合成直链烷基苯环境友好固体酸催化剂的研究 Ⅲ .催化剂失活原因分析

采用固定床反应器,对催化剂的稳定性进行了初步评价。在120℃、空速相同、液固反应条件下,高苯烯比时催化剂的稳定性明显高于低苯烯比时;在苯烯比和空速相同、液固反应条件下,相对低温反应时,催化剂的稳定性明显高于高温反应。IR分析结果表明,同新鲜和反应后未失活的催化剂相比,失活后催化剂的活性组分特征衍射峰消失,出现的新的特征衍射峰可能同—CH基的振动有关。TG分析结果表明,失活后催化剂在空气流中焙烧,失重幅度比新鲜催化剂大。     

固体酸的酸性和结构对苯与乙烯烷基化的影响

在搅拌高压釜中,研究了纯磷钨酸、负载磷钨酸、工业Y-分子筛、工业β-分子筛和纳米β-分子筛5种固体酸催化剂进行苯与乙烯的液相烷基化反应的催化活性和反应选择性。实验结果表明,固体酸催化剂的烷基化反应活性高低主要取决于表面酸强度和酸量;乙苯的选择性主要取决于催化剂的孔道结构;乙基化的选择性则与催化剂的表面酸强度、酸性中心位置和孔道结构等因素有关。     

Effect of organic dopants on electrodeposition and characteristics of polyaniline under the varying influence of H2SO4 and HClO4 electrolyte media

Electrodeposition of conducting polyaniline (Pani) was made under potentiostatic condition at pH 1.0 in different electrolyte media (H₂SO₄ and HClO₄) in the absence and presence of two organic dopants, disodium salts of naphthalene-1,5-disulphonic acid (NSA) and of catechol-3,5-disulphonic acid (CSA). The rate and yield of Pani deposition were dependent on the acid medium and the dopant employed. NSA in H₂SO₄ caused an increase in rate and yield but CSA decrease when compared to the rate and yield of H₂SO₄ alone. In HClO₄ medium, both the dopants showed a decrease. With regard to DC electrical conductivity, both the dopants exhibited an enhancement in H₂SO₄ medium but NSA a decline in HClO₄. Characterisation of the electrosynthesised polymer samples by various instrumental techniques (cyclic voltammetric: CV, FTIR, UV-Visible: UV-Vis, EPR, XRD, TGA and DTG methods) revealed that between the two acid media, H₂SO₄ was the better one. Further, it enlightened the role of two organic dopants in relation to the acid media. The advantageous role of NSA in H₂SO₄ had origin on its molecular characteristics such as non-polarity, larger π-electron cloud etc., while CSA could not perform such a role because of its easily oxidisable hydroxyl groups. In HClO₄, however, both the dopants could play only an unfavourable role owing to its greater polarity and oxidizing power than H₂SO₄.     

Corrosion of tin in citric acid solution and the effect of some inorganic anions

The corrosion behaviour of tin in different concentrations of citric acid solutions (0.3–1.0 M, pH=1.8) was studied at 30 °C by potentiodynamic technique. The E/I profiles exhibit an active passive behaviour. The active dissolution involves one anodic peak A associated with a dissolution of the metals as Sn(II) species. The passivity is due to the formation of thin film of SnO₂ and or Sn(OH)₄ on the anode surface. The cathodic sweep shows a small peak C related to the reduction of the passive film. The peak current density I_p of peak A increases with increasing both acid concentration and sweep rate.

The effects of adding increasing concentrations of Na₂CrO₄, NaMoO₄, NaNO₃ and NaNO₂ on the corrosion of tin in 0.5 M citric acid at 30 °C were investigated. Both CrO₄²⁻ and MoO₄²⁻ ions inhibit the corrosion of tin and the extent of inhibition enhances with their concentrations. Addition of either NO₃⁻ or NO₂⁻ accelerates the corrosion of tin. NO₃⁻ ions are more aggressive than NO₂⁻ ions.     

Anhydrous esterification of myristic acid with propylene: Ion exchange resin and acid-treated clay as catalysts

Anhydrous esterification of myristic acid with propylene was carried out in the temperature range of 110–145°C and pressure from 190–195 psig in the presence of Amberlyst-15 (cation exchange resin) and Filtrol-24 (acid-treated clay) as catalysts. The product ester, isopropyl myristate finds use in cosmetic and topical medicinal preparations where good absorption through the skin is desired. Filtrol-24 is the catalyst of choice, and the recommended operating temperature is 130°C with a pressure of 190 psig.     

以杂多酸为催化剂合成乙二醇-乙醚的研究

研究了杂多酸催化无水乙醇和环氧乙烷(EO)制备乙醇乙醚的醚化反应,考察了不同种类的杂多酸以及醚化反应工艺条件对反应活性和选择性的影响.结果表明,PW_(12)催化剂的反应活性高、反应温度低、选择性好,当用PW_(12)作催化剂,乙醇与环氧化乙烷之比为3.0(mol),反应温度45℃,反应时间1h时,转化率和选择性均超过97%.     

Cu－MnO_2同槽电解半工业试验研究

提出了Ｃｕ－ＭｎＯ＿２同槽电解的新工艺，在同一电解槽同时得到电铜和电解二氧化锰两种产品，该新工艺具有低电耗、低酸雾污染和低酸耗等优点．     

用φ20mm离心萃取器两步法制取高纯钇

本文研究了中钇富镧稀土的氧化物溶液在环烷酸中的萃取行为，测定了镧钇组成、温度变化与分离系数的关系；在Ｐ＿（５０７）体系中研究了ｐＨ值与分配比的关系；提出用环烷酸、Ｐ＿（５０７）两种萃取剂制备高纯钇的工艺流程。用８４台φ２０ｍｍ离心萃取器进行了一个月的台架试验，结果证明两种萃取剂有很好的互补性，在满足钇的纯度要求下有较高收率。离心萃取器具有易分相、体系存留量少、液流密闭性好等优点，它更适宜于粘度大、级数多、产品纯度要求高的体系。     

Copper phthalocyanine as corrosion inhibitor for ASTM A606-4 steel in 16% hydrochloric acid

A study based on the corrosion inhibition properties of copper phthalocyanine is described. Coverage degrees of copper phthalocyanine (Cu-phcy) on ASTM-A606-4 steel, obtained by weight loss measurements, were fitted to Langmuir, Frumkin, Temkin and Flory–Huggins adsorption isotherms. A better fit to the Langmuir isotherm was obtained. The polarization curves showed that polarization of both the anodic and cathodic reactions were verified for concentrations higher than 10^–4 M, indicating a mixed type action. Only the anodic reactions were polarized for lower concentrations. At high frequencies the Nyquist diagrams showed one capacitive loop attributable to double layer charging and a small one at intermediary frequencies attributable to the faradaic process of hydrogen evolution. The formation of an adsorbed film was characterized by increasing charge transfer resistance values in the low frequency range for increasing inhibitor concentrations. According to the techniques used in this study, copper phthalocyanines showed a high corrosion inhibiting efficiency for all concentrations.     

Temperature and pressure effects on supercritical CO2 extraction of tomato seed oil

Tomato seed oil was extracted with supercritical carbon dioxide in a semibatch-flow extractor within the temperature range 313–343 K and the pressure range 10.8–24.5MPa. The extraction rates increased with pressure, but decreased with temperature increase because of the variation in solvent density and resultant differences in oil solubility. The fatty acid composition of the extracted oil was similar to that of soybean oil.