膏盐岩地层地质特征与录井技术

石油勘探实践和研究结果表明，许多油气藏的形成都与膏盐岩地层有关，也常与膏盐岩地层伴生，成功钻穿膏盐岩地层是钻井难题之一，录井技术成为钻进安全监测、膏盐岩地层准确预报的重要手段。针对上述情况，介绍了膏盐岩地层的主要类型、沉积模式以及与油气的关系，归纳总结了膏盐岩地层的录井技术经验，包括：在随钻录井过程中熟悉地质设计与邻井资料；在没有预测钻遇膏盐岩地层的情况下，通过钻井液中Cl^-的变化判定是否钻遇膏盐岩地层；预计钻遇膏盐岩地层时，使用饱和盐水钻井液；钻遇膏盐岩地层后观察盐岩是否以岩屑形式返出；同时，把握膏盐岩地层的岩性、岩性组合、层位、顶底界和厚度是非常重要的。通过S1井实例分析，论述了在膏盐岩地层中钻进时，防卡、防漏是录井人员监测和预报的重点。     

Simultaneous sulfide and acetate oxidation under denitrifying conditions using an inverse fluidized bed reactor

BACKGROUND: Simultaneous removal of sulfur, nitrogen and carbon compounds from wastewaters is a commercially important biological process. The objective was to evaluate the influence of the CH₃COO^?/NO₃^? molar ratio on the sulfide oxidation process using an inverse fluidized bed reactor (IFBR). RESULTS: Three molar ratios of CH₃COO^?/NO₃^? (0.85, 0.72 and 0.62) with a constant S^2?/NO₃^? molar ratio of 0.13 were evaluated. At a CH₃COO^?/NO₃^? molar ratio of 0.85, the nitrate, acetate and sulfide removal efficiencies were approximately 100%. The N₂ yield (g N₂ g^?1 NO₃^?‐N consumed) was 0.81. Acetate was mineralized, resulting in a yield of 0.65 g inorganic‐C g^?1 CH₃COO^?‐C consumed. Sulfide was partially oxidized to S⁰, and 71% of the S^2? consumed was recovered as elemental sulfur by a settler installed in the IFBR. At a CH₃COO^?/NO₃^? molar ratio of 0.72, the efficiencies of nitrate, acetate and sulfide consumption were of 100%, with N₂ and inorganic‐C yields of 0.84 and 0.69, respectively. The sulfide was recovered as sulfate instead of S⁰, with a yield of 0.92 g SO₄^2?‐S g^?1 S^2? consumed. CONCLUSIONS: The CH₃COO^?/NO₃^? molar ratio was shown to be an important parameter that can be used to control the fate of sulfide oxidation to either S⁰ or sulfate. In this study, the potential of denitrification for the simultaneous removal of organic matter, sulfide and nitrate from wastewaters was demonstrated, obtaining CO₂, S⁰ and N₂ as the major end products. Copyright © 2008 Society of Chemical Industry     

Observation and Analysis of Gypsum Particleboard using SEM

The microstructures of gypsum board and gypsum particleboard were observed by SEM. The effects of retarder and waterproof agent on the shape and the average dimension of the gypsum crystal were discussed. The mechanism was investigated as well. Four typical instances, i e, the gypsum crystal shape, the gypsum combined with particles on the particles surface, the gypsum combined with particles on the wood cross section and the gypsum combined with particles inside the wood cell cavity were selected and observed. Furthermore, the agglomeration and cementation mechanism between gypsum and particle were studied.     

理学SMX-10/11型X荧光光谱仪的改进

对理学SMX-10／ll型X荧光光谱仪真空系统、样品定位系统及热交换器冷却水循环路径等易发生故障部位进行改进，并在11型仪器上增加了S元素分析通道。生产应用表明，改进效果良好，简化了分析工艺。降低了分析成本，提高了仪器的稳定性。     

动力配煤高温复合固硫剂研究

分析了高温复合固硫剂各成分的作用，实验研究了在不同配比的燃烧试验下，各成分对燃煤着火和燃烧以及对炉渣固硫的影响，得出了该煤种高温复合固硫剂的最佳配方。     

Instability of zeolite Y supported cobalt sulfide hydrotreating catalysts in the absence of H2S

Ion exchanged CoNaY was sulfided at 473 and 673 K and subsequently heated in He at 673 and 773 K. The resulting samples were characterized by means of overall sulfur analysis, temperature programmed Ar treatment and Fourier transform infrared spectroscopy. It was shown that during He flushing at sufficiently high temperature a protolysis reaction occurs resulting in the decomposition of Co sulfide into Co²⁺ ions and H₂S.     

微波消解-ICP-AES法测定菜油中P、S

采用微波加热,在高温高压下酸消解样品,运用电感耦合等离子体原子发射光谱法(ICP-AES)同时测定菜油中P、S。本法选用紫外区谱线P178.221nm、S180.669nm,避免了基体中存在的Fe、Zn、Al、Cu、Mn、Ca等元素的光谱干扰。实验通过用纯氮吹扫光谱仪光路的方法消减空气中氧对紫外线的吸收,获得了足够的灵敏度。该方法简便、快速,稳定可靠,P、S检出限分别为0.067、0.078μg/ml,RSD为1.35%～5.05%,回收率为89.0%～100.9%。     

亚硫酸钙氧化为石膏的研究

进行了亚硫酸钙氧化为二水石膏的研究 ,考察了初始 p H值、反应温度、空塔气速、固含量和停留时间对氧化率的影响 ,给出了适宜的反应条件 .在这些条件下 ,氧化率达 96 %以上     

SO_3磺化法合成PNTS新工艺的研究

本文采用正交设计及方差分析法,确定了 SO_3磺化法合成 PNTS 新工艺的最佳工艺条件;并从技术及经济方面将新工艺同国内现有的生产老工艺进行了分析对比。     

常减压蒸饱装置几起典型硫腐蚀事例分析

随着高（含）硫原油加工量的增加,硫腐蚀事故也时有发生。通过对常减压装置硫腐蚀事例进行分析,指出合理的混炼比,加强“一脱三注”管理,材料升级和实施腐蚀监测是防止腐蚀事故发生的有效措施。