Simulation of Fe-Al compounds developed during single superphosphate manufacture

In order to analyse iron phosphate complexes and gel-like phases encountered in the single superphosphate process, experiments were performed with a free-Al, Fe apatite crystal of Durango from Mexico phosphate rock and sulfuric acid. Reaction products were studied by X-ray diffraction and surface analysis methods namely X-ray photoelectron spectroscopy and scanning electron microscopy. Results show that in a free Al, Fe-system, part of the Ca(H₂PO₄ )₂.H₂O (MCPM) forms before precipitation of any CaSO₄(CS) and gel-like phase such H₂SO₄.yH₃PO₄.xH₂O is formed. When iron is added, the precipitation rate of (CS) and (MCPM) increases and Fe₃(H₃O)H₈(PO₄)₆.6H₂O is formed. When Fe and Al are added, a gel-like phase is quickly formed with a molar ratio that changes with time and develops into crystalline compounds. The composition of this gel may be represented as a mixture of two phases: H₂SO₄.yH₃PO₄.xH₂O and a gel containing Al-Fe-Si.     

过磷酸钙折流混合器的改进

由于绿原化工有限公司过磷酸钙装置生产能力由 6 70 t/ d(实物量 )提高到 84 0 t/ d,折流混合器负荷增大 ,出现折流环磨损加快等问题。采用若干技改措施 :扩大折流环内径、改变折流混合器喷射方向、采用新材料制作折流环 ,使折流混合器能满足 84 0 t/ d过磷酸钙生产的需要     

啮合同向双螺杆挤出机的相似放大

首先给出啮合同向双螺杆挤出机熔体输送段相似放大方法中所用到的参量表达式,然后从混合、热平衡和综合这两方面分别进行相似放大,并分析各自的优缺点。利用W＆P公司ZSK系列混合机的设计特点和技术数据,分析了相似放大设计在实际中的应用。对大型同向双螺杆挤出机提出相似放大的准则,应是螺杆线速度保持恒定。     

过磷酸钙含氟尾气处理的新方法

对动态泡沫床处理过磷酸钙含氟尾气的有关技术及费用作了说明 ,指出该方法费用高 ;提出一种新方法 ,该方法不加任何化学助剂 ,采用水作吸收剂 ,只需改变动态泡沫床一些设计参数和选用一种特殊的喷头 (喷头周围设计 1个圆锥形死角区 ,使含氟气体不可能进入该区 )避免了硅胶堵塞。该方法已在湖南浦市化工总厂运行 1年多未发现堵塞 ,同时该法投资少、能耗低、排放尾气达标     

单束纤维增强树脂基复合材料的热水老化性能研究

在96℃水中,对开芙拉29(Kevlar29),开芙拉49(Kevlar49)和聚苯撑苯并唑(PBO)纤维束增强的环氧树脂和双马树脂基复合材料进行老化实验后,再在60℃下进行干燥脱水处理。实验测定了吸水和脱水阶段的含水率及热水老化试样和干燥试样的弯曲性能。结果表明:在热水作用下,复合材料的弯曲强度和模量随热水老化时间的延长呈下降趋势,纤维与树脂基体间的界面发生破坏;再干燥脱水后,材料的弯曲强度和模量恢复,但仍低于未老化试样的性能,纤维与树脂基体间的界面破坏情况也类似。     

Variation in relative quantities of airborne sex pheromone components from individual femaleEphestia cautella (Lepidoptera: Pyralidae)

The airborne sex pheromone components (Z,E)-9,12-tetradeca-dien-1-yl acetate and (Z)-9-tetradecen-1-y1 acetate from single calling females ofEphestia cautella (Walker) were trapped within glass capillary tubes and were measured by gas chromatography-mass spectrometry. Broad and similar distributions of relative quantities were found for a laboratory strain and three Australian field strains, and means differed strongly from those reported previously for this species. The overall mean proportion of the two components found for Australian females was 8812. The composition in individuals ranged from 6327 to 973. The proportions for individuals appeared to vary slightly in a random fashion from day to day, and proportions for first-generation progeny were influenced by the maternal blend.Author order in this paper is alphabetical     

稀磷酸澄清槽泥浆泵改用单螺杆泵的实践

磷酸生产中输送稀磷酸澄清槽淤渣的泥浆泵，各厂的运行情况都不够理想。介绍了三种类型泥浆泵的运行情况，针对淤渣中会出现块结垢物影响泥浆泵长期运行，在单螺杆泵进料腔内设置破碎送料器后，取得了较理想的效果，从而提高了磷酸装置的运转率和磷得率。     

双螺杆转速差决定的螺杆间隙之探讨

根据相对运动原理计算了同向旋转双螺杆因螺杆转速差决定的两螺杆之间的径向和轴向间隙,可为工程上设计这些间隙时提供参考。     

Effects of apitong (Dipterocarpus spp.) extractives on bond strength development and curing rate of adhesives

Emulsion polymer isocyanate ( ), polyvinyl acetate ( ) and resorcinol-formaldehyde ( ) adhesives were used to produce single lap shear specimens using resinous and non-resinous apitong (Dipterocarpus spp.) timbers. Tests showed that joints made with highly resinous apitong were about 40% weaker than similar joints made with non-resinous apitong. The resinous apitong was treated with different solvents to yield five different extractives which were characterized by infra-red analysis. Apitong extractives were then added to and adhesives and joints made with buna (Fagus crenata), a timber known to be low in extractives and easy to bond. Joints prepared using extractive-containing adhesives were generally weaker than those made with the unmodified adhesives. RF adhesives containing extractives cured more slowly than unmodified . It is thought that the acidic nature of the extractives changes the pH of the system sufficiently to affect the curing mechanism     

Effective prediction of DEA model by neural network

In this paper,a fast neural network model for the forecasting of effective points by DEA model is proposed,which is based on the SPDS training algorithm.The SPDS training algorithm overcomes the drawbacks of slow convergent speed and partially minimum result for BP algorithm.Its training speed is much faster and its forecasting precision is much better than those of BP algorithm.By numeric examples,it is showed that adopting the neural network model in the forecasting of effective points by DEA model is valid.