上下行信号平衡与蜂窝小区设计

本文从无线电通信基本要素出发 ,阐述上行信号和下行信号的无线传播 ,得出上下行信号平衡链路方程 ,并以我国普遍使用的TACS系统和GSM系统为例 ,着重讨论了信号平衡与蜂窝小区设计之间的关系。     

一种新的带优先权控制的ATM交换结构

本文在Ｋｎｏｃｋｏｕｔ交换结构的基础上，探讨一种新的ＡＴＭ交换结构，使其本身带有优先权控制功能，以适应不同业务对信元丢失率及时延的不同要求。这种结构既能最大限度地有效利用系统资源，又能满足不同用户对业务质量的不同要求，并能降低交换结构复杂度。     

乙醇电氧化的研究进展

简要地叙述了国内外乙醇电催化氧化的研究进展，着重介绍不同电极材料对乙醇电氧化的影响及目前所提山的机理，并对其可能的研究方向提出了建议。     

Cyclic variations in the permeability of the cell wall of Saccharomyces cerevisiae.

To study cell-cycle-related variations in wall permeability of Saccharomyces cerevisiae, two approaches were used. First, an asynchronous culture was fractionated by centrifugal elutriation into subpopulations containing cells of increasing size. The subpopulations represented different stages of the cell cycle as judged by light microscopy. Cell wall porosity increased when these subpopulations became enriched with budded cells. Secondly, synchronous cultures were obtained by releasing MATa cells from alpha-factor induced G1-arrest. These cultures grew synchronously for at least two generations. The cell wall porosity increased sharply in these cultures, shortly before buds became visible and was maximal during the initial stages of bud growth. It decreased in cells which had completed nuclear migration and before abscission of the bud had occurred. The porosity reached its lowest value during abscission and in unbudded cells. We examined the incorporation of mannoproteins into the wall during the cell cycle. SDS-extractable mannoproteins were incorporated continuously. However, the incorporation of glucanase-extractable mannoproteins, which are known to affect cell wall porosity, showed cyclic oscillations and reached its maximum after nuclear migration. This coincided with a rapid decrease in cell wall porosity, indicating that glucanase-extractable mannoproteins might contribute to this decrease.     

Vero细胞在微载体上迁移和多层生长现象

本文通过对电子显微镜观察了Ｖｅｒｏ细胞有微载体增减过程中的迁移民政部发现在不同增减阶段，Ｖｒｏ细胞迁移方式不同；在分泌形成的细胞外基质，上，Ｖｅｒｏ细胞迁移是通过 层粘连蛋白介导进行的，被层粘连蛋白抗体抑制；这种迁移导致Ｖｅｒｏ细胞在微载体上形成多层生长现象。     

一种低压低功耗SRAM/SOI单元设计

提出一种改进4管自体偏压结构SRAM/SOI单元.基于TSUPREM4和MEDICI软件的模拟和结构性能的分析,设计单元结构并选取结构参数.该结构采用nMOS栅下的含p+埋沟的衬底体电阻代替传统6管CMOSSRAM单元中的pMOS元件,具有面积小、工艺简单的优点.该结构可以在0.5V的电源电压下正常工作,与6管单元相比,该单元瞬态响应正常,功耗只有6管单元的1/10,满足低压低功耗的要求.     

Charge transfer resistance of spray deposited and compressed counter electrodes for dye-sensitized nanoparticle solar cells on plastic substrates

Electrochemical impedance spectroscopy was used to determine the effective charge transfer resistances of porous dye-sensitized solar cell counter electrodes prepared by low-temperature spray deposition and compression of conductive carbon and platinized Sb-doped SnO₂ powders on indium tin oxide-coated plastic substrates. The charge transfer resistances were 0.5–2 and 8–13 Ω cm², respectively, when using 3-methoxypropionitrile as the electrolyte solvent. The manufacturing method used lends itself to produce mechanically stable and even-quality electrodes in an easy and fast manner.     

Promising alloys for intermediate-temperature solid oxide fuel cell interconnect application

The formation of a low Cr-volatility and electrically conductive oxide outer layer atop an inner chromia layer via thermal oxidation is highly desirable for preventing chromium evaporation from solid oxide fuel cell (SOFC) metallic interconnects at the SOFC operation temperatures. In this paper, a number of ferritic Fe–22Cr alloys with different levels of Mn and Ti as well as a Ni-based alloy Haynes 242 were cyclically oxidized in air at 800 °C for twenty 100-h cycles. No oxide scale spallation was observed during thermal cycling for any of these alloys. A mixed Mn₂O₃/TiO₂ surface layer and/or a (Mn, Cr)₃O₄ spinel outer layer atop a Cr₂O₃ inner layer was formed for the Fe–22Cr series alloys, while an NiO outer layer with a Cr₂O₃ inner layer was developed for Haynes 242 after cyclic oxidation. For the Fe–22Cr series alloys, the effects of Mn and Ti contents as well as alloy purity on the oxidation resistance and scale area specific resistance were evaluated. The performance of the ferritic alloys was compared with that of Haynes 242. The mismatch in thermal expansion coefficient between the different layers in the oxide scale was identified as a potential concern for these otherwise promising alloys.     

An extension of the Secant Method for the homogenization of the nonlinear behavior of composite materials

We discuss the consequences of a different application of the principle the Modified Secant Method is [C. R. Acad. Sci. Paris Sér. IIb 320 (1995) 563] based on. In fact, we directly compute the second-order averages of the local fields available from the linear elastic homogenization procedure exploited in order to evaluate the effective elastic moduli. This method, which can be seen either as a simplification of the Modified Secant Method or as an extension of the Secant Method [J. Mech. Phys. Solids 26 (1979) 325], may be useful for any composite whose overall elastic constants need to be estimated by modeling the microstructure through Morphologically Representative Patterns [J. Mech. Phys. Solids 44 (1996) 307], which is for instance the case of syntactic foams [Int. J. Solids and Structures 38/40-41 (2001) 7235]. In order to show the accuracy of the proposed method, we apply it to several examples and compare its results with those obtainable by means of other analytical methods available in the literature, with numerical results of Finite Element simulations, and with experimental results. Closed-form solutions are derived for the effective yield stress of porous metals and incompressible composites reinforced with rigid spheres.