Catalyst’s Sulfur Displacement by Thiophene, as Monitored by Exchange of 35S Radiotracer

The isotopic exchange has been studied between catalyst radiosulfur and H₂S, formed in thiophene hydrodesulfurization (HDS) (named S-displace) on alumina supported molybdena, on CoMoO_x, PdMoO_x, PtMoO_x and on silica–alumina supported NiWO_x. S-displace was compared with radiosulfur exchange data between catalyst radiosulfur and gas phase H₂S (S^exc) determined previously. The extent of S^exc was higher than that of the S-displace for Mo, CoMo in and NiW, whereas the extent of S-displace from PdMoO and PtMoO was significantly higher, than that of S^exc. Thiophene HDS product distribution data are discussed in terms of increased C=C hydrogenation and C–C hydrogenolysis activity, explained by increasing H₂S production with longer circulation time of the thiophene/H₂ mixture, The C₁/C₃<1 ratios among C₄-hydrogenolysis products indicate some coke formation. The decrease of thiophene HDS activity is presumably a consequence of increasing site-blocking with the formation of more H₂S and coke with longer duration of thiophene treatment.     

Biodesulfurization of dibenzothiophene sulfone by Arthrobacter sp. and studies with oxidized Illinois No. 6 coal

A bacterium identified as Arthrobacter sp. was grown on dibenzothiophene (DBT) sulfone as a sole source of sulfur, producing sulfite and sulfate. Sulfur in DBT sulfone (1.0 mM) was nearly quantitatively converted to sulfate by the organism. The organism could also use DBT sulfone as a sole source of carbon and energy. There was evidence for transient accumulation of benzoic acid in the culture medium after growth of the cells slowed. The DBT sulfoxide analogue 9-fluorenone was converted by resting cells to a product identified as 1,10-dihydroxy-1,10-dihydrofluoren-9-one, suggesting that DBT sulfone may be metabolized via an angular hydroxylation resulting in carbon- sulfur bond cleavage. This strain of Arthrobacter showed no ability to desulfurize oxidized Illinois No. 6 coal.     

利用工业废石膏作水泥缓凝剂的技术研究

介绍了利用生产混凝土外加剂时排放的工业废石膏作为水泥缓凝剂的研究。研究结果表明,废石膏作为水泥缓凝剂单独使用时虽然可能会影响水泥的凝结时间和强度,但如果与天然石膏搭配使用,并控制适当的SO3掺量,就可以在原有生产工艺参数基本不变的条件下,生产出合格的水泥,而且可以配制出符合建筑工程要求的高性能混凝土。     

过磷酸钙喷涂法生产硫基复合肥工艺研究

简述了过磷酸钙喷涂法生产硫基复合肥的反应原理及工艺方案、实施方案的确定。给出了该工艺较传统工艺的优势及特点。     

控制燃煤硫的污染与动力煤全硫比价划分

讨论了中国煤炭资源中全硫分布的特点，指出加强动力煤洗选，降低硫含量的重要性；采用ＩＧＣＣ工艺和热煤气脱硫技术，可以实现高硫煤的有效利用。并提出制定合理的动力煤全硫比价问题。     

OXIDATION OF SULFUR DIOXIDE IN DIFFERENT TYPES OF THREE PHASE REACTORS

Five different types of three-phase reactors are compared with each other by using oxidation of sulfur dioxide on activated carbon. The kinetic measurements were carried out by changing concentrations of sulfur dioxide from 0.04 to 0.17% (volume) and those of oxygen from 2 to 21%. The reaction rate was 0.2 order with respect to sulfur dioxide and 0.5 order with respect to oxygen. The catalytic effectiveness factor and intraparticle diffusivity were evaluated by changing particle sizes of activated carbon from 0.03 to 1.6 mm. Resistances of gas-liquid, liquid-solid mass transfer and intraparticle diffusion were estimated for individual reactors. The optimum reactor was dependent on operating conditions such as gas flow rates, rotating speeds and particle sizes.     

有机硫加氢(HDS)催化剂的预硫化

预硫化是HDS、HDN过程中决定催化剂活性的最重要环节。在分析催化剂硫化反应原理、硫化条件、硫化与还原的关系等基础上进一步指出了在工业过程中预硫化的一些原则。     

高含硫气藏中元素硫沉积形态和微观分布研究

元素硫沉积是高含硫气藏开采过程中存在而又必须解决的难题之一.随着高含硫气藏储层压力不断下降,元素硫溶解度也不断下降,一旦元素硫溶解度低于元素硫含量,元素硫就会从地层中沉积下来.沉积的元素硫会堵塞地层孔隙,降低渗透率,严重影响气井产能.为了研究元素硫在地层中的沉积形态和沉积特征,利用自主设计的实验流程和实验方法,使TD5-1井高含硫气体通过岩芯,并降低压力让元素硫在岩芯中沉积下来,然后对沉积了元素硫的岩芯进行电镜扫描和能谱分析,首次得到了元素硫在岩芯中的沉积形态,即元素硫主要以膜状形式分布在岩芯孔隙壁面上.该研究结果为深入认识、掌握元素硫沉积规律以及指导高含硫气藏合理开发奠定了基础.     

脱硫石膏－粉煤灰活性掺合料设计及水化特性

针对电厂两大工业废渣--烟气脱硫石膏及粉煤灰,通过试验研发用于混凝土的活性复合矿物掺合料.以适当比例复合后的脱硫石膏及粉煤灰等量取代水泥掺入到水泥砂浆中,通过活性激发措施,以胶砂流动度、早期强度以及强度发展规律等作为控制指标探索脱硫石膏及粉煤灰的最优配比,同时通过微细观结构的SEM观测评价脱硫石膏-粉煤灰活性矿物掺合料在水泥基材料中的作用效应.结果表明,脱硫石膏及粉煤灰以1:2的比例复合等量取代水泥30%掺入水泥砂浆中,可获得较为优异的胶砂流动度、早期强度,而后期强度能赶上甚至超过基准水泥胶砂;SEM表明由于脱硫石膏及其它外加组分的活性激发效应,粉煤灰的活性得到有效激发,早期有明显的钙矾石生成.脱硫石膏-粉煤灰复合矿物掺合料的研发可大量消纳燃煤电厂的工业废渣,且在水泥基材料体系中具有优异的水化及低成本特性,具有显著的"绿色"效应,符合中国"可持续发展"的战略要求.     

公路面层脱硫石膏—粉煤灰混凝土试验研究与应用

脱硫石膏和粉煤灰按比例混合后,掺入适量改性剂复合而成一种新型活性矿物掺合料,并制备C30～C40脱硫石膏-粉煤灰混凝土,试验研究其主要技术性能。结果表明,脱硫石膏-粉煤灰按质量比例掺入30%以上,混凝土不离析、不泌水,施工和易性优于普通混凝土;力学性能满足公路面层设计要求;180d干缩率小于450×10-6、磨耗量仅为标准限值的60%左右,抗冻等级大于D300。脱硫石膏-粉煤灰混凝土成功应用于常德桃花源-花岩溪旅游公路路面试验段施工,社会经济和环保效益显著。