DMT系统中一种易于实现的时域均衡器

总结了DMT系统中时域均衡器(TEQ)的主要设计方法，指出最大缩短信噪比(MSSNR)TEQ的最优设计方法很难实时实现。提出了一种MSSNR TEQ的次优设计方法，它首先估计出目标抽样窗的最优延迟，然后用分步求解法求出TEQ的抽头系数。和最优方法相比，次优方法的计算量大幅度减少，可实时实现，而其缩短信噪比的损失很小。仿真实验验证了次优方法的有效性。     

Estimation and Optimization of the Principal H-Maser Parameters

The scale along the coordinate axes in the equations of motion hitherto used for an H-maser (in relative units) is shown to depend on Q as the quality factor for an H-maser. This hinders both analysis of the operation of the H-maser and optimization of its parameters. The modified equations of motion proposed here do not have that shortcoming. We determine the atomic flux into the bulb that gives the H-maser the best metrological characteristics.     

一种实现非等带宽多载波调制的新方法

传统的多载波调制都是采用对传输信道进行等带宽划分的方式。为了更好地适应信道传输特性，一个很有应用前景的发展方向是采用非等带宽划分信道的多载波调制方式。本文提出了一种利用正交小波包变换实现的非等带宽划分信道的多载波调制方法。理论分析和实验结果表明，这种方法对于提高信道的传输性能有很大的潜力。     

Modulation and Equalisation Considerations for High Performance Radio LANs

The European Telecommunications Standards Institute (ETSI) has recently defined a European standard for a high performance radio LAN (known as HIPERLAN). To operate as wired LAN replacements, these systems will operate at 5.2 GHz and support instantaneous bit rates of just under 24 Mb/s. To counteract the time dispersive nature of the indoor radio channel, the use of adaptive equalisation is suggested. In this paper a number of possible modulation and equalisation techniques are presented and, in particular, the Bit Error Rate (BER) performance of quasi-coherent GMSK combined with Decision Feedback Equalisation is explored through computer simulation. The trade off between symbol spaced and fractionally spaced equalisation is considered together with the importance of feedfoward and feedback synchronisation to the channel's power delay profile. The paper also includes a comparison of the RLS and LMS based training algorithms and compares the modem developed under the ESPRIT III LAURA project with that specified in HIPERLAN.The application of dual antenna diversity is investigated and its impact on the number of received error free data packets obtained as a function of signal leval and rms delay spread. The use of such diversity is shown to greatly improve the BER performance of a HIPERLAN modem. The problem of frequency offset is considered and modifications are proposed to the HIPERLAN frame structure to improve the receiver's tolerance to such errors. Important practical issues such as frame and symbol synchronisation, frequency offset correction and hardware implementation are discussed from both the LAURA and HIPERLAN viewpoint.     

Biodegradation of monoaromatic hydrocarbons in aquifer columns amended with hydrogen peroxide and nitrate

The ability of indigenous microorganisms to degrade benzene, toluene, ethylbenzene and xylenes (BTEX) in laboratory scale flow-through aquifer columns was tested separately with hydrogen peroxide (110 mg/l) and nitrate (330 mg/l as NO₃⁻) amendments to air-saturated influent nutrient solution. The continuous removal of individual components from all columns relative to the sterile controls provided evidence for biodegradation. In the presence of hydrogen peroxide, the indigeneous microorganisms degraded benzene and toluene (> 95%), meta- plus para-xylene (80%) and ortho-xylene (70%). Nitrate addition resulted in 90% removal of toluene and 25% removal of ortho-xylene. However, benzene, ethylbenzene, meta- and para-xylene concentrations were not significantly reduced after 42 days of operation. Following this experiment, low dissolved oxygen (< 1 mg/l) conditions were initiated with the nitrate-amended column influent in order to mimic contaminated groundwater conditions distal from a nutrient injection well. Toluene continued to be effectively degraded (> 90%), and more than 25% of the benzene, 40% of the ethylbenzene, 50% of the meta- plus para-xylenes and 60% of the ortho-xylene were removed after several months of operation.     

氢电弧等离子体法制备的纳米镍铈粒子的催化特性

利用氢电弧等离子法制备具有储氢特性纳米镍铈粒子，并在气相苯加氢反应中研究了其催化特性，发现其催化活性与储氢特性及表面层中ＮｉＣｅ合金存在有关，且具有高的选择性和热稳定性，这与纳米粒子独特的结构及铈的加入有关。     

工艺因素对金属封装外引线弯曲疲劳的影响

考察了金属封装外壳制造工艺对外引线弯曲疲劳的影响,发现电镀镍是导致外引线弯曲次数明显减少的最主要工艺步骤,且随镀镍层厚度的增加,弯曲次数减少。此外还讨论了外引线的氢含量和晶粒度对引线抗疲劳能力的影响。     

化肥厂合成气及重整氢真空变压吸附制取高纯度氢气

从设计、生产操作和经济效益3个方面阐述了以化肥厂合成气及重氢为原料，通过真空变压吸附（VPSA）装置制取高纯度氢的过程。工业应用结果表明，该制氢工艺是一项操作简便灵活，制氢费用较低的工艺路线。VPSA装置技术和设计上的特点能够保证大的操作弹性、高的产品氢纯度和较高的氢气回收率。在36％－51％的低限负荷下，通过适当调整吸附时间，可获得纯度99％的氢气产品，89％－92％的氢气回收率。     

Skeletal Isomerization and Inter—molecular Hydrogen Transfer Reactions in Catalytic Cracking

Bimolecular hydrogen transfer and skeletal isomerization the important secondary reac-tions among catalytic cracking reactions,which affect product yield distribution and product quality,Catalyst properties and operating parameters have great impact on bimolecular hydrogen transfer and skeletal isomerization reactions .Bimolecular hydrogen transfer activity and skeletal isomrization activity of USY-containing catalysts are higher thn that of ZSM-5-containing catalyst.Coke deposition on the active sites of catalyst may suppress bimolecular hydrogen transfer activity and skeletal isomer-ization activity of catlys in different degrees.Short raction time causes a decrease of hydrogen trans-fer reaction,but and increase of skeletal isomerization reaction compared to cracking reaction in catalytic cracking process.     

地地战术导弹飞行可靠性指标评定方法

在小子样情况下 ,利用系统和分系统试验数据对导弹的飞行可靠性指标进行评定 ,从数学上说是系统可靠性综合问题 .运用MML SR方法对新型号地地战术导弹的飞行可靠性指标进行评定 ,避免了MML方法在遇到无失败单元时不适用的缺陷 ,在利用地面试验信息方面有其明显优势 ;运用Bayes方法对改进型导弹的飞行可靠性指标进行评定 ,将不同试验阶段的多源试验信息作为验前信息 ,扩大了信息量 .最后 ,对两种方法在工程应用上遇到的问题进行了讨论 ,并给出了解决方法 .