液相对流对固液界面稳定性的影响

以模型合金丁二腈－乙醇的强制性晶体生长为基础，利用自行研制的液相对流驱动装置，详细考查了液相自然对流及强迫对流作用下，模型合金平界面失稳的动态生长过程，证实了液相的流动加快了液相温度与浓度分布的均匀化，从而增强了液／固界面的稳定性。并且随流动速度的增加，界面稳定性提高。     

聚氧乙烯 - 聚氧丙烯 - 聚苯乙烯多嵌段聚合物的力学和导电性能研究

研究了聚苯乙烯含量对聚氧乙烯－聚氧丙烯－聚苯乙烯多嵌段聚合物的力学性能及其与ＬｉＣｌＯ４络合物的离子导电性能的影响；并以电导率较高的络合物为电解质，Ｎａ１＋ｘＶ３Ｏ８复合物和Ｌｉ片分别为正、负极组装了薄型锂电池并测定其放电性能。     

Oxidation of methane over platinum in a solid proton-conducting electrolyte cell

Studies of the complete oxidation of methane on a Pt electrode-catalyst in the cell with a solid proton-conducting electrolyte (CH₄ + O₂, Pt ¦ SrCe_0.92Dy_0.08O₃ ¦ Pt, H₂O + N₂) were carried out. The non-Faradaic effect of electrochemical hydrogen pumping on the rate of methane oxidation has been demonstrated. The induced change in the reaction rate at anodic polarization of a Pt electrode-catalyst was over two orders of magnitude higher than the rate of hydrogen pumping from the reaction zone through the electrolyte.     

Electrophilic chlorination of methane over superacidic sulfated zirconia

Catalytic chlorination of methane was studied over SO ₄ ^2– /ZrO₂, Pt/SO ₄ ^2– /ZrO₂, and Fe/Mn/SO ₄ ^2– /ZrO₂ solid superacid catalysts. The reactions were carried out in a continuous flow reactor under atmospheric pressure, at temperatures below 240°C, with a gaseous hourly space velocity of 1000 ml/g h and a methane to chlorine ratio of 4 to 1. At 200°C with 30% chlorine converted the selectivity in methyl chloride exceeds 90%. At more elevated temperatures, the selectivity decreases but stays above 80% in methyl chloride at 225°C using the sulfated zirconia catalysts. The selectivity can be enhanced by adding platinum to sulfated zirconia catalysts. An iron and manganese-doped catalyst exhibited excellent selectivities at somewhat lower conversions. Methyl chloride is obtained at 235°C in selectivities greater than 85%. No chloroform or carbon tetrachloride is formed. The electrophilic insertion involves electron-deficient metal-coordinated chlorine into the methane C-H bond.Catalysis by solid superacids, 29. For part 28 see ref. [14].     

Effect of harvesting time and fruit size on titratable acidity, soluble solid and distribution of limonin in Thai tangerine juice

The effect of fruit size and harvesting of Thai tangerine fruit ( Citrus reticulata , Blanco) at different growth stages, 8–12 months after fruit set, on the distribution of limonin in whole fruit as well as in the individual fruit parts and extracted juice was investigated. The highest limonin concentration was observed in seed, followed by albedo, flavedo, segment membrane and juice sacs in decreasing order. The limonin concentration in juice as well as in whole fruit was decreased when fruit was harvested 8–12 months of fruit set. Increasing harvesting time from 8 to 12 months showed corresponding decreases in the amount of limonin in flavedo, albedo and seed. There was a decrease in titrable acidity and increase in total soluble solid and total soluble solid/titrable acidity ratio of juice with a later than normal harvesting time. However, fruit size showed no effect on limonin content and other properties of juice extracted from tangerine.     

Spline-regression estimation of the influence of exposure dose on cancer probability

Spline regression is used to analyze the influence of radiation on the cancer probability in a group of participants of Chernobyl accident mitigation, depending on the exposure dose. A new method is proposed to approximate modified polygons by linear splines with two nodes. An algorithm for the identification of a transition point is outlined. __________ Translated from Kibernetika i Sistemnyi Analiz, No. 3, pp. 168–176, May–June 2006.     

Equilibrium Studies of the System'(Fe,Co)O'–(Fe,Co)3O4 by Solid-State emf Measurements in the Temperature Range 970 to 1370 K

The equilibrium reaction 3'(Fe, Co)O'( ss ) +1/2O₂ ( g ) ⇄ (Fe, Co)₃O₄( ss ) was studied in the temperature range 970 to 1370 K for seven different total compositions of molar ratios 0.5 < Fe/(Fe + Co) ≤ 1.0. The equilibrium pressures of oxygen were determined by using galvanic cells incorporating calcia stabilized zirconia as solid electrolyte and the Fe/Co ratios in the solid-solution phases by wavelength dispersive spectrometry microprobe analyses. The activities of 'FeO' in the cobaltowüstite phase were then derived from the experimental results obtained.     

Boundary Constrained Swept Surfaces for Modelling and Animation

Due to their simplicity and intuitiveness, swept surfaces are widely used in many surface modelling applications. In this paper, we present a versatile swept surface technique called the boundary constrained swept surfaces. The most distinct feature is its ability to satisfy boundary constraints, including the shape and tangent conditions at the boundaries of a swept surface. This permits significantly varying surfaces to be both modelled and smoothly assembled, leading to the construction of complex objects. The representation, similar to an ordinary swept surface, is analytical in nature and thus it is light in storage cost and numerically very stable to compute. We also introduce a number of useful shape manipulation tools, such as sculpting forces, to deform a surface both locally and globally. In addition to being a complementary method to the mainstream surface modelling and deformation techniques, we have found it very effective in automatically rebuilding existing complex models. Model reconstruction is arguably one of the most laborious and expensive tasks in modelling complex animated characters. We demonstrate how our technique can be used to automate this process.     

Testing the robustness of CIECAM02

CIE TC8‐01 has adopted a new color appearance model: CIECAM02¹ replaces the CIECAM97s.² The new model consists of a number of refinements and simplifications of the CIECAM97s color appearance model. This article describes further tests to the robustness of the forward and reverse modes. © 2005 Wiley Periodicals, Inc. Col Res Appl, 30, 99–106, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/col.20087     

JDZ-1型固态存储雨量器降水量误差成因分析

对JDZ-1型固态存储雨量器与虹吸自记雨量计平行观测资料进行了系统分析,分析了两者存在误差的影响因素。对JDZ-1型固态存储雨量器在北方地区使用过程中存在的问题提出了解决方法,以保证和提高JDZ-1型固态存储雨量器资料质量。