Sandwich panels with Kagome lattice cores reinforced by carbon fibers

Stretching dominated Kagome lattices reinforced by carbon fibers were designed and manufactured. The sandwich panels were assembled with bonded laminate skins. The mechanical behaviors of the sandwich panels were tested by out-of-plane compression, in-plane compression and three-point bending. Different failure modes of the sandwich structures were revealed. The experimental results showed that the carbon fiber reinforced lattice grids are much stiffer and stronger than foams and honeycombs. It was found that buckling and debonding dominate the mechanical behavior of the sandwich structures, and that more complaint skin sheets might further improve the overall mechanical performance of the sandwich panels.     

高合金钢铸造用涂料的试制与开发

介绍了炉爪用合金钢1Cr25Ni20Si2Re,导板用合金钢2Cr32Ni5采用串箱铸造过程中，有关镁砂粉涂料和石英粉涂料的试制。结果表明：镁砂粉涂料为不透气涂料，不太适用，而合理配方的石英粉涂料使用性能良好。     

矿石中金的快速测定

研究了活性炭纤维滤布富集分离的条件和解脱方法,并利用微波溶样、液珠萃取比色法测定矿石中的金。该方法的测定范围为(0.5~xx)×10-6,相对标准偏差RSD为3.2%,可用于矿石中金的野外快速测定。     

用单透镜变换由多模光纤出射的大功率Nd：YAG激光束的特性

根据理论假设，通过选取单透镜的参数和位置，计算说明了单透镜使经由多模光纤出射的大功率Ｎｄ：ＹＡＧ激光束的发射角压缩，光束聚焦效率提高，光束截面场为高斯分布；文中的计算结果符合已知规律，从而说明了理论假设的正确性。     

氧化铝/锌合金复合材料界面的SEM观察

利用挤压铸造制备氧化铝／锌合金复合材料，在扫描电镜（ＳＥＭ）上观察复合材料的界面。结果表明，在复合材料中纤维与基体间存在致密界面层，合金元素通过适当的化学反应可改善纤维与基体间的结合；在凝固过程中，纤维／基体界面上的硅在共晶体的共生生长过程中起了领先相作用，导致复合材料的共晶转变是由铝硅共晶转变和锌铝共晶转变两者组成。     

PVDF中空纤维滤膜的形态结构

用Ｌ－Ｓ相转换法制备了聚偏氟乙烯（ＰＶＤＦ）中空纤维不对称滤膜。铸膜液由聚合物、溶剂和添加剂组成。用电子显微镜（ＳＥＭ）考察了聚合物浓度、添加剂用量及种类对膜形态结构的影响。实验结果表明，聚合物浓度对膜形态结构有显著影响，当铸膜液中聚合物浓度较低时，无论用什么种类添加剂，都能形成大、且多的孔，但孔的形状随添加剂不同而异。当恒定聚合物浓度时，添加剂的用量对膜形态结构有很大的影响，但孔的大小及多少与添加剂含量的多少不成正比。     

Theoretical Analysis of Critical period in Microbend Fiberoptic Sensor

1IntrodctionThesdV8fltsg6Sofffi1CY0bCfldf山CY0ptlCS6fiS0f8f6lflt6llSltyffiDdU18tlflgsliddCtCCtlflg，simpletechnique，highrellabllltyandlowprice，thereformlcrobendfiberoptlcsensorIswidelyusedtomeasurementofstrain，stressandv比rationetc．Inpractice，thesensltlvltyofsensorIsaveryimportantparameter，andthesensltlvltyofmlcrobendf山eroptlcsensorIsmainlyrelat-6dtofoil0WlflgthY66f8CtofS［‘-：ffilCfob6fldsffiplltlld6：fillffib6yofthlCY0b6fldS6Ct10llSsfldffil-crobendperiod，andmlcrobendperio…     

Corrosion fatigue short crack growth behaviour in a high strength steel

The influence of an aggressive environment (0.6 M, aerated NaCl solution) on short fatigue crack initiation and growth behaviour has been studied. The study involved three major test series, namely: air fatigue, corrosion fatigue, and intermittent air fatigue/corrosion fatigue. The above tests carried out under fully reversed torsional loading conditions at a frequency of 5 Hz, showed that it was the non-metallic inclusions which took part in crack initiation resulting from debonding at metal matrix/inclusion interface and pitting of inclusions in both air and corrosove environments, respectively. Short fatigue crack growth results in these two environments obtained by using plastic replication technique, indicated a large effect of microstructure i.e. prior austenite grain boundaries. The stage/stages at which the environmental contribution was dominant has been discussed by considering the results achieved from intermittent tests. However, the mechanisms involved in corrosion fatigue short crack growth have also been described in the light of results obtained from futher investigations carried out by conducting corrosion fatigue tests under applied cathodic potential conditions and tests on hydrogen pre-charged specimens under air fatigue and uniaxial tension conditions.     

单模光纤最小群速度色散波长附近的调制不稳定性

利用修正的非线性Ｓｃｈｒｏｄｉｎｇｅｒ方程研究了单模光纤最小群速度色散波长附近的调制不稳定性，发现了一个新的由光纤四色散导致的调制不稳定性区域，该区域的调制范围与初始入射脉冲的功率和四阶色散有关。     

含羧基的聚乙烯醇胺肟螯合纤维吸附钯的研究

研究了含羧基的聚乙烯醇胺肟（ＰＶＡＡＯ－ＡＡｃ）螯合纤维对钯的吸附，讨论了ｐＨ、温度、浓度、吸附时间对吸附率及回收率的影响。确定了最佳吸附条件，吸附钯的纤维用５％硫脲＋０．１０ｍｏｌ／Ｌ硝酸溶液可以解吸。