. All data are consistent with a molecular picture of PAC consisting of highly reactive localized spin states that are selectively oxidized, and less reactive delocalized states that affect conductivity more strongly via doping.